| /openbmc/linux/drivers/net/ethernet/mellanox/mlxsw/ |
| H A D | Kconfig | 54 tristate "Mellanox Technologies Spectrum family support"
70 Spectrum/Spectrum-2/Spectrum-3/Spectrum-4 Ethernet Switch ASICs.
|
| H A D | spectrum_acl_bloom_filter.c | 10 #include "spectrum.h"
20 * blocks, eRP ID and region ID. In Spectrum-2 and above, region key is combined
31 /* Spectrum-2 and Spectrum-3 chunks */
57 * Spectrum-{2-3}. It is computed, Msbit first, for the Bloom filter
96 /* Spectrum-4 chunks */
99 /* In Spectrum-4, there is no padding. Each chunk size is 20 bytes.
122 /* For Spectrum-4, two hash functions are used, CRC-10 and CRC-6 based.
129 * Spectrum-4. It is computed, Msbit first, for the Bloom filter
168 * Spectrum-4. It is computed, Msbit first, for the Bloom filter
208 * key. The original keys layout is same for Spectrum-{2,3,4}.
[all …]
|
| H A D | spectrum_nve.h | 10 #include "spectrum.h"
33 u16 ul_rif_index; /* Reserved for Spectrum */
|
| H A D | cmd.h | 341 * Reserved on SwitchX/-2, Switch-IB/2, Spectrum-1
354 * Reserved on SwitchX/-2, Switch-IB/2, Spectrum-1
706 * Reserved when Spectrum-1/2/3, supported from Spectrum-4 and above.
707 * For Spectrum-4, firmware sets 128 for values between 1-128 and 256 for values
845 * Valid for Spectrum only
852 * Valid for Spectrum only
861 * Valid for Spectrum only
900 * Reserved when SwitchX/-2, Switch-IB/2 and Spectrum-1.
904 * Reserved when SwitchX/2, Switch-IB/2 and Spectrum-1.
912 * Reserved when SwitchX/-2, Switch-IB/2 and Spectrum-1.
|
| H A D | spectrum_mr_tcam.h | 7 #include "spectrum.h"
|
| H A D | spectrum_acl_flex_actions.h | 7 #include "spectrum.h"
|
| H A D | spectrum_cnt.h | 8 #include "spectrum.h"
|
| H A D | reg.h | 88 * Note: Must be set for Spectrum.
320 * For Spectrum-2 when set_vid=0 and smpe_valid=1, the smpe will modify the vid.
334 * For Spectrum: use FID for both Dynamic and Static entries.
400 * For Spectrum-2 when set_vid=0 and smpe_valid=1, the smpe will modify the vid.
414 * For Spectrum: use FID for both Dynamic and Static entries.
459 * For Spectrum this value must be set to 0x1FFF
739 * Reserved on Spectrum.
815 * Reserved when SwitchX/-2 or Spectrum-1.
837 * Reserved when Spectrum-1.
847 * 2: ether_type2 - Reserved when Spectrum-1, supported by Spectrum-2
[all …]
|
| /openbmc/linux/Documentation/devicetree/bindings/clock/ |
| H A D | ti,cdce925.yaml | 58 spectrum clocking parameters for a board
63 spread-spectrum:
67 spread-spectrum-center:
99 spread-spectrum = <4>;
100 spread-spectrum-center;
|
| H A D | mediatek,mt8186-fhctl.yaml | 7 title: MediaTek frequency hopping and spread spectrum clocking control
15 Spread spectrum clocking (SSC) is another function provided by this hardware.
35 description: The percentage of spread spectrum clocking for one PLL.
|
| /openbmc/linux/Documentation/devicetree/bindings/clock/ti/ |
| H A D | dpll.txt | 45 "ssc-deltam" - DPLL supports spread spectrum clocking (SSC), contains
47 "ssc-modfreq" - DPLL supports spread spectrum clocking (SSC), contains
61 - ti,ssc-deltam : DPLL supports spread spectrum clocking, frequency
63 - ti,ssc-modfreq-hz : DPLL supports spread spectrum clocking, spread
64 spectrum modulation frequency
65 - ti,ssc-downspread : DPLL supports spread spectrum clocking, boolean
|
| /openbmc/linux/drivers/media/dvb-frontends/ |
| H A D | cxd2820r.h | 35 * @spec_inv: Input spectrum inverted.
60 * @spec_inv: Spectrum inversion. Default: 0. Values: 0, 1.
