| /openbmc/linux/drivers/media/usb/gspca/ |
| H A D | nw80x.c | 162 #define I2C0 0xff macro
673 I2C0, 0x40, 0x02, 0x11, 0x06,
674 I2C0, 0x40, 0x02, 0x14, 0x00,
680 I2C0, 0x40, 0x02, 0x0f, 0x00,
1384 I2C0, 0x40, 0x02, 0x11, 0x06,
1385 I2C0, 0x40, 0x02, 0x14, 0x00,
1387 I2C0, 0x40, 0x02, 0x07, 0x01,
1391 I2C0, 0x40, 0x02, 0x02, 0x0c,
1392 I2C0, 0x40, 0x02, 0x13, 0x01,
1396 I2C0, 0x40, 0x02, 0x05, 0x0f,
[all …]
|
| /openbmc/linux/arch/sh/kernel/cpu/sh4/ |
| H A D | setup-sh7760.c | 26 I2C0, I2C1, enumerator
55 INTC_VECT(I2C0, 0x9c0), INTC_VECT(I2C1, 0x9e0),
90 SSI0, SSI1, HAC0, HAC1, I2C0, I2C1, USB, LCDC,
110 HAC0, HAC1, I2C0, I2C1 } },
|
| /openbmc/linux/arch/sh/kernel/cpu/sh4a/ |
| H A D | setup-sh7734.c | 315 I2C0, enumerator
393 INTC_VECT(I2C0, 0x860),
493 I2C0, /* I2C */ /* I2C 0, 1*/
515 { HPBDMAC23_25_27_28, I2C0, SRC0, SRC1 } },
|
| H A D | setup-sh7343.c | 329 DMAC0123, VIOVOU, MMC, DMAC45, FLCTL, I2C0, I2C1, SIM, USB, enumerator
374 INTC_GROUP(I2C0, I2C0_ALI, I2C0_TACKI, I2C0_WAITI, I2C0_DTEI),
414 { 0xa408001c, 0, 16, 4, /* IPRH */ { SIOF0, SIOF1, FLCTL, I2C0 } },
|
| H A D | setup-sh7786.c | 489 I2C0, I2C1, enumerator
532 INTC_VECT(I2C0, 0xcc0), INTC_VECT(I2C1, 0xce0),
606 I2C0, I2C1,
645 { 0xfe410848, 0, 32, 8, /* INT2PRI18 */ { 0, 0, I2C0, I2C1 } },
|
| H A D | setup-sh7724.c | 894 DMAC1B, DMAC0B, I2C0, I2C1, SDHI0, SDHI1, SPU, MMCIF, enumerator
1009 INTC_GROUP(I2C0, I2C0_ALI, I2C0_TACKI, I2C0_WAITI, I2C0_DTEI),
1068 I2C1, I2C0 } },
|
| /openbmc/linux/Documentation/devicetree/bindings/i2c/ |
| H A D | i2c-hix5hd2.txt | 17 I2C0@f8b10000 {
|
| /openbmc/linux/arch/arm64/boot/dts/mediatek/ |
| H A D | mt6797-x20-dev.dts | 53 /* LS - I2C0 */
|
| /openbmc/linux/arch/arm/boot/dts/intel/socfpga/ |
| H A D | socfpga_cyclone5_chameleon96.dts | 74 label = "LS-I2C0";
|
| /openbmc/linux/Documentation/devicetree/bindings/reset/ |
| H A D | nxp,lpc1850-rgu.txt | 48 48 I2C0
|
| /openbmc/u-boot/arch/arm/dts/ |
| H A D | r8a7790-lager.dts | 297 * IIC0/I2C0 is routed to EXIO connector A, pins 114 (SCL) + 116 (SDA) only.
299 * depending on the use case (e.g. DMA with IIC0 or slave support with I2C0).
301 * bus with IIC3 on pins 110 (SCL) + 112 (SDA), select I2C0 at runtime, and
305 * IIC0/I2C0 does not appear to support fallback to GPIO.
|
| H A D | armada-38x-controlcenterdc.dts | 53 i2c0 = &I2C0;
75 I2C0: i2c@11000 { label
|
| H A D | hi3798cv200-poplar.dts | 172 label = "LS-I2C0";
|
| H A D | stih410-b2260.dts | 98 label = "LS-I2C0";
|
| H A D | at91sam9x5.dtsi | 668 <AT91_PIOA 30 AT91_PERIPH_A AT91_PINCTRL_NONE /* PA30 periph A I2C0 data */
669 AT91_PIOA 31 AT91_PERIPH_A AT91_PINCTRL_NONE>; /* PA31 periph A I2C0 clock */
692 <AT91_PIOA 30 AT91_PERIPH_GPIO AT91_PINCTRL_MULTI_DRIVE /* PA30 gpio multidrive I2C0 data */
693 … AT91_PIOA 31 AT91_PERIPH_GPIO AT91_PINCTRL_MULTI_DRIVE>; /* PA31 gpio multidrive I2C0 clock */
|
| H A D | armada-8040-clearfog-gt-8k.dts | 78 * [35-38] CP0 I2C1 and I2C0
|
| H A D | armada-8040-mcbin.dts | 86 * [35-38] CP0 I2C1 and I2C0
|
| /openbmc/linux/arch/arm/boot/dts/renesas/ |
| H A D | r8a7790-lager.dts | 301 * IIC0/I2C0 is routed to EXIO connector A, pins 114 (SCL) + 116 (SDA) only.
303 * depending on the use case (e.g. DMA with IIC0 or slave support with I2C0).
305 * bus with IIC3 on pins 110 (SCL) + 112 (SDA), select I2C0 at runtime, and
309 * IIC0/I2C0 does not appear to support fallback to GPIO.
|
| /openbmc/linux/arch/arm64/boot/dts/socionext/ |
| H A D | uniphier-ld20-akebi96.dts | 141 /* LS connector I2C0 */
|
| /openbmc/linux/arch/arm64/boot/dts/hisilicon/ |
| H A D | hi3798cv200-poplar.dts | 164 label = "LS-I2C0";
|
| /openbmc/linux/Documentation/firmware-guide/acpi/ |
| H A D | non-d0-probe.rst | 71 AddressingMode7Bit, "\\_SB.PCI0.I2C0",
|
| /openbmc/linux/arch/arm/boot/dts/st/ |
| H A D | stih410-b2260.dts | 120 label = "LS-I2C0";
|
| /openbmc/linux/arch/arm/boot/dts/microchip/ |
| H A D | at91sam9x5.dtsi | 421 <AT91_PIOA 30 AT91_PERIPH_A AT91_PINCTRL_NONE /* PA30 periph A I2C0 data */
422 AT91_PIOA 31 AT91_PERIPH_A AT91_PINCTRL_NONE>; /* PA31 periph A I2C0 clock */
445 <AT91_PIOA 30 AT91_PERIPH_GPIO AT91_PINCTRL_MULTI_DRIVE /* PA30 gpio multidrive I2C0 data */
446 … AT91_PIOA 31 AT91_PERIPH_GPIO AT91_PINCTRL_MULTI_DRIVE>; /* PA31 gpio multidrive I2C0 clock */
|
| /openbmc/u-boot/doc/device-tree-bindings/pinctrl/ |
| H A D | marvell,mvebu-pinctrl.txt | 41 * I2C0 [4-5]
|
| /openbmc/u-boot/doc/driver-model/ |
| H A D | pmic-framework.txt | 50 | e.g.I2C0 | |--> LDO out N
|