| /openbmc/linux/Documentation/devicetree/bindings/pwm/ |
| H A D | pwm-rockchip.yaml | 7 title: Rockchip PWM controller
|
| H A D | pwm-tipwmss.txt | 1 TI SOC based PWM Subsystem
|
| H A D | allwinner,sun4i-a10-pwm.yaml | 7 title: Allwinner A10 PWM
|
| /openbmc/linux/Documentation/devicetree/bindings/display/bridge/ |
| H A D | parade,ps8622.yaml | 28 description: Backlight will be controlled by an external PWM.
|
| /openbmc/linux/arch/arm/boot/dts/ti/omap/ |
| H A D | twl6030.dtsi | 95 /* provides one PWM (id 0 for Charging indicator LED) */
|
| /openbmc/linux/Documentation/devicetree/bindings/iio/proximity/ |
| H A D | parallax-ping.yaml | 16 for receiving distance value as PWM signal
|
| /openbmc/linux/Documentation/devicetree/bindings/reset/ |
| H A D | nxp,lpc1850-rgu.txt | 39 38 Motor control PWM (MCPWM)
|
| /openbmc/linux/Documentation/devicetree/bindings/leds/ |
| H A D | leds-aw2013.yaml | 14 LED brightness with PWM output.
|
| H A D | leds-lm36274.txt | 6 the I2C bus and/or controlled via a logic level PWM input from 60 uA to 30 mA.
|
| /openbmc/linux/Documentation/devicetree/bindings/power/supply/ |
| H A D | richtek,rt9467.yaml | 15 portable applications. It integrates a synchronous PWM controller, power
|
| /openbmc/linux/Documentation/hwmon/ |
| H A D | max6639.rst | 22 temperature monitor with dual PWM fan speed controller. It can monitor its own
|
| H A D | mp2888.rst | 26 - PWM-VID Interface
|
| H A D | w83627ehf.rst | 139 this file stores PWM duty cycle or DC value (fan speed) in range:
164 controls if output is PWM or DC level
167 * 1 PWM output
|
| /openbmc/linux/arch/arm/boot/dts/nxp/imx/ |
| H A D | imx6ull-dhcor-som.dtsi | 103 regulator-allowed-modes = <DA9063_BUCK_MODE_SYNC>; /* PWM */
119 regulator-allowed-modes = <DA9063_BUCK_MODE_SYNC>; /* PWM */
|
| H A D | imx6qdl-colibri.dtsi | 614 /* Colibri PWM<B> */
621 /* Colibri PWM<D> */
628 /* Colibri PWM<A> */
635 /* Colibri PWM<C> */
912 /* Disable PWM pins on camera interface */
|
| /openbmc/u-boot/drivers/pinctrl/mscc/ |
| H A D | pinctrl-ocelot.c | 109 MSCC_P(21, RECO_CLK1, PWM, NONE);
|
| H A D | pinctrl-luton.c | 82 MSCC_P(29, PWM, NONE, NONE);
|
| /openbmc/phosphor-hwmon/ |
| H A D | targets.hpp | 20 PWM enumerator
|
| /openbmc/linux/arch/arm64/boot/dts/rockchip/ |
| H A D | rk3399-nanopc-t4.dts | 59 * With 20KHz PWM and an EVERCOOL EC4007H12SA fan, these levels
|
| /openbmc/u-boot/arch/arm/dts/ |
| H A D | exynos5250-spring.dts | 639 * [6]PWM function control by DPCD0040f[7], default
640 * is PWM block always works
663 0x01 0xa5 0xa0 /* DPCD720, Select internal PWM */
665 * 0xff for 100% PWM of brightness, 0h for 0% brightness
|
| /openbmc/linux/Documentation/devicetree/bindings/pinctrl/ |
| H A D | renesas,rzg2l-poeg.yaml | 13 The output pins(GTIOCxA and GTIOCxB) of the general PWM timer (GPT) can be
|
| /openbmc/linux/Documentation/devicetree/bindings/display/ |
| H A D | atmel,lcdc.txt | 60 - atmel,lcdcon-backlight-inverted: invert backlight PWM polarity
|
| /openbmc/linux/Documentation/devicetree/bindings/mfd/ |
| H A D | st,stm32-lptimer.yaml | 12 - PWM output (with programmable prescaler, configurable polarity)
|
| /openbmc/phosphor-pid-control/ |
| H A D | configure.md | 22 failsafe mode, even when the calculated PWM is higher than failsafe PWM. Without
23 this enabled, the PWM is calculated and set to the calculated PWM **or** the
24 failsafe PWM, whichever is higher.
|
| /openbmc/linux/Documentation/devicetree/bindings/sound/ |
| H A D | cs35l33.txt | 29 begins to when the amplifier disables the PWM outputs. If this property
61 - cirrus,ldo-thld : Configures the signal threshold at which the PWM output
|