| /openbmc/linux/drivers/gpu/drm/nouveau/dispnv50/ |
| H A D | dac507d.c | 38 sync |= NVVAL(NV507D, DAC_SET_POLARITY, VSYNC, asyh->or.nvsync); in dac507d_ctrl()
|
| /openbmc/linux/Documentation/devicetree/bindings/media/i2c/ |
| H A D | tvp514x.txt | 19 - vsync-active: VSYNC Polarity configuration for endpoint.
|
| H A D | tvp7002.txt | 13 - vsync-active: VSYNC Polarity configuration for the bus. Default value when
|
| H A D | ov7670.txt | 14 - vsync-active: active state of the VSYNC signal, 0/1 for LOW/HIGH respectively.
|
| H A D | tvp5150.txt | 45 - vsync-active: Active state of the VSYNC signal. Must be <1> (HIGH).
|
| /openbmc/linux/Documentation/fb/ |
| H A D | pxafb.rst | 45 vsynclen:VSYNC == LCCR2_VSW + 1
65 hsync:HSYNC, vsync:VSYNC
|
| H A D | matroxfb.rst | 265 upper:X top boundary: lines between end of VSYNC pulse and start of first
267 lower:X bottom boundary: lines between end of picture and start of VSYNC
269 vslen:X length of VSYNC pulse, in lines. Default is derived from `vesa`
279 sync:X sync. pulse - bit 0 inverts HSYNC polarity, bit 1 VSYNC polarity.
|
| /openbmc/linux/drivers/video/fbdev/i810/ |
| H A D | i810_regs.h | 153 #define VSYNC 0x60014 macro
|
| /openbmc/linux/include/video/ |
| H A D | sstfb.h | 162 #define VSYNC 0x0224 macro
|
| /openbmc/linux/Documentation/devicetree/bindings/display/exynos/ |
| H A D | exynos_dp.txt | 38 VSYNC polarity configuration.
|
| /openbmc/linux/arch/arm/boot/dts/ti/omap/ |
| H A D | am437x-sbc-t43.dts | 59 AM4372_IOPAD(0x8e0, PIN_OUTPUT_PULLUP | MUX_MODE0) /* DSS VSYNC */
|
| H A D | am437x-sk-evm.dts | 371 AM4372_IOPAD(0x8e0, PIN_OUTPUT | MUX_MODE0) /* DSS VSYNC */
|
| /openbmc/linux/drivers/gpu/drm/bridge/ |
| H A D | chipone-icn6211.c | 53 #define VSYNC 0x28 macro
404 chipone_writeb(icn, VSYNC, mode->vsync_end - mode->vsync_start); in chipone_atomic_enable()
|
| /openbmc/linux/Documentation/userspace-api/media/drivers/ |
| H A D | imx-uapi.rst | 94 Input capture requires hardware support. A VSYNC signal must be routed
|
| /openbmc/linux/arch/arm/boot/dts/nxp/imx/ |
| H A D | imx53-qsb-common.dtsi | 312 /* VGA_HSYNC, VSYNC with max drive strength */
|
| H A D | imx6ul-tx6ul-mainboard.dts | 206 MX6UL_PAD_LCD_VSYNC__LCDIF_VSYNC 0x10 /* VSYNC */
|
| H A D | imx6ul-tx6ul.dtsi | 600 MX6UL_PAD_LCD_VSYNC__LCDIF_VSYNC 0x10 /* VSYNC */
633 MX6UL_PAD_LCD_VSYNC__LCDIF_VSYNC 0x10 /* VSYNC */
|
| H A D | imx6qdl-kontron-samx6i.dtsi | 598 MX6QDL_PAD_DI0_PIN3__IPU1_DI0_PIN03 0x100f1 /* VSYNC */
|
| /openbmc/linux/drivers/video/fbdev/omap2/omapfb/dss/ |
| H A D | dispc-compat.c | 81 PIS(VSYNC); in dispc_dump_irqs()
|
| /openbmc/linux/drivers/gpu/drm/i2c/ |
| H A D | ch7006_mode.c | 123 DRM_MODE_FLAG_##vsynp##VSYNC, \
|
| /openbmc/u-boot/arch/arm/dts/ |
| H A D | am437x-sk-evm.dts | 344 0x0e0 (PIN_OUTPUT | MUX_MODE0) /* DSS VSYNC */
|
| H A D | am43x-epos-evm.dts | 309 AM4372_IOPAD(0x8e0, PIN_OUTPUT_PULLUP | MUX_MODE0) /* DSS VSYNC */
|
| H A D | am437x-gp-evm.dts | 270 0x0e0 (PIN_OUTPUT_PULLUP | MUX_MODE0) /* DSS VSYNC */
|
| /openbmc/linux/drivers/pinctrl/renesas/ |
| H A D | pfc-sh7786.c | 506 GPIO_FN(VSYNC),
|
| /openbmc/linux/arch/arm/boot/dts/microchip/ |
| H A D | at91sam9g45.dtsi | 282 AT91_PIOB 29 AT91_PERIPH_A AT91_PINCTRL_NONE /* VSYNC */
|