| /openbmc/linux/Documentation/devicetree/bindings/iommu/ |
| H A D | arm,smmu-v3.yaml | 14 The SMMUv3 architecture is a significant departure from previous
21 pattern: "^iommu@[0-9a-f]*"
37 hardware supports just a single, combined interrupt line.
|
| /openbmc/linux/drivers/scsi/ |
| H A D | wd33c93.h | 27 #define DB(f,a) if (hostdata->args & (f)) a; argument
29 #define DB(f,a) argument
|
| /openbmc/linux/Documentation/devicetree/bindings/media/i2c/ |
| H A D | dongwoon,dw9768.yaml | 14 The Dongwoon DW9768 is a single 10-bit digital-to-analog (DAC) converter
16 a linear mode driver. The DAC is controlled via a 2-wire (I2C-compatible)
|
| /openbmc/linux/arch/arm/boot/dts/allwinner/ |
| H A D | sun5i-r8.dtsi | 9 * licensing only applies to this file, and not this project as a
12 * a) This file is free software; you can redistribute it and/or
25 * obtaining a copy of this software and associated documentation
|
| /openbmc/linux/Documentation/devicetree/bindings/arm/ |
| H A D | arm,coresight-dynamic-funnel.yaml | 17 specification and can be connected in various topologies to suit a particular
23 The Coresight funnel merges 2-8 trace sources into a single trace
26 # Need a custom select here or 'arm,primecell' will match on lots of nodes
|
| H A D | arm,coresight-stm.yaml | 17 specification and can be connected in various topologies to suit a particular
23 The STM is a trace source that is integrated into a CoreSight system, designed
|
| /openbmc/linux/Documentation/devicetree/bindings/display/mediatek/ |
| H A D | mediatek,gamma.yaml | 14 Mediatek display gamma correction, namely GAMMA, provides a nonlinear
17 For a description of the MMSYS_CONFIG binding, see
57 register offset and size. Each GCE subsys id is mapping to a client
|
| /openbmc/linux/Documentation/dev-tools/kunit/ |
| H A D | run_manual.rst | 11 .. note:: KUnit is not designed for use in a production system. It is
28 ending in ``_KUNIT_TEST``. Most tests can either be built as a module,
35 a good way of quickly testing everything applicable to the current
|
| /openbmc/linux/Documentation/devicetree/bindings/display/ |
| H A D | arm,komeda.yaml | 15 to a 4K resolution each. Each pipeline can be composed of up to four
16 layers. It is typically connected to a digital display connector like HDMI.
48 Phandle to a node describing memory to be used for the framebuffer.
|
| /openbmc/linux/Documentation/devicetree/bindings/display/bridge/ |
| H A D | fsl,imx8qxp-pixel-combiner.yaml | 13 The Freescale i.MX8qm/qxp Pixel Combiner takes two output streams from a
14 single display controller and manipulates the two streams to support a number
47 description: Represents a display stream of pixel combiner.
|
| /openbmc/linux/Documentation/devicetree/bindings/spi/ |
| H A D | st,stm32-spi.yaml | 63 "^[a-zA-Z][a-zA-Z0-9,+\\-._]{0,63}@[0-9a-f]+$":
|
| /openbmc/linux/Documentation/devicetree/bindings/mux/ |
| H A D | reg-mux.yaml | 14 device tree node must be a device node to provide register r/w access.
33 description: Each entry pair describes a single mux control.
46 /* The parent device of mux controller is not a syscon device. */
|
| /openbmc/linux/Documentation/devicetree/bindings/net/ |
| H A D | nxp,dwmac-imx.yaml | 14 # We need a select here so we don't match all nodes with 'snps,dwmac'
37 - const: snps,dwmac-5.10a
88 compatible = "nxp,imx8mp-dwmac-eqos","snps,dwmac-5.10a";
|
| /openbmc/linux/Documentation/devicetree/bindings/mfd/ |
| H A D | brcm,bcm6358-gpio-sysctl.yaml | 14 Broadcom BCM6358 SoC GPIO system controller which provides a register map
35 "^gpio@[0-9a-f]+$":
44 "^pinctrl@[0-9a-f]+$":
|
| /openbmc/linux/Documentation/devicetree/bindings/net/dsa/ |
| H A D | microchip,ksz.yaml | 18 # See Documentation/devicetree/bindings/net/dsa/dsa.yaml for a list of additional
38 Should be a gpio specifier for a reset line.
|
| /openbmc/linux/usr/ |
| H A D | gen_initramfs.sh | 21 <uid> is only meaningful if <cpio_source> is a
24 <gid> is only meaningful if <cpio_source> is a
28 If <cpio_source> is a .cpio file it will be used
|
| /openbmc/linux/Documentation/devicetree/bindings/hwmon/ |
| H A D | ti,tmp513.yaml | 15 that include remote sensors, a local temperature sensor, and a high-side
40 If not, it's not possible to compute a valid calibration value.
|
| /openbmc/linux/Documentation/devicetree/bindings/mmc/ |
| H A D | aspeed,sdhci.yaml | 17 only a single slot is enabled.
19 The two slots are supported by a common configuration area. As the SDHCIs for
42 "^sdhci@[0-9a-f]+$":
|
| /openbmc/linux/Documentation/devicetree/bindings/display/panel/ |
| H A D | sharp,lq101r1sx01.yaml | 13 This panel requires a dual-channel DSI host to operate. It supports two modes:
17 Each of the DSI channels controls a separate DSI peripheral. The peripheral
19 peripheral and controls the device. The 'link2' property contains a phandle
|
| /openbmc/linux/Documentation/translations/zh_CN/core-api/ |
| H A D | local_ops.rst | 58 typedef struct { atomic_long_t a; } local_t;
150 /* Increment the counter from a non preemptible context */
154 /* This is what incrementing the variable would look like within a
|
| /openbmc/linux/arch/arm/boot/dts/nxp/imx/ |
| H A D | imx6dl-sabrelite.dts | 7 * licensing only applies to this file, and not this project as a
10 * a) This file is free software; you can redistribute it and/or
22 * obtaining a copy of this software and associated documentation
|
| H A D | imx6dl-tx6u-811x.dts | 6 * licensing only applies to this file, and not this project as a
9 * a) This file is free software; you can redistribute it and/or
21 * obtaining a copy of this software and associated documentation
|
| H A D | imx6dl-tx6s-8035-mb7.dts | 6 * licensing only applies to this file, and not this project as a
9 * a) This file is free software; you can redistribute it and/or
21 * obtaining a copy of this software and associated documentation
|
| H A D | imx6dl-tx6u-81xx-mb7.dts | 6 * licensing only applies to this file, and not this project as a
9 * a) This file is free software; you can redistribute it and/or
21 * obtaining a copy of this software and associated documentation
|
| /openbmc/linux/fs/sysv/ |
| H A D | Kconfig | 15 a set of kernel modules that lets you run SCO, Xenix, Wyse,
26 Note that this option is generally not needed for floppies, since a
35 To compile this as a module, choose M here: the module will be called
|