| /openbmc/u-boot/drivers/pinctrl/mscc/ |
| H A D | pinctrl-luton.c | 63 MSCC_P(10, SFP, PHY_LED, NONE);
64 MSCC_P(11, SFP, PHY_LED, NONE);
65 MSCC_P(12, SFP, PHY_LED, NONE);
66 MSCC_P(13, SFP, PHY_LED, NONE);
70 MSCC_P(17, SFP, PHY_LED, NONE);
71 MSCC_P(18, SFP, PHY_LED, NONE);
72 MSCC_P(19, SFP, PHY_LED, NONE);
73 MSCC_P(20, SFP, PHY_LED, NONE);
74 MSCC_P(21, SFP, PHY_LED, NONE);
75 MSCC_P(22, SFP, PHY_LED, NONE);
[all …]
|
| /openbmc/u-boot/arch/arm/dts/ |
| H A D | armada-8040-mcbin.dts | 94 * [51] 2.5G SFP TX fault
96 * [53] 2.5G SFP mode
97 * [54] 2.5G SFP LOS
100 * [62] CP1 SFI SFP FAULT
221 * [8] CP1 10G SFP LOS
223 * [10] CP1 10G SFP TX Disable
224 * [11] CP1 10G SFP Mode
230 * [24] CP1 2.5G SFP TX Disable
231 * [26] CP0 10G SFP TX Fault
232 * [27] CP0 10G SFP Mode
[all …]
|
| H A D | armada-8040-clearfog-gt-8k.dts | 84 * [49] SFP+ present signal
187 /* 10G SFI SFP */
222 * [29] CP0 10G SFP TX Disable
|
| H A D | armada-388-clearfog.dts | 266 * Routed to SFP, mikrobus, and PCIe.
267 * SFP limits this to 100kHz, and requires
283 /* SFP, PCIe, mSATA, mikrobus */
|
| H A D | armada-385-turris-omnia.dts | 218 /* routed to SFP+ */
244 * GPIO expander for SFP+ signals and
|
| H A D | armada-385-atl-x530.dtsi | 204 sfpmux: mux@77 { /* SFP I2C MUX */
|
| /openbmc/bmcweb/redfish-core/include/generated/enums/ |
| H A D | cable.hpp | 39 SFP, enumerator
87 {ConnectorType::SFP, "SFP"},
|
| H A D | port.hpp | 100 SFP, enumerator
182 SFP, enumerator
282 {SFPType::SFP, "SFP"},
364 {TransceiverManagementInterfaceType::SFP, "SFP"},
|
| /openbmc/openpower-occ-control/ |
| H A D | occ_command.hpp | 52 SFP = 0x03, // Static Frequency Point (requires freqPt) enumerator
|
| H A D | occ_pass_through.cpp | 144 if (((newMode == SysPwrMode::FFO) || (newMode == SysPwrMode::SFP)) && in setMode()
|
| H A D | powermode.hpp | 381 std::set<SysPwrMode> oemModeList = {SysPwrMode::SFP, SysPwrMode::FFO,
|
| H A D | powermode.cpp | 42 ((mode == SysPwrMode::SFP) || (mode == SysPwrMode::FFO) || \
273 newMode = SysPwrMode::SFP; in convertStringToMode()
|
| /openbmc/u-boot/board/freescale/t208xrdb/ |
| H A D | README | 131 ETH0 FM1@GTEC1 fm1-mac9 0xfe4f0000 10G SFP+ (CS4315)
132 ETH1 FM1@GTEC2 fm1-mac10 0xfe4f2000 10G SFP+ (CS4315)
|
| /openbmc/u-boot/board/freescale/lx2160a/ |
| H A D | README | 21 Aquantia AQR107 phy, two 25GbE SFP+ modules connected through an Inphi
|
| /openbmc/u-boot/board/freescale/t4qds/ |
| H A D | README | 84 four Lanes A/B/C/D to a SFP+ cages, which to house fiber cable or
|
| /openbmc/u-boot/board/freescale/t208xqds/ |
| H A D | README | 90 a on-board SFP+ cages, which to house optical module (fiber cable) or
|
| /openbmc/u-boot/drivers/gpio/ |
| H A D | Kconfig | 135 SIO controller is to connect control signals from SFP
|