| /openbmc/qemu/hw/dma/ |
| H A D | xlnx-zynq-devcfg.c | 93 REG32(INT_STS, 0x0C)
94 FIELD(INT_STS, PSS_GTS_USR_B, 31, 1)
95 FIELD(INT_STS, PSS_FST_CFG_B, 30, 1)
96 FIELD(INT_STS, PSS_CFG_RESET_B, 27, 1)
97 FIELD(INT_STS, RX_FIFO_OV, 18, 1)
98 FIELD(INT_STS, WR_FIFO_LVL, 17, 1)
99 FIELD(INT_STS, RD_FIFO_LVL, 16, 1)
100 FIELD(INT_STS, DMA_CMD_ERR, 15, 1)
101 FIELD(INT_STS, DMA_Q_OV, 14, 1)
102 FIELD(INT_STS, DMA_DONE, 13, 1)
[all …]
|
| /openbmc/qemu/hw/adc/ |
| H A D | zynq-xadc.c | 26 INT_STS, enumerator
82 s->regs[INT_STS] |= INT_CFIFO_LTH; in zynq_xadc_update_ints()
86 s->regs[INT_STS] |= INT_DFIFO_GTH; in zynq_xadc_update_ints()
89 qemu_set_irq(s->irq, !!(s->regs[INT_STS] & ~s->regs[INT_MASK])); in zynq_xadc_update_ints()
98 s->regs[INT_STS] = INT_CFIFO_LTH; in zynq_xadc_reset()
141 case INT_STS: in zynq_xadc_check_offset()
169 case INT_STS: in zynq_xadc_read()
208 case INT_STS: in zynq_xadc_write()
209 s->regs[INT_STS] &= ~val; in zynq_xadc_write()
|
| /openbmc/linux/drivers/mtd/nand/raw/ |
| H A D | mxic_nand.c | 42 #define INT_STS 0x4 macro
288 sts = readl(nfc->regs + INT_STS); in mxic_nfc_isr()
356 ret = readl_poll_timeout(nfc->regs + INT_STS, sts, in mxic_nfc_data_xfer()
363 ret = readl_poll_timeout(nfc->regs + INT_STS, sts, in mxic_nfc_data_xfer()
368 ret = readl_poll_timeout(nfc->regs + INT_STS, sts, in mxic_nfc_data_xfer()
379 if (readl(nfc->regs + INT_STS) & INT_RX_NOT_EMPTY) in mxic_nfc_data_xfer()
|
| /openbmc/linux/drivers/spi/ |
| H A D | spi-mxic.c | 43 #define INT_STS 0x4 macro
359 ret = readl_poll_timeout(mxic->regs + INT_STS, sts, in mxic_spi_data_xfer()
366 ret = readl_poll_timeout(mxic->regs + INT_STS, sts, in mxic_spi_data_xfer()
371 ret = readl_poll_timeout(mxic->regs + INT_STS, sts, in mxic_spi_data_xfer()
382 WARN_ON(readl(mxic->regs + INT_STS) & INT_RX_NOT_EMPTY); in mxic_spi_data_xfer()
422 writel(INT_LRD_DIS, mxic->regs + INT_STS); in mxic_spi_mem_dirmap_read()
425 ret = readl_poll_timeout(mxic->regs + INT_STS, sts, in mxic_spi_mem_dirmap_read()
466 writel(INT_LWR_DIS, mxic->regs + INT_STS); in mxic_spi_mem_dirmap_write()
469 ret = readl_poll_timeout(mxic->regs + INT_STS, sts, in mxic_spi_mem_dirmap_write()
|
| /openbmc/u-boot/drivers/usb/eth/ |
| H A D | lan7x.h | 29 #define INT_STS 0x0C macro
|
| H A D | lan75xx.c | 176 ret = lan7x_write_reg(udev, INT_STS, 0xFFFFFFFF); in lan75xx_eth_start()
|
| H A D | smsc95xx.c | 38 #define INT_STS 0x08 macro
591 ret = smsc95xx_write_reg(udev, INT_STS, write_buf); in smsc95xx_init_common()
