| /openbmc/qemu/hw/dma/ |
| H A D | trace-events | 30 pl330_dmakill(void) "abort interrupt lowered"
37 pl330_dmawfe(uint8_t ev_id) "event lowered 0x%"PRIx8
45 pl330_iomem_write_clr(int i) "event interrupt lowered %d"
|
| /openbmc/qemu/hw/char/ |
| H A D | trace-events | 86 exynos_uart_irq_lowered(uint32_t channel) "UART%d: IRQ lowered"
116 stm32l4x5_usart_irq_lowered(void) "USART: IRQ lowered"
|
| /openbmc/linux/Documentation/devicetree/bindings/power/supply/ |
| H A D | bq25890.yaml | 79 temperature above which the charge current is lowered, to avoid overheating
|
| /openbmc/linux/Documentation/devicetree/bindings/arm/msm/ |
| H A D | qcom,idle-state.txt | 50 be flushed, system bus, clocks - lowered, and SoC main XO clock gated and
|
| /openbmc/linux/Documentation/driver-api/ |
| H A D | regulator.rst | 102 frequencies but does not require that the supply voltage be lowered). Where
|
| /openbmc/linux/Documentation/hwmon/ |
| H A D | w83792d.rst | 146 interval. The fan speed will be lowered as long as the current temperature
|
| /openbmc/linux/drivers/gpu/drm/amd/display/dc/clk_mgr/dcn20/ |
| H A D | dcn20_clk_mgr.c | 323 // if clock is being lowered, increase DTO before lowering refclk in dcn2_update_clocks()
330 // always update dtos unless clock is lowered and not safe to lower in dcn2_update_clocks()
|
| /openbmc/linux/Documentation/virt/kvm/x86/ |
| H A D | timekeeping.rst | 92 lowered), during which the output is set low. When the count reaches zero,
99 low, the count is halted. If the output is low when the gate is lowered, the
123 (which does not stop if the gate is lowered). When the counter reaches zero,
|
| /openbmc/linux/Documentation/scsi/ |
| H A D | advansys.rst | 18 lowered in the BIOS by changing the 'Host Queue Size' adapter setting.
|
| /openbmc/linux/drivers/net/can/usb/etas_es58x/ |
| H A D | es581_4.c | 483 * the device and thus, echo_skb_max was lowered to the
|
| /openbmc/linux/drivers/usb/serial/ |
| H A D | io_ionsp.h | 277 // beginning transmission and lowered after
|
| /openbmc/linux/tools/testing/selftests/net/forwarding/ |
| H A D | bridge_igmp.sh | 427 # make sure the lowered timers have expired (by default 2 seconds)
|
| /openbmc/u-boot/drivers/pci/ |
| H A D | pci-aardvark.c | 627 * with the SOC RESET signal. It should be lowered as early as in pcie_advk_probe()
|
| /openbmc/linux/drivers/gpu/drm/amd/display/dc/clk_mgr/dcn316/ |
| H A D | dcn316_clk_mgr.c | 232 // always update dtos unless clock is lowered and not safe to lower in dcn316_update_clocks()
|
| /openbmc/linux/net/bridge/ |
| H A D | br_multicast_eht.c | 643 * entries still exist (unless lowered to LMQT in __eht_inc_exc()
|
| /openbmc/linux/sound/soc/ti/ |
| H A D | davinci-i2s.c | 289 * rate is lowered. in davinci_i2s_set_dai_fmt()
|
| /openbmc/linux/drivers/gpu/drm/amd/display/dc/clk_mgr/dcn30/ |
| H A D | dcn30_clk_mgr.c | 302 /* if clock is being lowered, increase DTO before lowering refclk */ in dcn3_update_clocks()
|
| /openbmc/linux/Documentation/networking/device_drivers/hamradio/ |
| H A D | z8530drv.rst | 486 should be somewhere near 50-60, and should be lowered when
|
| /openbmc/linux/drivers/ssb/ |
| H A D | driver_pcicore.c | 366 * Tested delay 850 us lowered reboot chance to 50-80%, 1000 us fixed it in ssb_pcicore_init_hostmode()
|
| /openbmc/linux/drivers/staging/media/av7110/ |
| H A D | budget-patch.c | 507 ** ends, HS is lowered. in budget_patch_attach()
|
| /openbmc/linux/drivers/gpu/drm/amd/display/dc/clk_mgr/dcn31/ |
| H A D | dcn31_clk_mgr.c | 241 // always update dtos unless clock is lowered and not safe to lower in dcn31_update_clocks()
|
| /openbmc/linux/drivers/gpu/drm/amd/display/dc/clk_mgr/dcn315/ |
| H A D | dcn315_clk_mgr.c | 228 // always update dtos unless clock is lowered and not safe to lower in dcn315_update_clocks()
|
| /openbmc/linux/drivers/net/wireless/ralink/rt2x00/ |
| H A D | rt2400pci.h | 933 * value means that the txpower must be lowered. This is
|
| /openbmc/linux/Documentation/driver-api/media/drivers/ |
| H A D | zoran.rst | 511 a safe bet. Personally, I think I would have lowered requested-bits-per-block
|
| /openbmc/linux/drivers/gpu/drm/amd/display/dc/clk_mgr/dcn21/ |
| H A D | rn_clk_mgr.c | 237 // always update dtos unless clock is lowered and not safe to lower in rn_update_clocks()
|