/openbmc/qemu/hw/ssi/ |
H A D | Kconfig | 3 select SSI 7 select SSI 9 config SSI config 14 select SSI 18 select SSI 22 select SSI 26 select SSI 30 select SSI 34 select SSI
|
/openbmc/linux/Documentation/devicetree/bindings/sound/ |
H A D | renesas,rsnd.txt | 17 SSI : Serial Sound Interface 25 Multi channel is supported by Multi-SSI, or TDM-SSI. 27 Multi-SSI : 6ch case, you can use stereo x 3 SSI 28 TDM-SSI : 6ch case, you can use TDM 185 But you can't use it if SSI was PIO mode. 186 In DMA mode, you can select not to use SSIU by using "no-busif" via SSI. 192 and these sounds will be merged SSIU/SSI. 211 * SSI (Serial Sound Interface) 217 Note: The system will drop non-SSI modules in PIO mode 235 Each SSI can share WS pin. It is based on platform. [all …]
|
H A D | fsl,ssi.txt | 3 The SSI is a serial device that communicates with audio codecs. It can 13 - cell-index: The SSI, <0> = SSI1, <1> = SSI2, and so on. 23 - clocks: "ipg" - Required clock for the SSI unit 24 "baud" - Required clock for SSI master mode. Otherwise this 33 codec connected to this SSI. This node is typically 37 where an incompatible codec is connected to this SSI, e.g. 44 "ac97-slave" - AC97 mode, SSI is clock slave 45 "ac97-master" - AC97 mode, SSI is clock master 47 If specified, the SSI is to be programmed in asynchronous 74 On SOCs that have an SSI, specific DMA channels are hard-wired for playback
|
H A D | eukrea-tlv320.txt | 9 - ssi-controller : The phandle of the SSI controller.
|
H A D | imx-audio-sgtl5000.txt | 9 - ssi-controller : The phandle of the i.MX SSI controller
|
H A D | imx-audio-es8328.txt | 6 - ssi-controller : The phandle of the i.MX SSI controller
|
/openbmc/linux/drivers/hsi/clients/ |
H A D | Kconfig | 28 tristate "SSI protocol" 31 If you say Y here, you will enable the SSI protocol aka McSAAB. 36 tristate "HSI/SSI character driver" 39 If you say Y here, you will enable the HSI/SSI character driver. 41 serial communication with the cellular modem over HSI/SSI bus.
|
/openbmc/linux/drivers/hsi/controllers/ |
H A D | Kconfig | 8 tristate "OMAP SSI hardware driver" 12 SSI is a legacy version of HSI. It is usually used to connect 14 If you say Y here, you will enable the OMAP SSI hardware driver.
|
/openbmc/qemu/docs/system/arm/ |
H A D | stellaris.rst | 23 - Timers, UARTs, ADC, |I2C| and SSI interfaces. 26 SSI.
|
/openbmc/linux/Documentation/devicetree/bindings/mfd/ |
H A D | hisilicon,hi655x.txt | 4 Between PMIC Hi655x and Hi6220, the physical signal channel is SSI. 9 | Hi6220 | SSI bus | Hi655x |
|
H A D | mc13xxx.txt | 14 - adc-port: Contain PMIC SSI port number used for ADC. 15 - dac-port: Contain PMIC SSI port number used for DAC.
|
/openbmc/linux/arch/arm/boot/dts/gemini/ |
H A D | gemini-ssi1328.dts | 4 * Device Tree file for SSI 1328 12 model = "SSI 1328";
|
/openbmc/linux/sound/soc/sh/ |
H A D | Kconfig | 40 tristate "R-Car series SRU/SCU/SSIU/SSI support" 46 This option enables R-Car SRU/SCU/SSIU/SSI sound support
|
/openbmc/linux/arch/sh/kernel/cpu/sh4a/ |
H A D | setup-sh7780.c | 307 SCIF1, SIOF, HSPI, MMCIF, TMU3, TMU4, TMU5, SSI, FLCTL, GPIO, enumerator 343 INTC_VECT(SSI, 0xe80), 358 SSI, MMCIF, HSPI, SIOF, PCIC5, PCIINTD, PCIINTC, PCIINTB, 373 { 0xffd40018, 0, 32, 8, /* INT2PRI6 */ { SIOF, HSPI, MMCIF, SSI } },
|
H A D | setup-sh7734.c | 363 SSI, enumerator 439 INTC_GROUP(SSI, SSI0, SSI1, SSI2, SSI3), 487 SSI, /* SSI 0-3 */ 505 { HUDI, SHDMAC, USB, SSI } },
|
/openbmc/qemu/hw/sd/ |
H A D | Kconfig | 7 depends on SSI
|
/openbmc/linux/Documentation/devicetree/bindings/hsi/ |
H A D | omap-ssi.txt | 1 OMAP SSI controller bindings 3 OMAP3's Synchronous Serial Interface (SSI) controller implements a
|
/openbmc/qemu/hw/arm/ |
H A D | Kconfig | 247 select SSI 433 select SSI 479 select SSI 537 select SSI 631 select SSI
|
/openbmc/linux/sound/soc/fsl/ |
H A D | Kconfig | 47 tristate "Synchronous Serial Interface module (SSI) support" 52 Say Y if you want to add Synchronous Serial Interface (SSI) 281 to the SSI interface 293 via SSI/I2S over either SPI or I2C. 335 ESAI/SAI/SSI and connect with external CODECs such as WM8962, CS42888,
|
/openbmc/openbmc/meta-openembedded/meta-oe/recipes-support/ssiapi/ |
H A D | ssiapi_1.3.0.bb | 1 SUMMARY = "Intel RSTe with Linux OS SSI API Library"
|
/openbmc/linux/drivers/pinctrl/ |
H A D | pinctrl-xway.c | 452 MFP_XWAY(GPIO34, GPIO, SIN, SSI, NONE), 453 MFP_XWAY(GPIO35, GPIO, SIN, SSI, NONE), 454 MFP_XWAY(GPIO36, GPIO, SIN, SSI, NONE), 665 MFP_XWAY(GPIO34, GPIO, SIN, SSI, NONE), 666 MFP_XWAY(GPIO35, GPIO, SIN, SSI, NONE), 667 MFP_XWAY(GPIO36, GPIO, SIN, SSI, EXIN), 921 MFP_XWAY(GPIO34, GPIO, NONE, SSI, NONE), 922 MFP_XWAY(GPIO35, GPIO, NONE, SSI, NONE), 923 MFP_XWAY(GPIO36, GPIO, NONE, SSI, NONE),
|
/openbmc/linux/Documentation/devicetree/bindings/powerpc/fsl/ |
H A D | dma.txt | 200 DMA driver, such as the SSI sound drivers for the MPC8610. Therefore, any DMA 202 "fsl,elo-dma-channel" or "fsl,eloplus-dma-channel". For the SSI drivers, for
|
/openbmc/linux/Documentation/devicetree/bindings/clock/ti/ |
H A D | interface.txt | 22 "ti,omap3-ssi-interface-clock" - interface clock with SSI specific HW handling
|
/openbmc/qemu/hw/misc/ |
H A D | Kconfig | 89 select SSI
|
/openbmc/linux/arch/arm64/boot/dts/renesas/ |
H A D | rz-smarc-common.dtsi | 12 * SSI-WM8978
|