Home
last modified time | relevance | path

Searched full:nominal (Results 1 – 25 of 313) sorted by relevance

12345678910>>...13

/openbmc/linux/Documentation/devicetree/bindings/phy/
H A Dphy-stm32-usbphyc.yaml125 - <0> = 18.87 mA target current / nominal + 0%
126 - <1> = 19.165 mA target current / nominal + 1.56%
127 - <2> = 19.46 mA target current / nominal + 3.12%
128 - <3> = 19.755 mA target current / nominal + 4.68%
129 - <4> = 20.05 mA target current / nominal + 6.24%
130 - <5> = 20.345 mA target current / nominal + 7.8%
131 - <6> = 20.64 mA target current / nominal + 9.36%
132 - <7> = 20.935 mA target current / nominal + 10.92%
133 - <8> = 21.23 mA target current / nominal + 12.48%
134 - <9> = 21.525 mA target current / nominal + 14.04%
[all …]
H A Dfsl,imx8mq-usb-phy.yaml40 Tunes the HS DC level relative to the nominal level
47 its nominal value
67 relative to the nominal value
73 Adjust TX de-emphasis attenuation in dB at nominal
H A Dapm-xgene-phy.txt23 data earlier than the nominal sampling point. 1 means
24 sample data later than the nominal sampling point.
/openbmc/linux/drivers/memory/tegra/
H A Dtegra210-emc-table.c32 /* only the nominal and derated tables are expected */ in tegra210_emc_table_device_init()
38 if (emc->nominal) { in tegra210_emc_table_device_init()
40 dev_warn(dev, "%u derated vs. %u nominal entries\n", in tegra210_emc_table_device_init()
49 emc->nominal = timings; in tegra210_emc_table_device_init()
65 if ((emc->nominal && timings != emc->nominal) && in tegra210_emc_table_device_release()
/openbmc/phosphor-dbus-interfaces/yaml/xyz/openbmc_project/Inventory/Item/
H A DRotor.interface.yaml10 The nominal voltage of the fan in mV.
15 The nominal maximum current of the fan in mA.
20 The nominal speed of the fan in RPMs.
/openbmc/linux/drivers/cpufreq/
H A Dpowernv-cpufreq.c150 * max, min and nominal frequencies. It also stores number of
153 * powernv_pstate_info.nominal indicates the index to the highest
159 unsigned int nominal; member
181 * corresponding to the nominal frequency.
187 return powernv_freqs[powernv_pstate_info.nominal].driver_data; in idx_to_pstate()
199 * this will return the index of the nominal
213 return powernv_pstate_info.nominal; in pstate_to_idx()
257 if (of_property_read_u32(power_mgt, "ibm,pstate-nominal", in init_powernv_pstates()
259 pr_warn("ibm,pstate-nominal not found\n"); in init_powernv_pstates()
281 pr_info("cpufreq pstate min 0x%x nominal 0x%x max 0x%x\n", pstate_min, in init_powernv_pstates()
[all …]
H A Dpcc-cpufreq.c88 u32 nominal; member
175 curr_freq = (((ioread32(&pcch_hdr->nominal) * (output_buffer & 0xff)) in pcc_get_freq()
222 / (ioread32(&pcch_hdr->nominal) * 1000)) << 8); in pcc_cpufreq_target()
462 " status field: 0x%x, nominal latency: %d us\n", in pcc_cpufreq_evaluate()
471 " nominal CPU frequency: %d MHz," in pcc_cpufreq_evaluate()
476 ioread32(&pcch_hdr->nominal), in pcc_cpufreq_evaluate()
528 ioread32(&pcch_hdr->nominal)); in pcc_cpufreq_evaluate()
555 ioread32(&pcch_hdr->nominal) * 1000; in pcc_cpufreq_cpu_init()
/openbmc/linux/Documentation/hwmon/
H A Dsmsc47m192.rst44 Voltages are scaled such that the nominal voltage corresponds to
46 each voltage channel is 0V ... 255/192*(nominal voltage), the resolution
47 is 1 bit per (nominal voltage)/192.
