Home
last modified time | relevance | path

Searched refs:SPEED_2500 (Results 1 – 25 of 79) sorted by relevance

1234

/openbmc/linux/drivers/phy/microchip/
H A Dlan966x_serdes.c318 ret_val->mpll_multiplier = macro->speed == SPEED_2500 ? 50 : 40; in lan966x_sd6g40_get_conf_from_mode()
320 ret_val->tx_rate = macro->speed == SPEED_2500 ? 0x1 : 0x2; in lan966x_sd6g40_get_conf_from_mode()
321 ret_val->rx_rate = macro->speed == SPEED_2500 ? 0x1 : 0x2; in lan966x_sd6g40_get_conf_from_mode()
323 ret_val->mpll_multiplier = macro->speed == SPEED_2500 ? 125 : 100; in lan966x_sd6g40_get_conf_from_mode()
325 ret_val->tx_rate = macro->speed == SPEED_2500 ? 0x1 : 0x2; in lan966x_sd6g40_get_conf_from_mode()
326 ret_val->rx_rate = macro->speed == SPEED_2500 ? 0x1 : 0x2; in lan966x_sd6g40_get_conf_from_mode()
468 macro->speed = SPEED_2500; in serdes_set_mode()
/openbmc/linux/drivers/net/ethernet/microchip/sparx5/
H A Dsparx5_port.c100 status->speed = SPEED_2500; in sparx5_get_dev2g5_status()
217 conf->speed > SPEED_2500) || in sparx5_port_verify_speed()
235 if (conf->speed != SPEED_2500 || in sparx5_port_verify_speed()
247 conf->speed != SPEED_2500) in sparx5_port_verify_speed()
489 case SPEED_2500: in sparx5_port_fifo_sz()
611 case SPEED_2500: in sparx5_port_fwd_urg()
876 gig_mode = spd == SPEED_1000 || spd == SPEED_2500; in sparx5_port_config_low_set()
/openbmc/linux/drivers/net/phy/
H A Dmxl-gpy.c350 phydev->speed = SPEED_2500; in gpy_2500basex_chk()
524 case SPEED_2500: in gpy_update_interface()
556 if (phydev->speed == SPEED_2500 || phydev->speed == SPEED_1000) { in gpy_update_interface()
609 phydev->speed = SPEED_2500; in gpy_read_status()
H A Dbcm84881.c216 phydev->speed = SPEED_2500; in bcm84881_read_status()
H A Daquantia_main.c391 phydev->speed = SPEED_2500; in aqr107_read_rate()
606 phy_set_max_speed(phydev, SPEED_2500); in aqcs109_config_init()
H A Dphy-c45.c148 case SPEED_2500: in genphy_c45_pma_setup_forced()
619 phydev->speed = SPEED_2500; in genphy_c45_read_pma()
H A Dphylink.c221 return SPEED_2500; in phylink_interface_max_speed()
420 { MAC_2500FD, SPEED_2500, DUPLEX_FULL },
3360 { ETHTOOL_LINK_MODE_2500baseX_Full_BIT, SPEED_2500 },
3392 if (speed == SPEED_2500) in phylink_decode_c37_word()
3462 state->speed = SPEED_2500; in phylink_decode_usxgmii_word()
3549 phylink_decode_c37_word(state, lpa, SPEED_2500); in phylink_mii_c22_pcs_decode_state()
H A Dmarvell10g.c957 case SPEED_2500: in mv3310_update_interface()
1018 phydev->speed = SPEED_2500; in mv3310_read_status_copper()
/openbmc/linux/drivers/net/dsa/mv88e6xxx/
H A Dserdes.c73 state->speed = SPEED_2500; in mv88e6xxx_pcs_decode_state()
96 state->speed = SPEED_2500; in mv88e6xxx_pcs_decode_state()
/openbmc/linux/drivers/infiniband/ulp/ipoib/
H A Dipoib_ethtool.c163 return SPEED_2500; in ib_speed_enum_to_int()
/openbmc/linux/drivers/net/ethernet/amd/xgbe/
H A Dxgbe-mdio.c231 pdata->hw_if.set_speed(pdata, SPEED_2500); in xgbe_kx_2500_mode()
1098 case SPEED_2500: in xgbe_phy_speed_string()
1369 pdata->phy.speed = SPEED_2500; in xgbe_phy_status_result()
1598 return SPEED_2500; in xgbe_phy_best_advertised_speed()
1600 return SPEED_2500; in xgbe_phy_best_advertised_speed()
H A Dxgbe-phy-v1.c544 case SPEED_2500: in xgbe_phy_get_mode()
615 case SPEED_2500: in xgbe_phy_valid_speed()
/openbmc/linux/drivers/net/ethernet/microchip/lan966x/
H A Dlan966x_port.c162 case SPEED_2500: in lan966x_port_link_up()
325 state->speed = SPEED_2500; in lan966x_port_status_get()
H A Dlan966x_taprio.c427 case SPEED_2500: in lan966x_taprio_speed_set()
/openbmc/linux/drivers/net/usb/
H A Daqc111.c250 case SPEED_2500: in aqc111_speed_to_link_mode()
305 speed = SPEED_2500; in aqc111_get_link_ksettings()
337 case SPEED_2500: in aqc111_set_phy_speed()
352 case SPEED_2500: in aqc111_set_phy_speed()
388 speed != SPEED_2500 && in aqc111_set_link_ksettings()
/openbmc/linux/drivers/net/dsa/b53/
H A Db53_serdes.c126 state->speed = SPEED_2500; in b53_serdes_get_state()
/openbmc/linux/drivers/net/ethernet/intel/igc/
H A Digc_tsn.c77 case SPEED_2500: in igc_tsn_adjust_txtime_offset()
H A Digc_defines.h234 #define SPEED_2500 2500 macro
H A Digc_ptp.c502 case SPEED_2500: in igc_ptp_rx_pktstamp()
734 case SPEED_2500: in igc_ptp_tx_reg_to_stamp()
H A Digc_mac.c694 *speed = SPEED_2500; in igc_get_speed_and_duplex_copper()
/openbmc/linux/drivers/net/pcs/
H A Dpcs-lynx.c78 state->speed = SPEED_2500; in lynx_pcs_get_state_2500basex()
/openbmc/u-boot/include/linux/
H A Dethtool.h621 #define SPEED_2500 2500 macro
/openbmc/linux/include/linux/
H A Dmii.h562 case SPEED_2500: in mii_bmcr_encode_fixed()
/openbmc/linux/drivers/net/ethernet/broadcom/
H A Dbnx2.c961 case SPEED_2500: in bnx2_report_fw_link()
1134 bp->line_speed = SPEED_2500; in bnx2_5709s_linkup()
1162 bp->line_speed = SPEED_2500; in bnx2_5708s_linkup()
1343 case SPEED_2500: in bnx2_set_mac_link()
1718 if (bp->req_line_speed == SPEED_2500) in bnx2_setup_remote_phy()
1783 if (bp->req_line_speed == SPEED_2500) in bnx2_setup_serdes_phy()
1928 bp->req_line_speed = SPEED_2500; in bnx2_set_default_remote_link()
2018 bp->line_speed = SPEED_2500; in bnx2_remote_phy_event()
3970 if (bp->line_speed == SPEED_2500) in bnx2_setup_wol()
6990 speed != SPEED_2500) || in bnx2_set_link_ksettings()
[all …]
/openbmc/linux/drivers/net/ethernet/intel/igb/
H A De1000_defines.h259 #define SPEED_2500 2500 macro

1234