Searched full:mcusys (Results 1 – 9 of 9) sorted by relevance
/openbmc/linux/Documentation/devicetree/bindings/interrupt-controller/ |
H A D | mediatek,mtk-cirq.yaml | 14 work outside of MCUSYS which comprises with Cortex-Ax cores, CCI and GIC. 15 The external interrupts (outside MCUSYS) will feed through CIRQ and connect 16 to GIC in MCUSYS. When CIRQ is enabled, it will record the edge-sensitive 18 flush command is executed. With CIRQ, MCUSYS can be completely turned off
|
/openbmc/linux/Documentation/devicetree/bindings/arm/mediatek/ |
H A D | mediatek,mt8186-sys-clock.yaml | 23 The mcusys provides mux control to select the clock source in AP MCU. 30 - mediatek,mt8186-mcusys
|
/openbmc/linux/drivers/clk/mediatek/ |
H A D | clk-mt8186-mcu.c | 52 { .compatible = "mediatek,mt8186-mcusys", .data = &mcu_desc }, 67 MODULE_DESCRIPTION("MediaTek MT8186 mcusys clocks driver");
|
H A D | Kconfig | 645 tristate "Clock driver for MediaTek MT8186 mcusys" 649 This driver supports MediaTek MT8186 mcusys clocks.
|
/openbmc/linux/Documentation/devicetree/bindings/clock/ |
H A D | mediatek,mt8188-sys-clock.yaml | 23 The mcusys provides mux control to select the clock source in AP MCU.
|
/openbmc/linux/arch/arm64/boot/dts/mediatek/ |
H A D | mt8186.dtsi | 32 clocks = <&mcusys CLK_MCU_ARMPLL_BUS_SEL>, 371 clocks = <&mcusys CLK_MCU_ARMPLL_LL_SEL>, 395 clocks = <&mcusys CLK_MCU_ARMPLL_LL_SEL>, 419 clocks = <&mcusys CLK_MCU_ARMPLL_LL_SEL>, 443 clocks = <&mcusys CLK_MCU_ARMPLL_LL_SEL>, 467 clocks = <&mcusys CLK_MCU_ARMPLL_LL_SEL>, 491 clocks = <&mcusys CLK_MCU_ARMPLL_LL_SEL>, 515 clocks = <&mcusys CLK_MCU_ARMPLL_BL_SEL>, 539 clocks = <&mcusys CLK_MCU_ARMPLL_BL_SEL>, 840 mcusys: syscon@c53a000 { label [all …]
|
/openbmc/linux/drivers/clocksource/ |
H A D | timer-mediatek-cpux.c | 24 /* cpux mcusys wrapper */
|
/openbmc/linux/include/dt-bindings/clock/ |
H A D | mt8186-clk.h | 10 /* MCUSYS */
|
/openbmc/linux/drivers/bluetooth/ |
H A D | btmtkuart.c | 600 /* Wakeup MCUSYS is required for certain devices before we start to in btmtkuart_setup()
|