68 in1_input CPU voltage input (nominal 2.25V)
72 in5_input Vcc voltage input (nominal 3.3V)
/openbmc/linux/drivers/gpu/drm/amd/display/modules/freesync/
H A Dfreesync.c138 /* v_total cannot be less than nominal */ in mod_freesync_calc_v_total_from_refresh()
173 /* v_total cannot be less than nominal */ in calc_v_total_from_duration()
248 /* v_total cannot be less than nominal */ in update_v_total_for_static_ramp()
606 // For v1 & 2 infoframes program nominal if non-fs mode, otherwise full range in build_vrr_infopacket_data_v1()
673 max_refresh; // Non-fs case, program nominal range in build_vrr_infopacket_data_v3()
677 max_refresh;// Non-fs case, program nominal range in build_vrr_infopacket_data_v3()
1002 /* Calculate nominal field rate for stream */ in mod_freesync_build_vrr_params()
1015 /* Full range may be larger than current video timing, so cap at nominal */ in mod_freesync_build_vrr_params()
1019 /* Full range may be larger than current video timing, so cap at nominal */ in mod_freesync_build_vrr_params()
1023 /* If a monitor reports exactly max refresh of 2x of min, enforce it on nominal */ in mod_freesync_build_vrr_params()
[all …]
/openbmc/linux/Documentation/devicetree/bindings/ata/
H A Dceva,ahci-1v84.yaml48 - description: CIBGN - COMINIT Burst Gap Nominal.
61 - description: CWBGN - COMWAKE Burst Gap Nominal.
72 - description: BNM - COM Burst Nominal.
94 - description: CIBGN - COMINIT Burst Gap Nominal.
107 - description: CWBGN - COMWAKE Burst Gap Nominal.
118 - description: BNM - COM Burst Nominal.
/openbmc/bmcweb/redfish-core/schema/dmtf/csdl/
H A DCircuit_v1.xml186 <Annotation Term="OData.Description" String="AC 100-127V nominal."/>
187 …LongDescription" String="This value shall indicate the device supports a nominal voltage in the co…
198 <Annotation Term="OData.Description" String="AC 100-240V nominal."/>
199 …LongDescription" String="This value shall indicate the device supports a nominal voltage in the co…
202 <Annotation Term="OData.Description" String="AC 100-277V nominal."/>
203 …LongDescription" String="This value shall indicate the device supports a nominal voltage in the co…
206 <Annotation Term="OData.Description" String="AC 120V nominal."/>
207 …LongDescription" String="This value shall indicate the device supports a nominal voltage of 120VAC…
210 <Annotation Term="OData.Description" String="AC 200-240V nominal."/>
211 …LongDescription" String="This value shall indicate the device supports a nominal voltage in the co…
[all …]
/openbmc/u-boot/arch/x86/cpu/intel_common/
H A Dcpu.c82 /* Use nominal TDP ratio for flex ratio */ in cpu_set_flex_ratio_to_tdp_nominal()
86 /* See if flex ratio is already set to nominal TDP ratio */ in cpu_set_flex_ratio_to_tdp_nominal()
90 /* Set flex ratio to nominal TDP ratio */ in cpu_set_flex_ratio_to_tdp_nominal()
/openbmc/linux/Documentation/userspace-api/media/v4l/
H A Dext-ctrls-colorimetry.rst25 The Content Light Level defines upper bounds for the nominal target
88 - Specifies the nominal maximum display luminance of the mastering
92 - specifies the nominal minimum display luminance of the mastering
/openbmc/linux/Documentation/userspace-api/media/drivers/
H A Dimx-uapi.rst42 intervals (elapsed time between two EOF's) drop below the nominal
67 the nominal frame interval reported by the sensor. This can reduce noise
72 If the averaged intervals fall outside nominal by this amount, in
/openbmc/linux/Documentation/admin-guide/pm/
H A Dcpufreq_drivers.rst170 a percentage of the nominal (ie: maximum) CPU frequency. The output buffer
245 nominal frequency from the BIOS, sometimes, the values displayed by
251 In this example, the nominal frequency is 2933 MHz. The driver obtains the
252 current frequency, cpuinfo_cur_freq, as 54% of the nominal frequency:
256 Nominal frequency is the maximum frequency of the processor, and it usually
/openbmc/linux/drivers/staging/media/imx/
H A Dimx-media-fim.c65 unsigned long nominal; /* usec */ member
85 fim->nominal = DIV_ROUND_CLOSEST_ULL(1000000ULL * (u64)fi->numerator, in update_fim_nominal()
88 dev_dbg(fim->sd->dev, "FI=%lu usec\n", fim->nominal); in update_fim_nominal()
142 * from the nominal frame rate, send the frame interval error event. The
158 error = abs(interval - NSEC_PER_USEC * (u64)fim->nominal); in frame_interval_monitor()
/openbmc/linux/Documentation/devicetree/bindings/sound/
H A Dcs35l32.txt39 - cirrus,battery-recovery : Low battery nominal recovery threshold, rising VP.
