Searched full:xmii (Results 1 – 18 of 18) sorted by relevance
53 xMII Params yes no416 0 xMII xMII xMII417 1 xMII xMII xMII418 2 xMII xMII xMII419 3 xMII xMII xMII420 4 xMII xMII SGMII432 2 xMII xMII xMII xMII434 3 xMII xMII xMII
411 can make it harder to debug MDIO switch connected using xMII interfaces
154 /* 3 - xMII */
666 /* xMII configuration */
1182 /* 3 - xMII */
1048 /* Read from XMII register to determine host port in ksz9477_config_cpu_port()
20 /* For the LAN9303 and LAN9354, only port 0 is an XMII port. */1337 * this is the xMII port. All other ports are 10/100 phys using MDIO in lan9303_phylink_mac_link_up()
862 /* Disable the xMII interface and clear it's isolation bit */ in gswip_setup()
456 dev_err(priv->dev, "xMII interface %d not supported\n", in mt7530_pad_clk_setup()
275 /* This is an external PHY (xMII), so we need to enable the RGMII in bcmgenet_mii_config()
121 * Override Ports 0-7 State on devices with xMII interfaces (8 bit)
257 /* Discard previous xMII Mode Parameters Table */ in sja1105_init_mii_settings()1414 * config (the xMII Mode table cannot be dynamically in sja1105_phylink_get_caps()3078 * but not the xMII mode parameters table.3086 * can populate the xMII mode parameters table.
494 /* Ports 2 and 3 are capable of xMII, but there isn't anything to
1007 "xmii-table is missing",
491 printf("error: xMII mode %d not supported\n", mode); in mt7530_pad_clk_setup()
440 if (fec->xcv_type != SEVENWIRE) /* xMII modes */ in fec_reg_setup()
1563 /* Configure the PHY to stop receiving xMII in phy_init_eee()
1386 dev_err(ds->dev, "xMII mode %s not supported for port %d\n", in qca8k_phylink_mac_config()