| /openbmc/u-boot/arch/arm/include/asm/arch-am33xx/ |
| H A D | clk_synthesizer.h | 27 * @capacitor: value of the capacitor attached
34 u32 capacitor; member
|
| /openbmc/linux/Documentation/devicetree/bindings/iio/proximity/ |
| H A D | ams,as3935.yaml | 31 ams,tuning-capacitor-pf:
34 Calibration tuning capacitor stepping value. This will require using
70 ams,tuning-capacitor-pf = <80>;
|
| /openbmc/u-boot/arch/arm/mach-omap2/am33xx/ |
| H A D | clk_synthesizer.c | 92 * as per the PLL_DIV and load capacitor programmed.
118 /* Crystal Load capacitor selection */ in setup_clock_synthesizer()
120 data->capacitor); in setup_clock_synthesizer()
|
| /openbmc/linux/drivers/media/tuners/ |
| H A D | mt2060_priv.h | 55 V1CSE : LO1 VCO Automatic Capacitor Select Enable ( ? )
56 V1CS : LO1 Capacitor Selection Value ( ? )
|
| /openbmc/linux/Documentation/devicetree/bindings/sound/ |
| H A D | qcom,pm8916-wcd-analog-codec.yaml | 87 True if micbias1 has an external capacitor.
92 True if micbias2 has an external capacitor.
|
| H A D | ti,tas5086.txt | 16 split-capacitor charge period. The hardware chip
|
| /openbmc/linux/include/linux/regulator/ |
| H A D | tps62360.h | 19 * @en_discharge: Enable discharge the output capacitor via internal
|
| /openbmc/linux/drivers/iio/proximity/ |
| H A D | as3935.c | 367 "ams,tuning-capacitor-pf", &st->tune_cap); in as3935_probe()
370 dev_warn(dev, "no tuning-capacitor-pf set, defaulting to %d", in as3935_probe()
375 dev_err(dev, "wrong tuning-capacitor-pf setting of %d\n", in as3935_probe()
|
| /openbmc/linux/arch/arm/boot/dts/ti/omap/ |
| H A D | omap3-beagle-ab4.dts | 12 * Workaround for capacitor C70 issue, see "Boards revision A and < B5"
|
| /openbmc/linux/Documentation/devicetree/bindings/mmc/ |
| H A D | sdhci-atmel.txt | 23 and a capacitor (see "SDMMC I/O Calibration" chapter).
|
| /openbmc/linux/Documentation/devicetree/bindings/power/supply/ |
| H A D | qcom,pm8941-coincell.yaml | 10 The hardware block controls charging for a coincell or capacitor that is
|
| H A D | mediatek,mt6370-charger.yaml | 62 and the bootstrap capacitor
|
| H A D | bq25980.yaml | 17 switched capacitor architecture.
|
| /openbmc/linux/Documentation/hwmon/ |
| H A D | pim4328.rst | 83 in4_input Measured voltage on holdup capacitor.
|
| H A D | bel-pfe.rst | 92 in2_input Hold up capacitor voltage
|
| /openbmc/linux/Documentation/devicetree/bindings/clock/ |
| H A D | ti,cdce925.yaml | 50 Crystal load-capacitor value to fine-tune performance on a
|
| H A D | idt,versaclock5.yaml | 81 description: Optional load capacitor for XTAL1 and XTAL2
|
| /openbmc/u-boot/board/pandora/ |
| H A D | pandora.c | 112 /* Enable battery backup capacitor (3.2V, 0.5mA charge current) */ in misc_init_r()
|
| /openbmc/linux/sound/soc/codecs/ |
| H A D | inno_rk3036.c | 356 /* set a big current for capacitor charging. */ in rk3036_codec_set_bias_level()
364 /* set a big current for capacitor discharging. */ in rk3036_codec_set_bias_level()
|
| /openbmc/u-boot/drivers/power/regulator/ |
| H A D | stm32-vrefbuf.c | 50 * Vrefbuf startup time depends on external capacitor: wait here for in stm32_vrefbuf_set_enable()
|
| /openbmc/linux/include/linux/iio/frequency/ |
| H A D | ad9523.h | 135 * @cpole1: PLL2 loop filter Cpole capacitor value.
|
| /openbmc/linux/drivers/scsi/mvsas/ |
| H A D | mv_sas.h | 258 /* 4 bits, FFE Capacitor Select (value range 0~F) */
285 * BIT 0~3 : FFE Capacitor select(value range 0~F)
|
| /openbmc/linux/include/linux/mfd/arizona/ |
| H A D | pdata.h | 60 unsigned int ext_cap:1; /** External capacitor fitted */
|
| /openbmc/u-boot/drivers/power/ |
| H A D | axp209.c | 127 * On some boards, LDO3 has a too big capacitor installed. When in axp_set_aldo3()
|
| /openbmc/linux/Documentation/userspace-api/media/v4l/ |
| H A D | ext-ctrls-fm-tx.rst | 176 This selects the value of antenna tuning capacitor manually or
|