/openbmc/u-boot/doc/ |
H A D | README.pblimage | 37 =>tftp 100000 u-boot.pbl 39 =>sf erase 0 100000 40 =>sf write 100000 0 $filesize 46 =>tftp 100000 u-boot.pbl 48 =>mmc write 100000 8 441 54 =>tftp 100000 u-boot.pbl 56 =>nand erase 0 100000 57 =>nand write 100000 0 $filesize 88 091380c0 00000100 108 091380c0 00000000
|
/openbmc/u-boot/arch/arm/cpu/armv7/ls102xa/ |
H A D | timer.c | 26 ticks = ((usec / 10) * (get_tbclk() / 100000)); in usec2ticks() 35 asm volatile("mrc p15, 0, %0, c14, c0, 0" : "=r" (freq)); in tick_to_time() 47 asm volatile("mrc p15, 0, %0, c14, c0, 0" : "=r" (freq)); in us_to_tick() 65 asm("mcr p15, 0, %0, c14, c0, 0" : : "r" (freq)); in timer_init() 119 asm volatile("mrc p15, 0, %0, c14, c0, 0" : "=r" (freq)); in get_tbclk()
|
/openbmc/u-boot/arch/arm/mach-imx/ |
H A D | syscounter.c | 29 ticks = ((usec / 10) * (get_tbclk() / 100000)); in usec2ticks() 38 asm volatile("mrc p15, 0, %0, c14, c0, 0" : "=r" (freq)); in tick_to_time() 50 asm volatile("mrc p15, 0, %0, c14, c0, 0" : "=r" (freq)); in us_to_tick() 65 asm volatile("mcr p15, 0, %0, c14, c0, 0" : : "r" (freq)); in timer_init() 119 asm volatile("mrc p15, 0, %0, c14, c0, 0" : "=r" (freq)); in get_tbclk()
|
/openbmc/linux/arch/x86/kernel/cpu/ |
H A D | umwait.c | 17 * umwait max time is 100000 in TSC-quanta and C0.2 is enabled 19 static u32 umwait_control_cached = UMWAIT_CTRL_VAL(100000, UMWAIT_C02_ENABLE); 101 * When bit 0 in IA32_UMWAIT_CONTROL MSR is 1, C0.2 is disabled. 102 * Otherwise, C0.2 is enabled.
|
/openbmc/u-boot/arch/arm/dts/ |
H A D | ast2400.dtsi | 339 ibt: ibt@c0 { 408 bus-frequency = <100000>; 423 bus-frequency = <100000>; 431 i2c2: i2c-bus@c0 { 438 bus-frequency = <100000>; 454 bus-frequency = <100000>; 470 bus-frequency = <100000>; 486 bus-frequency = <100000>; 495 i2c6: i2c-bus@1c0 { 502 bus-frequency = <100000>; [all …]
|
H A D | ast2500.dtsi | 379 ibt: ibt@c0 { 448 bus-frequency = <100000>; 463 bus-frequency = <100000>; 471 i2c2: i2c-bus@c0 { 478 bus-frequency = <100000>; 494 bus-frequency = <100000>; 510 bus-frequency = <100000>; 526 bus-frequency = <100000>; 535 i2c6: i2c-bus@1c0 { 542 bus-frequency = <100000>; [all …]
|
H A D | ast2600.dtsi | 594 ibt: ibt@c0 { 800 bus-frequency = <100000>; 815 bus-frequency = <100000>; 830 bus-frequency = <100000>; 844 bus-frequency = <100000>; 858 bus-frequency = <100000>; 872 bus-frequency = <100000>; 886 bus-frequency = <100000>; 900 bus-frequency = <100000>; 914 bus-frequency = <100000>; [all …]
|
/openbmc/u-boot/include/configs/ |
H A D | devkit3250.h | 54 #define CONFIG_SYS_I2C_SPEED 100000 64 #define CONFIG_LPC32XX_SSP_TIMEOUT 100000 137 "ethaddr=00:01:90:00:C0:81\0" \
|
/openbmc/linux/drivers/usb/serial/ |
H A D | ipw.c | 58 #define CHAR2INT16(c1, c0) (((u32)((c1) & 0xff) << 8) + (u32)((c0) & 0xff)) argument 155 100000); in ipw_open() 176 100000); in ipw_open() 278 100000); in ipw_close()
|
/openbmc/linux/arch/arm/boot/dts/aspeed/ |
H A D | aspeed-g4.dtsi | 490 bus-frequency = <100000>; 505 bus-frequency = <100000>; 512 i2c2: i2c@c0 { 520 bus-frequency = <100000>; 536 bus-frequency = <100000>; 552 bus-frequency = <100000>; 568 bus-frequency = <100000>; 576 i2c6: i2c@1c0 { 584 bus-frequency = <100000>; 600 bus-frequency = <100000>; [all …]
|
