| 663163f0 | 18-Apr-2024 |
Peter Maydell <peter.maydell@linaro.org> |
target/arm: Enable FEAT_Spec_FPACC for -cpu max
FEAT_Spec_FPACC is a feature describing speculative behaviour in the
event of a PAC authontication failure when FEAT_FPACCOMBINE is
implemented. FEAT
target/arm: Enable FEAT_Spec_FPACC for -cpu max
FEAT_Spec_FPACC is a feature describing speculative behaviour in the
event of a PAC authontication failure when FEAT_FPACCOMBINE is
implemented. FEAT_Spec_FPACC means that the speculative use of
pointers processed by a PAC Authentication is not materially
different in terms of the impact on cached microarchitectural state
(caches, TLBs, etc) between passing and failing of the PAC
Authentication.
QEMU doesn't do speculative execution, so we can advertise
this feature.
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Reviewed-by: Philippe Mathieu-Daudé <philmd@linaro.org>
Message-id: 20240418152004.2106516-6-peter.maydell@linaro.org
show more ...
|
| 74360f35 | 18-Apr-2024 |
Peter Maydell <peter.maydell@linaro.org> |
target/arm: Enable FEAT_ETS2 for -cpu max
FEAT_ETS2 is a tighter set of guarantees about memory ordering
involving translation table walks than the old FEAT_ETS; FEAT_ETS has
been retired from the A
target/arm: Enable FEAT_ETS2 for -cpu max
FEAT_ETS2 is a tighter set of guarantees about memory ordering
involving translation table walks than the old FEAT_ETS; FEAT_ETS has
been retired from the Arm ARM and the old ID_AA64MMFR1.ETS == 1
now gives no greater guarantees than ETS == 0.
FEAT_ETS2 requires:
* the virtual address of a load or store that appears in program
order after a DSB cannot be translated until after the DSB
completes (section B2.10.9)
* TLB maintenance operations that only affect translations without
execute permission are guaranteed complete after a DSB
(R_BLDZX)
* if a memory access RW2 is ordered-before memory access RW2,
then RW1 is also ordered-before any translation table walk
generated by RW2 that generates a Translation, Address size
or Access flag fault (R_NNFPF, I_CLGHP)
As with FEAT_ETS, QEMU is already compliant, because we do not
reorder translation table walk memory accesses relative to other
memory accesses, and we always guarantee to have finished TLB
maintenance as soon as the TLB op is done.
Update the documentation to list FEAT_ETS2 instead of the
no-longer-existent FEAT_ETS, and update the 'max' CPU ID registers.
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Reviewed-by: Philippe Mathieu-Daudé <philmd@linaro.org>
Message-id: 20240418152004.2106516-4-peter.maydell@linaro.org
show more ...
|
| e1973951 | 18-Apr-2024 |
Peter Maydell <peter.maydell@linaro.org> |
target/arm: Enable FEAT_CSV2_3 for -cpu max
FEAT_CSV2_3 adds a mechanism to identify if hardware cannot disclose
information about whether branch targets and branch history trained
in one hardware d
target/arm: Enable FEAT_CSV2_3 for -cpu max
FEAT_CSV2_3 adds a mechanism to identify if hardware cannot disclose
information about whether branch targets and branch history trained
in one hardware described context can control speculative execution
in a different hardware context.
There is no branch prediction in TCG, so we don't need to do anything
to be compliant with this. Upadte the '-cpu max' ID registers to
advertise the feature.
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Reviewed-by: Philippe Mathieu-Daudé <philmd@linaro.org>
Message-id: 20240418152004.2106516-3-peter.maydell@linaro.org
show more ...
|
| 1cdcfb6e | 05-Mar-2024 |
Inès Varhol <ines.varhol@telecom-paris.fr> |
hw/gpio: Implement STM32L4x5 GPIO
Features supported :
- the 8 STM32L4x5 GPIOs are initialized with their reset values
(except IDR, see below)
- input mode : setting a pin in input mode "externa
hw/gpio: Implement STM32L4x5 GPIO
Features supported :
- the 8 STM32L4x5 GPIOs are initialized with their reset values
(except IDR, see below)
- input mode : setting a pin in input mode "externally" (using input
irqs) results in an out irq (transmitted to SYSCFG)
- output mode : setting a bit in ODR sets the corresponding out irq
(if this line is configured in output mode)
- pull-up, pull-down
- push-pull, open-drain
Difference with the real GPIOs :
- Alternate Function and Analog mode aren't implemented :
pins in AF/Analog behave like pins in input mode
- floating pins stay at their last value
- register IDR reset values differ from the real one :
values are coherent with the other registers reset values
and the fact that AF/Analog modes aren't implemented
- setting I/O output speed isn't supported
- locking port bits isn't supported
- ADC function isn't supported
- GPIOH has 16 pins instead of 2 pins
- writing to registers LCKR, AFRL, AFRH and ASCR is ineffective
Signed-off-by: Arnaud Minier <arnaud.minier@telecom-paris.fr>
Signed-off-by: Inès Varhol <ines.varhol@telecom-paris.fr>
Reviewed-by: Philippe Mathieu-Daudé <philmd@linaro.org>
Acked-by: Alistair Francis <alistair.francis@wdc.com>
Message-id: 20240305210444.310665-2-ines.varhol@telecom-paris.fr
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
show more ...
|
| c9948fdd | 09-Jan-2024 |
Inès Varhol <ines.varhol@telecom-paris.fr> |
hw/misc: Implement STM32L4x5 EXTI
Although very similar to the STM32F4xx EXTI, STM32L4x5 EXTI generates
more than 32 event/interrupt requests and thus uses more registers
than STM32F4xx EXTI which g
hw/misc: Implement STM32L4x5 EXTI
Although very similar to the STM32F4xx EXTI, STM32L4x5 EXTI generates
more than 32 event/interrupt requests and thus uses more registers
than STM32F4xx EXTI which generates 23 event/interrupt requests.
Acked-by: Alistair Francis <alistair.francis@wdc.com>
Signed-off-by: Arnaud Minier <arnaud.minier@telecom-paris.fr>
Signed-off-by: Inès Varhol <ines.varhol@telecom-paris.fr>
Reviewed-by: Philippe Mathieu-Daudé <philmd@linaro.org>
Message-id: 20240109160658.311932-2-ines.varhol@telecom-paris.fr
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
show more ...
|
| e2862554 | 09-Jan-2024 |
Peter Maydell <peter.maydell@linaro.org> |
target/arm: Add FEAT_NV2 to max, neoverse-n2, neoverse-v1 CPUs
Enable FEAT_NV2 on the 'max' CPU, and stop filtering it out for
the Neoverse N2 and Neoverse V1 CPUs.
Signed-off-by: Peter Maydell <pe
target/arm: Add FEAT_NV2 to max, neoverse-n2, neoverse-v1 CPUs
Enable FEAT_NV2 on the 'max' CPU, and stop filtering it out for
the Neoverse N2 and Neoverse V1 CPUs.
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Tested-by: Miguel Luis <miguel.luis@oracle.com>
show more ...
|