| /openbmc/linux/drivers/dax/ |
| H A D | bus.c | 567 return a->mode; in dax_region_visible()
1287 return a->mode; in dev_dax_visible()
|
| /openbmc/linux/drivers/media/pci/saa7164/ |
| H A D | saa7164-core.c | 714 dev->fw_status.mode = saa7164_readl(SAA_DEVICE_SYSINIT_MODE); in saa7164_getfirmwarestatus()
723 dprintk(1, " .mode = 0x%08x\n", s->mode); in saa7164_getfirmwarestatus()
|
| /openbmc/linux/fs/exfat/ |
| H A D | namei.c | 566 struct dentry *dentry, umode_t mode, bool excl) in exfat_create() argument
848 struct dentry *dentry, umode_t mode) in exfat_mkdir() argument
|
| /openbmc/linux/drivers/net/wireless/realtek/rtw88/ |
| H A D | debug.c | 1233 #define rtw_debugfs_add_core(name, mode, fopname, parent) \ argument
1236 if (IS_ERR(debugfs_create_file(#name, mode, \
|
| /openbmc/linux/drivers/net/wireless/intel/iwlegacy/ |
| H A D | 4965.c | 1704 addsta->mode = cmd->mode; in il4965_build_addsta_hcmd()
|
| /openbmc/linux/drivers/net/wireless/mediatek/mt76/ |
| H A D | mt76x02_mac.c | 948 int mode = ht_mode & IEEE80211_HT_OP_MODE_PROTECTION; in mt76x02_mac_set_tx_protection() local
997 switch (mode) { in mt76x02_mac_set_tx_protection()
|
| /openbmc/linux/drivers/net/ieee802154/ |
| H A D | at86rf230.c | 1156 switch (cca->mode) { in at86rf230_set_cca_mode()
1464 lp->hw->phy->cca.mode = NL802154_CCA_ENERGY; in at86rf230_detect_device()
|
| /openbmc/linux/drivers/net/ethernet/mellanox/mlxsw/ |
| H A D | spectrum.h | 376 unsigned long *mode);
557 enum mlxsw_sp_hdroom_mode mode; member
|
| /openbmc/linux/drivers/net/can/ |
| H A D | xilinx_can.c | 562 static int xcan_do_set_mode(struct net_device *ndev, enum can_mode mode) in xcan_do_set_mode() argument
566 switch (mode) { in xcan_do_set_mode()
|
| /openbmc/linux/drivers/usb/serial/ |
| H A D | mos7720.c | 243 enum mos7715_pp_modes mode) in mos7715_change_mode() argument
245 mos_parport->shadowECR = mode; in mos7715_change_mode()
|
| /openbmc/linux/drivers/net/ethernet/freescale/enetc/ |
| H A D | enetc_ethtool.c | 581 rfse.mode |= ENETC_RFSE_EN; in enetc_set_cls_entry()
583 rfse.mode |= ENETC_RFSE_MODE_BD; in enetc_set_cls_entry()
|
| /openbmc/linux/fs/overlayfs/ |
| H A D | super.c | 663 const char *name, umode_t mode) in ovl_lookup_or_create() argument
672 OVL_CATTR(mode)); in ovl_lookup_or_create()
|
| /openbmc/linux/Documentation/userspace-api/ |
| H A D | seccomp_filter.rst | 46 An additional seccomp mode is added and is enabled using the same
369 kernels in vsyscall=native mode will behave differently, but the
|
| /openbmc/linux/arch/arm/boot/dts/st/ |
| H A D | ste-ux500-samsung-codina.dts | 642 zinitix,mode = <2>;
681 * R0.4 variants, GPIO130 should be set in GPIO mode and
|
| /openbmc/linux/drivers/regulator/ |
| H A D | palmas-regulator.c | 438 static int palmas_set_mode_smps(struct regulator_dev *dev, unsigned int mode) in palmas_set_mode_smps() argument
457 switch (mode) { in palmas_set_mode_smps()
|
| /openbmc/linux/drivers/iio/accel/ |
| H A D | bmc150-accel-core.c | 209 enum bmc150_power_modes mode, in bmc150_accel_set_mode() argument
233 lpw_bits = mode << BMC150_ACCEL_PMU_MODE_SHIFT; in bmc150_accel_set_mode()
|
| H A D | mma8452.c | 635 static int mma8452_set_power_mode(struct mma8452_data *data, u8 mode) in mma8452_set_power_mode() argument
645 reg |= mode << MMA8452_CTRL_REG2_MODS_SHIFT; in mma8452_set_power_mode()
|
| /openbmc/linux/arch/arm/boot/dts/ti/omap/ |
| H A D | dra74x-mmc-iodelay.dtsi | 16 * b) We keep the mode names as close to the datamanual as possible. So
17 * if the manual calls a mode, DDR50, or DDR or DDR 1.8v or DDR 3.3v,
|
| /openbmc/linux/drivers/ata/ |
| H A D | sata_fsl.c | 1499 host_priv->intr_coalescing.attr.mode = S_IRUGO | S_IWUSR; in sata_fsl_probe()
1508 host_priv->rx_watermark.attr.mode = S_IRUGO | S_IWUSR; in sata_fsl_probe()
|
| /openbmc/linux/net/ipv4/ |
| H A D | ip_tunnel.c | 599 if (unlikely(!tun_info || !(tun_info->mode & IP_TUNNEL_INFO_TX) || in ip_md_tunnel_xmit()
715 if (tun_info && (tun_info->mode & IP_TUNNEL_INFO_TX) && in ip_tunnel_xmit()
|
| /openbmc/linux/drivers/net/dsa/realtek/ |
| H A D | rtl8366rb.c | 1081 rtl8366rb_mac_link_up(struct dsa_switch *ds, int port, unsigned int mode, in rtl8366rb_mac_link_up() argument
1119 rtl8366rb_mac_link_down(struct dsa_switch *ds, int port, unsigned int mode, in rtl8366rb_mac_link_down() argument
|
| /openbmc/linux/lib/ |
| H A D | Kconfig | 93 bool "Access I/O in non-MMIO mode"
98 hosts which can not be accessed in MMIO mode. Using the logical PIO
|
| /openbmc/linux/drivers/gpu/drm/msm/disp/dpu1/ |
| H A D | dpu_kms.c | 233 void dpu_debugfs_create_regset32(const char *name, umode_t mode, in dpu_debugfs_create_regset32() argument
251 debugfs_create_file(name, mode, parent, regset, &dpu_regset32_fops); in dpu_debugfs_create_regset32()
|
| /openbmc/qemu/crypto/ |
| H A D | block-luks.c | 152 QCryptoCipherMode mode, in qcrypto_block_luks_cipher_name_lookup() argument
161 if (mode == QCRYPTO_CIPHER_MODE_XTS) { in qcrypto_block_luks_cipher_name_lookup()
|
| /openbmc/linux/drivers/gpu/drm/amd/display/dc/link/protocols/ |
| H A D | link_dp_training.c | 894 link->dpcd_caps.lttpr_caps.mode = repeater_mode; in configure_lttpr_mode_non_transparent()
908 link->dpcd_caps.lttpr_caps.mode = repeater_mode; in configure_lttpr_mode_non_transparent()
|