H A D | aspeed-g5.dtsi | 619 bus-frequency = <100000>; 634 bus-frequency = <100000>; 641 i2c2: i2c@c0 { 649 bus-frequency = <100000>; 665 bus-frequency = <100000>; 681 bus-frequency = <100000>; 697 bus-frequency = <100000>; 705 i2c6: i2c@1c0 { 713 bus-frequency = <100000>; 729 bus-frequency = <100000>; [all …]
|
H A D | aspeed-bmc-ibm-sbp1.dts | 924 * Scale the system voltage by 231000/100000 to fit the ADC range. 1693 /* C0 - C7 */ 3646 regulator-enable-ramp-delay = <100000>; 3653 regulator-enable-ramp-delay = <100000>; 4736 shunt-resistor-micro-ohms = <100000>; 4779 shunt-resistor-micro-ohms = <100000>; 4822 shunt-resistor-micro-ohms = <100000>; 4865 shunt-resistor-micro-ohms = <100000>; 4908 shunt-resistor-micro-ohms = <100000>; 4951 shunt-resistor-micro-ohms = <100000>; [all …]
|
/openbmc/linux/Documentation/devicetree/bindings/mfd/ |
H A D | brcm,bcm63268-gpio-sysctl.yaml | 64 syscon@100000c0 {
|
/openbmc/u-boot/arch/mips/dts/ |
H A D | brcm,bcm63268.dtsi | 109 gpio1: gpio-controller@100000c0 { 119 gpio0: gpio-controller@100000c4 {
|
/openbmc/linux/arch/mips/boot/dts/mscc/ |
H A D | ocelot.dtsi | 68 uart0: serial@100000 { 258 mdio1: mdio@10700c0 {
|
/openbmc/linux/arch/powerpc/boot/dts/ |
H A D | mpc836x_rdk.dts | 194 qe@100000 { 230 usb@6c0 { 246 spi@4c0 {
|
H A D | mpc8315erdb.dts | 84 kernel@100000 { 338 ipic-msi@7c0 {
|
/openbmc/linux/arch/arm64/boot/dts/sprd/ |
H A D | whale2.dtsi | 84 uart1: serial@100000 { 231 eic_sync: gpio@402100c0 {
|
/openbmc/linux/arch/arm/boot/dts/broadcom/ |
H A D | bcm7445.dtsi | 212 upg_gio_aon: gpio@4172c0 { 277 memc@100000 {
|
/openbmc/linux/arch/s390/crypto/ |
H A D | prng.c | 57 #define PRNG_RESEED_LIMIT_SHA512 100000 283 static const u8 C0[] __initconst = { in prng_sha512_selftest() local 343 || memcmp(ws.C, C0, sizeof(C0)) != 0) { in prng_sha512_selftest()
|
/openbmc/linux/drivers/gpu/drm/i915/gt/ |
H A D | intel_rps.c | 567 intel_uncore_write(uncore, RCUPEI, 100000); in gen5_rps_enable() 568 intel_uncore_write(uncore, RCDNEI, 100000); in gen5_rps_enable() 1494 /* Correction factor in 1/100000 units */ in __ips_gfx_val() 1504 corr2 = div_u64(corr, 100000) * ips->corr; in __ips_gfx_val() 1776 u64 time, c0; in vlv_wa_c0_ei() local 1790 c0 = max(render, media); in vlv_wa_c0_ei() 1791 c0 *= 1000 * 100 << 8; /* to usecs and scale to threshold% */ in vlv_wa_c0_ei() 1793 if (c0 > time * rps->power.up_threshold) in vlv_wa_c0_ei() 1795 else if (c0 < time * rps->power.down_threshold) in vlv_wa_c0_ei()
|
/openbmc/linux/arch/arm64/boot/dts/rockchip/ |
H A D | rk3326-odroid-go.dtsi | 441 rockchip,sleep-filter-current-microamp = <100000>; 539 /* EXT Header(P2): 2(RXD:GPIO1.C0),3(TXD:.C1),4(CTS:.C2),5(RTS:.C3) */
|
/openbmc/u-boot/drivers/usb/host/ |
H A D | ehci-tegra.c | 93 * DIVN 960 (0x3c0) 200 (0c8) 960 (3c0h) 960 (3c0) 542 for (loop_count = 100000; loop_count != 0; loop_count--) { in init_utmi_usb_controller() 660 for (loop_count = 100000; loop_count != 0; loop_count--) { in init_ulpi_usb_controller()
|
/openbmc/linux/arch/arm/mach-sunxi/ |
H A D | mc_smp.c | 35 #define TIMEOUT_USEC 100000 353 "mcr p15, 1, %0, c15, c0, 3\n" in sunxi_cluster_cache_disable_without_axi()
|
/openbmc/qemu/target/hppa/ |
H A D | insns.decode | 169 ixtlbt 000001 r2:5 r1:5 000 data:1 100000 0 00000 # idtlbt 262 permh 111110 r1:5 r2:5 0 c0:2 0 c1:2 c2:2 c3:2 0 t:5 385 cmpb 100000 ..... ..... ... ........... . . @rrb_cdf d=0 f=0
|