| /openbmc/linux/drivers/bus/ |
| H A D | ts-nbus.c | 35 struct gpio_desc *rdy; member
76 ts_nbus->rdy = devm_gpiod_get(&pdev->dev, "ts,rdy", GPIOD_IN); in ts_nbus_init_pdata()
77 if (IS_ERR(ts_nbus->rdy)) { in ts_nbus_init_pdata()
79 return PTR_ERR(ts_nbus->rdy); in ts_nbus_init_pdata()
227 ret = gpiod_get_value_cansleep(ts_nbus->rdy); in ts_nbus_read()
262 while (gpiod_get_value_cansleep(ts_nbus->rdy) != 0) { in ts_nbus_write()
|
| /openbmc/linux/drivers/mtd/nand/raw/ |
| H A D | gpio.c | 39 struct gpio_desc *rdy; member
124 if (!gpiomtd->rdy) in gpio_nand_exec_instr()
127 return nand_gpio_waitrdy(chip, gpiomtd->rdy, in gpio_nand_exec_instr()
342 gpiomtd->rdy = devm_gpiod_get_optional(dev, "rdy", GPIOD_IN); in gpio_nand_probe()
343 if (IS_ERR(gpiomtd->rdy)) { in gpio_nand_probe()
344 ret = PTR_ERR(gpiomtd->rdy); in gpio_nand_probe()
|
| H A D | lpc32xx_slc.c | 298 int rdy = 0; in lpc32xx_nand_device_ready() local
301 rdy = 1; in lpc32xx_nand_device_ready()
303 return rdy; in lpc32xx_nand_device_ready()
|
| /openbmc/linux/Documentation/devicetree/bindings/bus/ |
| H A D | ts-nbus.txt | 16 - ts,rdy-gpios : The GPIO pin connected to the rdy line on the FPGA
43 ts,rdy-gpios = <&gpio0 21 GPIO_ACTIVE_HIGH>;
|
| H A D | nvidia,tegra20-gmi.txt | 45 - nvidia,snor-rdy-active-before-data: Assert RDY signal one cycle before data.
47 - nvidia,snor-rdy-active-high: RDY signal is active high
|
| /openbmc/qemu/hw/pci/ |
| H A D | pcie_doe.c | 183 static void pcie_doe_set_ready(DOECap *doe_cap, bool rdy) in pcie_doe_set_ready() argument
185 doe_cap->status.ready = rdy; in pcie_doe_set_ready()
187 if (rdy) { in pcie_doe_set_ready()
|
| /openbmc/u-boot/drivers/mmc/ |
| H A D | sdhci.c | 73 unsigned int stat, rdy, mask, timeout, block = 0; in sdhci_transfer_data() local
83 rdy = SDHCI_INT_SPACE_AVAIL | SDHCI_INT_DATA_AVAIL; in sdhci_transfer_data()
92 if (!transfer_done && (stat & rdy)) { in sdhci_transfer_data()
95 sdhci_writel(host, rdy, SDHCI_INT_STATUS); in sdhci_transfer_data()
|
| /openbmc/linux/drivers/input/touchscreen/ |
| H A D | wacom_w8001.c | 60 u8 rdy; member
111 coord->rdy = data[0] & 0x20; in parse_pen_data()
256 input_report_key(dev, w8001->type, coord->rdy); in report_pen_events()
259 if (!coord->rdy) in report_pen_events()
|
| /openbmc/linux/drivers/scsi/aic7xxx/ |
| H A D | aic7xxx_93cx6.c | 95 #define CLOCK_PULSE(sd, rdy) \ argument
96 while ((SEEPROM_STATUS_INB(sd) & rdy) == 0) { \
|
| /openbmc/linux/Documentation/devicetree/bindings/phy/ |
| H A D | phy-miphy28lp.txt | 34 - st,osc-rdy : to check the MIPHY0_OSC_RDY status in the glue-logic. This
65 st,osc-rdy;
|
| /openbmc/linux/Documentation/devicetree/bindings/pinctrl/ |
| H A D | lantiq,pinctrl-xway.txt | 67 ebu cs1, ebu wait, nand ale, nand cs1, nand cle, nand rdy, nand rd,
79 ebu cs1, ebu wait, nand ale, nand cs1, nand cle, nand rdy, nand rd,
94 nand rdy, nand rd, nand_d0, nand_d1, nand_d2, nand_d3, nand_d4, nand_d5,
|
| /openbmc/linux/arch/mips/boot/dts/ni/ |
| H A D | 169445.dts | 67 gpios = <&gpio2 0 0>, /* rdy */
|
| /openbmc/linux/arch/arm/boot/dts/st/ |
| H A D | stih418-b2199.dts | 43 st,osc-rdy;
|
| H A D | stih418-b2264.dts | 121 st,osc-rdy;
|
| H A D | stihxxx-b2120.dtsi | 77 st,osc-rdy;
|
| /openbmc/linux/drivers/crypto/amcc/ |
| H A D | crypto4xx_reg_def.h | 231 u32 rdy:1; member
|
| H A D | crypto4xx_core.c | 893 sd->ctl.rdy = 1; in crypto4xx_build_pd()
904 sd->ctl.rdy = 1; in crypto4xx_build_pd()
|
| /openbmc/linux/Documentation/devicetree/bindings/mtd/ |
| H A D | atmel-nand.txt | 181 gpios = <&pioC 13 0 /* rdy */
208 gpios = <&pioD 5 0 /* rdy */
|
| /openbmc/linux/sound/pci/ |
| H A D | sis7019.c | 895 u16 rdy; in sis_ac97_rw() local
903 rdy = codec_ready[codec]; in sis_ac97_rw()
923 if ((status & rdy) && !(status & SIS_AC97_STATUS_BUSY)) in sis_ac97_rw()
|
| /openbmc/linux/drivers/scsi/be2iscsi/ |
| H A D | be_cmds.c | 1617 u32 loop, post, rdy = 0; in beiscsi_check_fw_rdy() local
1625 rdy = 1; in beiscsi_check_fw_rdy()
1631 if (!rdy) { in beiscsi_check_fw_rdy()
1636 return rdy; in beiscsi_check_fw_rdy()
|
| /openbmc/u-boot/include/ |
| H A D | usbdevice.h | 501 struct urb_link rdy; /* empty urbs ready to receive */ member
|
| /openbmc/linux/drivers/scsi/hisi_sas/ |
| H A D | hisi_sas.h | 653 extern void hisi_sas_phy_down(struct hisi_hba *hisi_hba, int phy_no, int rdy,
|
| H A D | hisi_sas_main.c | 2053 void hisi_sas_phy_down(struct hisi_hba *hisi_hba, int phy_no, int rdy, in hisi_sas_phy_down() argument
2060 if (rdy) { in hisi_sas_phy_down()
|
| /openbmc/u-boot/drivers/serial/ |
| H A D | usbtty.c | 708 urb_link_init (&endpoint_instance[i].rdy); in usbtty_init_instances()
|
| /openbmc/u-boot/arch/arm/dts/ |
| H A D | rk3128.dtsi | 661 nandc_rdy:nandc-rdy {
|