Searched refs:speed (Results 2451 – 2475 of 3127) sorted by relevance
1...<<919293949596979899100>>...126
762 maximum-speed = "super-speed";1012 max-link-speed = <2>;1040 max-link-speed = <2>;
948 current-speed = <115200>;956 current-speed = <115200>;964 current-speed = <115200>;972 current-speed = <115200>;
806 cpu_speed_grade: speed-grade@10 { /* 0x440 */1747 fsl,max-link-speed = <2>;1790 fsl,max-link-speed = <2>;1821 fsl,max-link-speed = <2>;
1861 u16 speed; member1892 (unsigned long)&memdev_dmi_entry->speed - in decode_dclk()1907 dmi_mem_clk_speed = memdev_dmi_entry->speed; in decode_dclk()
1541 cmd->base.speed = SPEED_10; in smc_ethtool_get_link_ksettings()1543 cmd->base.speed = SPEED_100; in smc_ethtool_get_link_ksettings()1570 cmd->base.speed != SPEED_10 || in smc_ethtool_set_link_ksettings()
1100 if (phy_interface_is_rgmii(phydev) && phydev->speed == SPEED_1000) in ave_phy_adjust_link()1102 else if (phydev->speed == SPEED_100) in ave_phy_adjust_link()1110 if (phydev->speed == SPEED_10) in ave_phy_adjust_link()
115 This will speed up residue calculation, for large transfers such as video
215 current-speed = <0>; /* Filled in by U-Boot */
286 max-speed = <100>;
282 max-speed = <100>;
832 struct mmc *mmc_spi_init(uint bus, uint cs, uint speed, uint mode);
339 * We run eMMC at max speed; bump up drive strength.
181 max-speed = <100>;
73 max-speed = <100>;
42 Two high speed USB 3.0 ports. First USB 3.0 port configured as
13 behave the same except for transfer speed dependent behaviors and the
171 Data path microcode controlling high-speed packet processing.
81 macros. This is the preferred method due to speed but it
52 c) You need a second client/console system with a high speed USB 2.0 port.
81 should contain default/high speed pin ctrl.
341 * We run eMMC at max speed; bump up drive strength.
203 with 1G and 100M link speed.
224 current-speed = <115200>;
418 max-speed = <3000000>;
288 max-speed = <2000000>;