Home
last modified time | relevance | path

Searched refs:RAM (Results 101 – 125 of 670) sorted by relevance

12345678910>>...27

/openbmc/openbmc/meta-nuvoton/
H A DREADME.md5 The NPCM7XX is an ARM based SoC with external DDR RAM and
/openbmc/u-boot/doc/
H A DREADME.arm-relocation53 d) this initialize CPU, RAM, ... and copy itself to RAM
92 - This u-boot does no RAM init, nor CPU register setup. Just look
106 Debugging u-boot in RAM:
H A DREADME.distro218 Mandatory. The location in RAM where the DTB will be loaded or copied to when
229 Mandatory. The location in RAM where the initial ramdisk will be loaded to
232 It is recommended that this location be highest in RAM out of fdt_addr_,
233 kernel_addr_r, and ramdisk_addr_r, so that the RAM disk can vary in size
234 and use any available RAM.
238 Mandatory. The location in RAM where the kernel will be loaded to when
241 The kernel should be located within the first 128M of RAM in order for the
244 start of RAM, kernel_addr_r should not overlap that area, or the kernel will
251 Mandatory. The location in RAM where extlinux.conf will be loaded to prior
259 location in RAM where boot.scr will be loaded to prior to execution.
H A DREADME.ext462 3. To read and load a file from an ext4-formatted partition to RAM, run:
71 a) First load a file to RAM at a particular address for example 0x30007fc0.
/openbmc/linux/drivers/mtd/devices/
H A DKconfig7 tristate "Ramix PMC551 PCI Mezzanine RAM card support"
10 This provides a MTD device driver for the Ramix PMC551 RAM PCI card
124 tristate "Uncached system RAM"
131 tristate "Physical system RAM"
140 tristate "Test driver using RAM"
/openbmc/u-boot/drivers/ram/stm32mp1/
H A DKconfig5 select RAM
/openbmc/linux/Documentation/networking/
H A Darcnet-hardware.rst623 7-8: RAM Offset Select
676 Switch | Hex RAM | Hex ROM
1107 Switches RAM ROM
1653 Switch | Hex RAM | Hex ROM
1827 | | | | RAM | | UFS | |
1857 RAM 2k of SRAM
1918 Switch | Hex RAM
2497 7-8: RAM Offset Select
2578 Switch | Hex RAM | Hex ROM
2772 Switch | Hex RAM | Hex ROM
[all …]
/openbmc/qemu/docs/system/ppc/
H A Dprep.rst17 * PREP Non Volatile RAM
/openbmc/u-boot/lib/lzma/
H A Dlzma.txt177 Also Benchmark checks possible hardware errors (RAM
194 size D = 2^N you need about D bytes of memory (RAM).
352 When to use: RAM->RAM decompressing
458 For example, you can use Large RAM Pages (2 MB) in allocBig allocator for
460 Large RAM Pages.
534 Single-call RAM->RAM Compression
537 Single-call RAM->RAM Compression is similar to Compression with callbacks,
/openbmc/linux/Documentation/devicetree/bindings/pci/
H A Dintel,ixp4xx-pci.yaml44 the RAM is at. It can map only 64MB so if the RAM is bigger
/openbmc/linux/Documentation/devicetree/bindings/display/
H A Dbrcm,bcm2711-hdmi.yaml24 - description: Packet RAM register range
25 - description: Metadata RAM register range
/openbmc/linux/fs/cramfs/
H A DKconfig20 purpose to remain small and low on RAM usage. It is most suitable
21 for small embedded systems. If you have ample RAM to spare, you may
/openbmc/linux/Documentation/translations/zh_CN/mm/
H A Dovercommit-accounting.rst26 不超量使用。系统提交的总地址空间不允许超过swap+一个可配置的物理RAM的数量
/openbmc/linux/arch/arm64/boot/dts/freescale/
H A Ds32g274a-evb.dts23 /* 4GiB RAM */
/openbmc/u-boot/arch/arm/mach-rockchip/
H A Drk3036-board.c38 #if !CONFIG_IS_ENABLED(RAM)
/openbmc/linux/arch/arm64/boot/dts/qcom/
H A Dsdm630-sony-xperia-ganges-kirin.dts24 /* Reserve a bigger chunk of RAM for the higher-res display */
/openbmc/linux/fs/configfs/
H A DKconfig6 configfs is a RAM-based filesystem that provides the converse
/openbmc/u-boot/arch/arm/mach-aspeed/ast2400/
H A DKconfig15 It has 512M of RAM, 32M of SPI flash, two Ethernet ports,
/openbmc/u-boot/arch/arm/mach-aspeed/ast2500/
H A DKconfig15 It has 512M of RAM, 32M of SPI flash, two Ethernet ports,
/openbmc/u-boot/arch/x86/cpu/tangier/
H A DKconfig27 Space in bytes in eSRAM used as Cache-As-RAM (CAR).
/openbmc/linux/arch/arm64/boot/dts/amlogic/
H A Dmeson-axg-jethome-jethub-j110-rev-3.dts16 /* 2GiB or 4GiB RAM */
/openbmc/linux/Documentation/ABI/testing/
H A Dsysfs-driver-w1_therm26 * 'save': save device RAM to EEPROM
27 * 'restore': restore EEPROM data in device RAM
53 will be changed only in device RAM, so it will be cleared when
101 * '9..14' : set the device resolution in RAM
/openbmc/linux/Documentation/devicetree/bindings/mfd/
H A Dstericsson,db8500-prcmu.yaml183 description: Embedded Static RAM (ESRAM) 1 and 2 voltage regulator.
189 description: Embedded Static RAM (ESRAM) 1 and 2 voltage regulator for
196 description: Embedded Static RAM (ESRAM) 3 and 4 voltage regulator.
202 description: Embedded Static RAM (ESRAM) 3 and 4 voltage regulator for
/openbmc/qemu/docs/
H A Dmulti-thread-compression.txt20 compress the RAM page before sending; after receiving, the data will
61 RAM: 128G
90 to RAM block areas periodically.
/openbmc/linux/Documentation/hid/
H A Dhid-alps.rst67 To read/write to RAM, need to send a command to the device.
85 Address is read/write RAM address.
89 When you read RAM, there is no meaning.

12345678910>>...27