| /openbmc/linux/Documentation/devicetree/bindings/mfd/ |
| H A D | samsung,s5m8767.yaml | 55 s5m8767,pmic-buck4-dvs-voltage:
60 A set of 8 voltage values in micro-volt (uV) units for buck4 when
78 s5m8767,pmic-buck4-uses-gpio-dvs:
80 description: buck4 can be controlled by gpio dvs.
106 description: Power supply for buck4
148 s5m8767,pmic-buck4-dvs-voltage: [ 's5m8767,pmic-buck-dvs-gpios' ]
151 …s5m8767,pmic-buck4-uses-gpio-dvs: [ 's5m8767,pmic-buck-dvs-gpios', 's5m8767,pmic-buck4-dvs-voltage…
163 - s5m8767,pmic-buck4-uses-gpio-dvs
167 - s5m8767,pmic-buck4-uses-gpio-dvs
209 s5m8767,pmic-buck4-dvs-voltage = <1200000>, <1200000>,
|
| H A D | richtek,rt5120.yaml | 59 description: phandle for buck4 input power source
154 buck4 {
155 regulator-name = "rt5120-buck4";
|
| H A D | da9052-i2c.txt | 22 buck4 : regulator BUCK PERI
61 buck4 {
|
| H A D | ti,tps6594.yaml | 128 buck4-supply = <&vcc_3v3_sys>;
144 buck4: buck4 {
|
| H A D | rohm,bd71828-pmic.yaml | 130 buck4: BUCK4 {
131 regulator-name = "buck4";
|
| H A D | rohm,bd71815-pmic.yaml | 143 buck4: buck4 {
144 regulator-name = "buck4";
|
| H A D | rohm,bd71847-pmic.yaml | 176 buck4: BUCK4 {
177 regulator-name = "buck4";
|
| H A D | rohm,bd71837-pmic.yaml | 174 buck4: BUCK4 {
175 regulator-name = "buck4";
|
| H A D | st,stpmic1.yaml | 91 - buck4 for Buck BUCK4
323 buck4 {
|
| /openbmc/linux/drivers/regulator/ |
| H A D | tps65086-regulator.c | 17 enum tps65086_regulators { BUCK1, BUCK2, BUCK3, BUCK4, BUCK5, BUCK6, LDOA1, enumerator
150 TPS65086_REGULATOR("BUCK4", "buck4", BUCK4, 0x80, TPS65086_BUCK4VID,
190 TPS65086_REGULATOR("BUCK4", "buck4", BUCK4, 0x80, TPS65086_BUCK4VID,
229 TPS65086_REGULATOR("BUCK4", "buck4", BUCK4, 0x80, TPS65086_BUCK4VID,
268 TPS65086_REGULATOR("BUCK4", "buck4", BUCK4, 0x80, TPS65086_BUCK4VID,
322 case BUCK4: in tps65086_of_parse_cb()
|
| H A D | tps6594-regulator.c | 184 TPS6594_REGULATOR("BUCK4", "buck4", TPS6594_BUCK_4,
225 { TPS6594_IRQ_NAME_BUCK4_OV, "BUCK4", "overvoltage", REGULATOR_EVENT_OVER_VOLTAGE_WARN },
226 { TPS6594_IRQ_NAME_BUCK4_UV, "BUCK4", "undervoltage", REGULATOR_EVENT_UNDER_VOLTAGE },
227 { TPS6594_IRQ_NAME_BUCK4_SC, "BUCK4", "short circuit", REGULATOR_EVENT_REGULATION_OUT },
228 { TPS6594_IRQ_NAME_BUCK4_ILIM, "BUCK4", "reach ilim, overcurrent",
|
| H A D | mp5416.c | 131 * DVS ramp rate BUCK1 to BUCK4
170 MP5416BUCK("buck4", 4, mp5416_I_limits2, MP5416_REG_CTL2, BIT(5), 2),
181 MP5416BUCK("buck4", 4, mp5416_I_limits2, MP5416_REG_CTL2, BIT(5), 1),
|
| /openbmc/linux/Documentation/devicetree/bindings/regulator/ |
| H A D | richtek,rt5190a-regulator.yaml | 38 description: phandle to buck4 input voltage.
61 regulator description for buck1 to buck4, and ldo.
126 buck4 {
127 regulator-name = "rt5190a-buck4";
|
| H A D | nxp,pca9450-regulator.yaml | 21 # BUCK1, BUCK2, BUCK3, BUCK4, BUCK5, BUCK6,
136 buck4: BUCK4 {
137 regulator-name = "BUCK4";
|
| /openbmc/linux/arch/arm64/boot/dts/freescale/ |
| H A D | imx8mp-icore-mx8mp.dtsi | 63 buck4: BUCK4 { label
68 regulator-name = "BUCK4";
|
| H A D | imx8mm-emtop-som.dtsi | 92 buck4: BUCK4 { label
93 regulator-name = "BUCK4";
|
| H A D | imx8mp-debix-som-a.dtsi | 76 buck4: BUCK4 { label
77 regulator-name = "BUCK4";
|
| H A D | imx8mn-ddr3l-evk.dts | 49 buck4: BUCK4 { label
|
| H A D | imx8mn-evk.dts | 62 buck4: BUCK4 { label
|
| H A D | imx8mm-evkb.dts | 58 buck4_reg: BUCK4 {
59 regulator-name = "BUCK4";
|
| H A D | imx8mp-phycore-som.dtsi | 119 buck4: BUCK4 { label
124 regulator-name = "VDD_3V3 (BUCK4)";
|
| H A D | imx8mn-ddr4-evk.dts | 92 buck4_reg: BUCK4 {
94 regulator-name = "buck4";
|
| H A D | imx8mp-dhcom-som.dtsi | 36 vin-supply = <&buck4>;
50 vin-supply = <&buck4>;
303 buck4: BUCK4 { /* VDD_3V3 */ label
395 vio-supply = <&buck4>;
544 vmmc-supply = <&buck4>;
584 vmmc-supply = <&buck4>;
|
| H A D | imx8mq-pico-pi.dts | 107 buck4: BUCK4 { label
108 regulator-name = "buck4";
|
| H A D | imx8mp-beacon-som.dtsi | 120 buck4: BUCK4 { label
121 regulator-name = "BUCK4";
|