| /openbmc/linux/drivers/net/mdio/ |
| H A D | Kconfig | 210 comment "MDIO Multiplexers"
217 multiplexers which connect one of several child MDIO busses
229 the amlogic g12a SoC. The multiplexers connects either the external
244 tristate "Broadcom BCM6368 MDIO bus multiplexers"
249 This module provides a driver for MDIO bus multiplexers found in
255 tristate "Broadcom iProc based MDIO bus multiplexers"
260 This module provides a driver for MDIO bus multiplexers found in
266 tristate "GPIO controlled MDIO bus multiplexers"
270 This module provides a driver for MDIO bus multiplexers that
288 tristate "MMIO device-controlled MDIO bus multiplexers"
[all …]
|
| /openbmc/linux/drivers/mux/ |
| H A D | Kconfig | 13 tristate "Analog Devices ADG792A/ADG792G Multiplexers"
16 ADG792A and ADG792G Wide Bandwidth Triple 4:1 Multiplexers
18 The driver supports both operating the three multiplexers in
25 tristate "Analog Devices ADGS1408/ADGS1409 Multiplexers"
43 multiplexers, which in that case will be operated in parallel.
|
| /openbmc/u-boot/drivers/i2c/muxes/ |
| H A D | Kconfig | 2 bool "Support I2C multiplexers"
11 bool "Support I2C multiplexers on SPL"
|
| /openbmc/linux/Documentation/devicetree/bindings/mux/ |
| H A D | mux-controller.yaml | 15 several parallel multiplexers. Presumably there will be at least one
17 control several multiplexers for a single consumer.
140 * parallel 4-way multiplexers controlled by the same two GPIO-lines.
|
| H A D | gpio-mux.yaml | 14 multiplexers, if the same pins control more than one multiplexer.
|
| H A D | adi,adg792a.txt | 1 Bindings for Analog Devices ADG792A/G Triple 4:1 Multiplexers
|
| H A D | reg-mux.yaml | 13 Define register bitfields to be used to control multiplexers. The parent
|
| /openbmc/linux/Documentation/devicetree/bindings/i2c/ |
| H A D | i2c-mux-gpmux.yaml | 59 However, I2C transactions to devices behind all I2C multiplexers connected
66 The properties of mux-locked and parent-locked multiplexers are discussed
|
| H A D | i2c-mux-ltc4306.txt | 19 multiplexers on the bus and the devices behind them use same I2C addresses.
|
| H A D | i2c-mux.yaml | 17 For i2c multiplexers/switches that have child nodes that are a mixture of both
|
| H A D | i2c-mux-pca954x.yaml | 63 necessary for example, if there are several multiplexers on the bus and
|
| /openbmc/linux/drivers/iio/multiplexer/ |
| H A D | Kconfig | 7 menu "Multiplexers" menu
|
| /openbmc/linux/Documentation/devicetree/bindings/clock/st/ |
| H A D | st,clkgen-mux.txt | 3 This binding supports only simple indexed multiplexers, it does not
|
| /openbmc/linux/include/linux/platform_data/ |
| H A D | mlxcpld.h | 11 /* Platform data for the CPLD I2C multiplexers */
|
| /openbmc/u-boot/doc/device-tree-bindings/clock/ |
| H A D | microchip,pic32-clock.txt | 4 multiplexers and few divider modules capable of supplying clocks
|
| /openbmc/linux/Documentation/devicetree/bindings/sound/ |
| H A D | simple-audio-mux.yaml | 13 Simple audio multiplexers are driven using gpios, allowing to select which of
|
| /openbmc/linux/Documentation/admin-guide/media/ |
| H A D | imx.rst | 68 - Two video multiplexers for selecting among multiple sensor inputs
113 multiplexers, but the internal IPUv3 topology downstream from there
151 multiplexers as described below.
154 two video multiplexers. Both CSI0 and CSI1 can receive any virtual
155 channel, as selected by the video multiplexers.
165 These are the video multiplexers. They have two or more sink pads to
|
| /openbmc/linux/drivers/media/platform/ |
| H A D | Kconfig | 62 This driver provides support for N:1 video bus multiplexers.
|
| /openbmc/linux/Documentation/devicetree/bindings/media/ |
| H A D | video-mux.yaml | 14 Video multiplexers allow to select between multiple input ports. Video
|
| /openbmc/linux/Documentation/devicetree/bindings/clock/ti/davinci/ |
| H A D | pll.txt | 5 an multiplexers for various clock signals.
|
| /openbmc/linux/sound/soc/codecs/ |
| H A D | tlv320aic31xx.h | 49 #define AIC31XX_CLKMUX AIC31XX_REG(0, 4) /* Clock clock Gen muxing, Multiplexers*/
62 #define AIC31XX_CLKOUTMUX AIC31XX_REG(0, 25) /* Clock setting register 9, Multiplexers */
|
| /openbmc/u-boot/drivers/i2c/ |
| H A D | i2c_core.c | 47 * a given I2C adapter directly or via other multiplexers. In the latter
54 * NXP (Philips) PCA954x multiplexers are supported. Switches are NOT
|
| /openbmc/linux/Documentation/devicetree/bindings/clock/ |
| H A D | ingenic,cgu.yaml | 11 typically includes a variety of PLLs, multiplexers, dividers & gates in order
|
| /openbmc/u-boot/drivers/clk/ |
| H A D | Kconfig | 10 feed into other clocks in a tree structure, with multiplexers to
|
| /openbmc/linux/Documentation/devicetree/bindings/gpio/ |
| H A D | gpio-pca95xx.yaml | 13 Bindings for the family of I2C GPIO multiplexers/expanders: NXP PCA95xx,
|