/openbmc/u-boot/arch/arm/cpu/armv8/fsl-layerscape/doc/ |
H A D | README.soc | 32 - Up to 1 x XFI supporting 10G interface 34 - Up to 4 x SGMII supporting 1000Mbps 35 - Up to 2 x SGMII supporting 2500Mbps 36 - Up to 2 x RGMII supporting 1000Mbps 38 - Three PCIe 2.0 controllers, one supporting x4 operation 47 - Integrated flash controller supporting NAND and NOR flash 71 - QSPI, SPI, IFC2.0 supporting NAND, NOR flash 111 - Four PCIe 3.0 controllers, one supporting SR-IOV 120 - Integrated flash controller (IFC 2.0) supporting NAND and NOR flash 146 - One PCI Express Gen2 controller, supporting x1 operation [all …]
|
/openbmc/openbmc/poky/meta/files/common-licenses/ |
H A D | OFFIS | 3 This software and supporting documentation were developed by 16 Copyright of the software and supporting documentation is, unless 20 of this software source code or supporting documentation or derivative 21 works (source code and supporting documentation) must include the
|
H A D | LOOP | 8 supporting documentation. The names "M.I.T." and "Massachusetts 11 prior permission. Notice must be given in supporting documentation that 29 supporting documentation. The name "Symbolics" may not be used in 32 supporting documentation that copying distribution is by permission of
|
H A D | HPND-Fenneberg-Livingston | 5 permission notice appear on all copies and supporting documentation, the 8 given in supporting documentation that copying and distribution is by
|
/openbmc/linux/include/dt-bindings/pinctrl/ |
H A D | qcom,pmic-gpio.h | 20 * Note: PM8018 GPIO3 and GPIO4 are supporting 32 * Note: PM8038 GPIO7 and GPIO8 are supporting 53 * Note: PM8916 GPIO1 and GPIO2 are supporting 76 * Note: PM8941 gpios from 15 to 18 are supporting 85 * Note: PMA8084 gpios from 15 to 18 are supporting
|
/openbmc/u-boot/board/freescale/ls1021atwr/ |
H A D | README | 37 supporting speeds up to 1600Mtps 46 - One Serial ATA 3.0 supporting 6 GT/s operation 47 - Two SGMII interfaces supporting 1000 Mbps 58 - Eight FlexTimers four supporting PWM and four FlexCAN ports 59 - Four GPIO controllers supporting up to 109 general purpose I/O signals 72 - Two universal communication controllers (TDM and HDLC) supporting 64
|
/openbmc/u-boot/board/freescale/ls1021aqds/ |
H A D | README | 37 supporting speeds up to 1600Mtps 46 - One Serial ATA 3.0 supporting 6 GT/s operation 47 - Two SGMII interfaces supporting 1000 Mbps 58 - Eight FlexTimers four supporting PWM and four FlexCAN ports 59 - Four GPIO controllers supporting up to 109 general purpose I/O signals 72 - Two universal communication controllers (TDM and HDLC) supporting 64
|
/openbmc/u-boot/board/freescale/t1040qds/ |
H A D | README | 34 - Two SATA controllers supporting 1.5 and 3.0 Gb/s operation 36 - Upto six SGMII interface supporting 1000 Mbps 37 - One SGMII interface supporting upto 2500 Mbps 55 - SERDES Connections, 8 lanes supporting: 56 — PCI Express: supporting Gen 1 and Gen 2; 85 - Supporting SD slots for: SD, SDHC (1x, 4x, 8x) and/or MMC 86 — Supporting eMMC memory devices
|
/openbmc/linux/drivers/net/wan/ |
H A D | Kconfig | 34 You will need supporting software from 48 Generic HDLC driver supporting raw HDLC over WAN connections. 56 Generic HDLC driver supporting raw HDLC Ethernet device emulation 67 Generic HDLC driver supporting Cisco HDLC over WAN connections. 75 Generic HDLC driver supporting Frame Relay over WAN connections. 83 Generic HDLC driver supporting PPP over WAN connections. 91 Generic HDLC driver supporting X.25 over WAN connections.
|
/openbmc/linux/drivers/pinctrl/starfive/ |
H A D | Kconfig | 17 peripherals supporting inputs, outputs, configuring pull-up/pull-down 38 peripherals supporting inputs, outputs, configuring pull-up/pull-down 50 peripherals supporting inputs, outputs, configuring pull-up/pull-down
|
/openbmc/linux/Documentation/devicetree/bindings/pinctrl/ |
H A D | samsung,pinctrl-gpio-bank.yaml | 31 For GPIO banks supporting external GPIO interrupts or external wake-up 37 For GPIO banks supporting external GPIO interrupts or external wake-up 42 For GPIO banks supporting direct external wake-up interrupts (without
|
H A D | pincfg-node.yaml | 38 supporting it the pull strength in Ohm. 45 supporting it the pull strength in Ohm. 52 hardware supporting it the pull strength in Ohm.