89 /* Spectrum inversion.
|
| H A D | m88ds3103.h | 54 * @spec_inv: Input spectrum inversion.
99 * @spec_inv: Spectrum inversion. Default: 0.
|
| /openbmc/linux/Documentation/ABI/testing/ |
| H A D | sysfs-platform-dptf | 134 (RO) Presents SSC (spread spectrum clock) information for EMI
140 [7:0] Sets clock spectrum spread percentage:
147 spectrum clock
153 (Spread spectrum clock) range
|
| /openbmc/linux/tools/testing/selftests/drivers/net/mlxsw/spectrum/ |
| H A D | q_in_vni_veto.sh | 48 check_fail $? "802.1ad bridge with VxLAN in Spectrum-1 not rejected"
52 check_err $? "802.1ad bridge with VxLAN in Spectrum-1 rejected without extack"
|
| /openbmc/linux/Documentation/driver-api/thermal/ |
| H A D | intel_dptf.rst | 204 which is compensated by adjusting Spread spectrum percent. This helps
231 Set the FIVR spread spectrum clocking percentage
234 Enable/disable of the FIVR spread spectrum clocking feature
299 Sets DLVR spread spectrum percent value.
302 Specifies how frequencies are spread using spread spectrum.
|
| /openbmc/linux/tools/testing/selftests/drivers/net/mlxsw/ |
| H A D | mlxsw_lib.sh | 21 echo "Couldn't determine Spectrum chip revision." \
45 log_test_skip $src:$caller "(Spectrum-$rev only)"
|
| H A D | qos_max_descriptors.sh | 64 # 200Mbps. On Spectrum-2, writing a value close to zero instead of zero works
65 # well, but the performance on Spectrum-1 is unpredictable. Thus, do not run the
66 # test on Spectrum-1.
|
| H A D | tc_sample.sh | 434 # Output traffic class is not supported on Spectrum-1.
480 # Output traffic class occupancy is not supported on Spectrum-1.
524 # Egress sampling not supported on Spectrum-1.
553 # Policy-based sampling is not supported on Spectrum-1.
582 # Policy-based sampling is not supported on Spectrum-1.
634 # Policy-based sampling is not supported on Spectrum-1.
|
| /openbmc/linux/Documentation/devicetree/bindings/ata/ |
| H A D | imx-sata.yaml | 57 fsl,no-spread-spectrum:
59 description: if present, disable spread-spectrum clocking on the SATA link.
|
| /openbmc/linux/Documentation/misc-devices/ |
| H A D | apds990x.rst | 26 might vary quite much depending the spectrum of the light source.
69 on the light spectrum etc.
|
| /openbmc/linux/drivers/gpu/drm/amd/pm/swsmu/inc/pmfw_if/ |
| H A D | smu11_driver_if_sienna_cichlid.h | 906 // SECTION: Clock Spread Spectrum
908 // GFXCLK PLL Spread Spectrum
913 // GFXCLK DFLL Spread Spectrum
918 // UCLK Spread Spectrum
922 // FCLK Spread Spectrum
949 // UCLK Spread Spectrum
1267 // SECTION: Clock Spread Spectrum
1269 // GFXCLK PLL Spread Spectrum
1274 // GFXCLK DFLL Spread Spectrum
1279 // UCLK Spread Spectrum
[all …]
|
| /openbmc/linux/drivers/gpu/drm/amd/display/dc/clk_mgr/dce120/ |
| H A D | dce120_clk_mgr.c | 48 * dce121_clock_patch_xgmi_ss_info() - Save XGMI spread spectrum info
51 * Reads from VBIOS the XGMI spread spectrum info and saves it within
|
| /openbmc/linux/sound/soc/codecs/ |
| H A D | tda7419.c | 451 SOC_ENUM("Spectrum Analyzer Q Factor", soc_enum_sa_q_factor),
452 SOC_ENUM("Spectrum Analyzer Reset Mode", soc_enum_reset_mode),
453 SOC_ENUM("Spectrum Analyzer Source", soc_enum_sa_src),
454 SOC_SINGLE("Spectrum Analyzer Run Switch", TDA7419_SA_CLK_AC_REG,
456 SOC_SINGLE("Spectrum Analyzer Reset Switch", TDA7419_SA_CLK_AC_REG,
|
| /openbmc/linux/drivers/phy/starfive/ |
| H A D | phy-jh7110-pcie.c | 65 /* Configuare spread-spectrum mode: down-spread-spectrum */ in phy_usb3_mode_set()
|