|
| H A D | lan78xx.c | 356 ret = lan7x_write_reg(udev, INT_STS, 0xFFFFFFFF); in lan78xx_eth_start()
|
| /openbmc/linux/drivers/net/usb/ |
| H A D | smsc95xx.h | 51 #define INT_STS (0x08) macro
|
| H A D | smsc75xx.h | 60 #define INT_STS (0x000C) macro
|
| H A D | lan78xx.h | 105 #define INT_STS (0x0C) macro
|
| H A D | smsc75xx.c | 639 ret = smsc75xx_write_reg(dev, INT_STS, INT_STS_CLEAR_ALL); in smsc75xx_link_reset()
1248 ret = smsc75xx_write_reg(dev, INT_STS, INT_STS_CLEAR_ALL); in smsc75xx_reset()
|
| H A D | lan78xx.c | 328 INT_STS,
1425 ret = lan78xx_write_reg(dev, INT_STS, INT_STS_PHY_INT_); in lan78xx_link_reset()
2978 ret = lan78xx_write_reg(dev, INT_STS, INT_STS_CLEAR_ALL_); in lan78xx_reset()
|
| H A D | smsc95xx.c | 997 ret = smsc95xx_write_reg(dev, INT_STS, INT_STS_CLEAR_ALL_); in smsc95xx_reset()
|
| /openbmc/linux/drivers/net/ethernet/smsc/ |
| H A D | smsc911x.h | 112 #define INT_STS 0x58 macro
|
| H A D | smsc911x.c | 1230 smsc911x_reg_write(pdata, INT_STS, INT_STS_RSFL_); in smsc911x_poll()
1527 smsc911x_reg_write(pdata, INT_STS, 0xFFFFFFFF); in smsc911x_disable_irq_chip()
1534 u32 intsts = smsc911x_reg_read(pdata, INT_STS); in smsc911x_irqhandler()
1543 smsc911x_reg_write(pdata, INT_STS, INT_STS_SW_INT_); in smsc911x_irqhandler()
1553 smsc911x_reg_write(pdata, INT_STS, INT_STS_RXSTOP_INT_); in smsc911x_irqhandler()
1563 smsc911x_reg_write(pdata, INT_STS, INT_STS_TDFA_); in smsc911x_irqhandler()
1570 smsc911x_reg_write(pdata, INT_STS, INT_STS_RXE_); in smsc911x_irqhandler()
|
| /openbmc/linux/drivers/usb/typec/ |
| H A D | anx7411.c | 140 #define INT_STS 0xB7 macro
918 ret = anx7411_reg_block_read(ctx->spi_client, INT_STS, STATUS_LEN, buf); in anx7411_work_func()
935 ret = anx7411_reg_write(ctx->spi_client, INT_STS, 0); in anx7411_work_func()
1294 ret = anx7411_reg_write(ctx->spi_client, INT_STS, 0); in anx7411_typec_check_connection()
|
| /openbmc/u-boot/drivers/net/ |
| H A D | smc911x.h | 114 #define INT_STS 0x58 macro
|
| /openbmc/linux/drivers/net/ethernet/microchip/ |
| H A D | lan743x_main.h | 402 #define INT_STS (0x780) macro
|
| H A D | lan743x_ethtool.c | 1240 rb[ETH_INT_STS] = lan743x_csr_read(adapter, INT_STS); in lan743x_common_regs()
|
| H A D | lan743x_main.c | 352 int_sts = lan743x_csr_read(adapter, INT_STS); in lan743x_intr_entry_isr()
2215 lan743x_csr_read(adapter, INT_STS); in lan743x_tx_napi_poll()
|
| /openbmc/linux/drivers/gpu/drm/bridge/ |
| H A D | ite-it6505.c | 77 #define INT_STS BIT(0) macro
|