|
/openbmc/linux/sound/soc/sof/amd/ |
H A D | vangogh.c | 45 /* Supporting only stereo for I2S HS controller capture */ 69 /* Supporting only stereo for I2S BT controller capture */ 93 /* Supporting only stereo for I2S SP controller capture */ 130 /* Supporting only stereo for I2S HS-Virtual controller capture */
|
H A D | rembrandt.c | 45 /* Supporting only stereo for I2S HS controller capture */ 69 /* Supporting only stereo for I2S BT controller capture */ 93 /* Supporting only stereo for I2S SP controller capture */
|
/openbmc/u-boot/board/freescale/ls2080aqds/ |
H A D | README | 16 - SERDES Connections, 16 lanes supporting: 29 - IFC rev. 2.0 implementation supporting Little Endian connection scheme. 39 - SDHC: PCIe x1 Right Angle connector for supporting following cards 40 - 1/4-/8-bit SD/MMC Legacy CARD supporting 3.3V devices only 41 - 1-/4-/8-bit SD/MMC Card supporting 1.8V devices only 54 - Two DB9 D-Type connectors supporting one Serial port each
|
/openbmc/u-boot/drivers/phy/ |
H A D | Kconfig | 93 This PHY is found on omap devices supporting SATA such as dra7, am57x 102 This PHY is found on omap devices supporting SATA such as dra7, am57x 165 This PHY is found on OMAP devices supporting USB2. 175 This PHY is found on some Keystone (K2) devices supporting USB.
|
/openbmc/linux/Documentation/powerpc/ |
H A D | elf_hwcaps.rst | 147 supporting later architectures DO NOT set this feature. 160 supporting later architectures also set this feature. 182 supporting later architectures also set this feature. 209 supporting later architectures also set this feature. 228 supporting later architectures also set this feature.
|
/openbmc/u-boot/board/freescale/ls1043ardb/ |
H A D | README | 16 - SERDES Connections, 4 lanes supporting: 17 - PCI Express 2.0 with two PCIe connectors supporting: miniPCIe card and 34 - Two DB9 D-Type connectors supporting one Serial port each
|
/openbmc/linux/Documentation/devicetree/bindings/regulator/ |
H A D | maxim,max77802.yaml | 43 LDOs supporting the regulator-initial-mode property and changing their 52 LDOs supporting the regulator-mode property (changing mode to Low Power 64 bucks supporting the regulator-mode property (changing mode to Low Power
|
/openbmc/u-boot/board/freescale/ls1046ardb/ |
H A D | README | 16 - SERDES1 Connections, 4 lanes supporting: 21 - SERDES2 Connections, 4 lanes supporting: 38 - Two DB9 D-Type connectors supporting one Serial port each
|
/openbmc/u-boot/board/freescale/t102xqds/ |
H A D | README | 21 - CoreNet coherency manager supporting coherent and noncoherent transactions 38 - One SATA controller supporting 1.5 and 3.0 Gb/s operation 40 - Four SGMII interface supporting 1000 Mbps 41 - Three SGMII interfaces supporting up to 2500 Mbps 59 - Two universal communication controllers, supporting TDM, HDLC, and UART 78 4 lanes supporting the following: 102 - Four SGMII interface supporting 1Gbps 103 - Three SGMII interfaces supporting 2.5Gbps
|
/openbmc/linux/arch/sh/cchips/ |
H A D | Kconfig | 16 the SH7709 CPU, supporting a LCD controller, 18 PCMCIA controller supporting 2 slots.
|
/openbmc/openbmc/poky/meta/recipes-core/glibc/glibc/ |
H A D | run-ptest | 25 # Do not run tests supporting only 32 bit time 32 # Run tests supporting only 64 bit time
|
/openbmc/u-boot/arch/arm/mach-rockchip/ |
H A D | Kconfig | 71 video interfaces supporting HDMI and eDP, several DDR3 options 91 video interfaces supporting HDMI and eDP, several DDR3 options 111 output processor supporting LVDS/HDMI/eDP, several DDR3 options and 145 video interfaces supporting HDMI and eDP, several DDR3 options
|
/openbmc/u-boot/board/freescale/t102xrdb/ |
H A D | README | 21 - CoreNet coherency manager supporting coherent and noncoherent transactions 38 - One SATA controller supporting 1.5 and 3.0 Gb/s operation 40 - Four SGMII interface supporting 1000 Mbps 41 - Three SGMII interfaces supporting up to 2500 Mbps 59 - Two universal communication controllers, supporting TDM, HDLC, and UART 94 - one SD connector supporting 1.8V/3.3V via J53. 105 - CoreNet fabric supporting coherent and noncoherent transactions with
|