45 - cirrus,battery-threshold : Low battery nominal threshold, falling VP.
/openbmc/bmcweb/redfish-core/schema/dmtf/json-schema/
H A DPowerDistribution.v1_4_0.json591 …"description": "The frequency in hertz units over the nominal value that satisfies a criterion for…
592 …ion": "This property shall contain the frequency in hertz units over the nominal value that satisf…
601 …"description": "The positive percentage of voltage RMS over the nominal value that satisfies a cri…
602 …s property shall contain the positive percentage of voltage RMS over the nominal value that satisf…
625 …"description": "The frequency in hertz units under the nominal value that satisfies a criterion fo…
626 …on": "This property shall contain the frequency in hertz units under the nominal value that satisf…
635 …"description": "The negative percentage of voltage RMS under the nominal value that satisfies a cr…
636 … property shall contain the negative percentage of voltage RMS under the nominal value that satisf…
H A DPowerSupply.v1_6_0.json244 "description": "The nominal voltage of this output power rail.",
245 …"longDescription": "This property shall contain the nominal voltage of the associated output power…
394 …"description": "The nominal voltage type that is detected on the line input to this power supply.",
395 …"longDescription": "This property shall contain the nominal voltage type that is detected on the l…
481 "description": "The nominal output voltage type of this power supply.",
482 …"longDescription": "This property shall contain the nominal voltage type of the single output line…
491 …ovided by this power supply. The elements shall be ordered in ascending nominal voltage order. T…
/openbmc/linux/drivers/net/can/dev/
H A Dcalc_bittiming.c70 unsigned int bitrate_error; /* difference between current and nominal value */ in can_calc_bittiming()
72 unsigned int sample_point_error; /* difference between current and nominal value */ in can_calc_bittiming()
74 unsigned int sample_point_nominal; /* nominal sample point */ in can_calc_bittiming()
/openbmc/linux/tools/testing/selftests/cgroup/
H A Dmemcg_protection.m16 % n vector nominal protection of siblings set at the given level (memory.low)
51 protected = min(n, c); % start with nominal
/openbmc/linux/Documentation/devicetree/bindings/regulator/
H A Dtwl-regulator.txt62 - 0x08 - Sleep mode, the nominal output voltage is maintained with low power
64 - 0x0e - Active mode, the regulator can deliver its nominal output voltage
/openbmc/linux/arch/x86/kernel/acpi/
H A Dcppc.c86 pr_debug("Could not retrieve highest or nominal performance\n"); in amd_set_max_freq_ratio()
94 pr_debug("Non-zero highest/nominal perf values led to a 0 ratio\n"); in amd_set_max_freq_ratio()
/openbmc/bmcweb/redfish-core/schema/dmtf/json-schema-installed/
H A DPowerSupply.v1_6_0.json244 "description": "The nominal voltage of this output power rail.",
245 …"longDescription": "This property shall contain the nominal voltage of the associated output power…
394 …"description": "The nominal voltage type that is detected on the line input to this power supply.",
395 …"longDescription": "This property shall contain the nominal voltage type that is detected on the l…
481 "description": "The nominal output voltage type of this power supply.",
482 …"longDescription": "This property shall contain the nominal voltage type of the single output line…
491 …ovided by this power supply. The elements shall be ordered in ascending nominal voltage order. T…
/openbmc/linux/drivers/net/wireless/ath/ath9k/
H A Dar9002_phy.c359 ah->nf_2g.nominal = AR_PHY_CCA_NOM_VAL_9285_2GHZ; in ar9002_hw_set_nf_limits()
363 ah->nf_2g.nominal = AR_PHY_CCA_NOM_VAL_9287_2GHZ; in ar9002_hw_set_nf_limits()
367 ah->nf_2g.nominal = AR_PHY_CCA_NOM_VAL_9271_2GHZ; in ar9002_hw_set_nf_limits()
371 ah->nf_2g.nominal = AR_PHY_CCA_NOM_VAL_9280_2GHZ; in ar9002_hw_set_nf_limits()
374 ah->nf_5g.nominal = AR_PHY_CCA_NOM_VAL_9280_5GHZ; in ar9002_hw_set_nf_limits()

12345678910>>...13