| /openbmc/u-boot/arch/arm/include/asm/arch-mxs/ |
| H A D | imx-regs.h | 3 * Freescale i.MX23/i.MX28 Registers
29 #include <asm/arch/regs-clkctrl-mx23.h>
30 #include <asm/arch/regs-power-mx23.h>
|
| H A D | regs-base.h | 3 * Freescale i.MX23/i.MX28 Peripheral Base Addresses
18 * Register base addresses for i.MX23
|
| H A D | sys_proto.h | 3 * Freescale i.MX23/i.MX28 specific functions
19 #include <asm/arch/iomux-mx23.h>
|
| H A D | clock.h | 3 * Freescale i.MX23/i.MX28 Clock
|
| /openbmc/u-boot/arch/arm/cpu/arm926ejs/mxs/ |
| H A D | spl_mem_init.c | 73 * i.MX23 DDR at 133MHz
114 debug("SPL: Setting mx23 board specific SDRAM parameters\n"); in initialize_dram_values()
121 * mx23 Reference Manual marks HW_DRAM_CTL27 and HW_DRAM_CTL28 as in initialize_dram_values()
254 debug("SPL: Setting mx23 VDDMEM\n"); in mx23_mem_setup_vddmem()
268 debug("SPL: Initialising mx23 SDRAM Controller\n"); in mx23_mem_init()
272 * suffers from memory instability. This thing is mx23 specific and is in mx23_mem_init()
|
| /openbmc/u-boot/arch/arm/mach-imx/mxs/ |
| H A D | Kconfig | 3 config MX23 config
8 prompt "MX23 board select"
|
| /openbmc/u-boot/doc/imx/mkimage/ |
| H A D | mxsimage.txt | 5 Such a BootStream is then bootable on i.MX23/i.MX28.
20 mxsimage.mx23.cfg -- This is an example configuration for i.MX23
91 i.MX23, string_mode = USB/I2C/SPI1_FLASH/SPI2_FLASH/NAND_BCH
|
| /openbmc/linux/Documentation/devicetree/bindings/clock/ |
| H A D | imx23-clock.yaml | 7 title: Freescale i.MX23 Clock Controller
14 ID in its "clocks" phandle cell. The following is a full list of i.MX23
|
| /openbmc/u-boot/board/olimex/mx23_olinuxino/ |
| H A D | mx23_olinuxino.c | 3 * Olimex MX23 Olinuxino board
11 #include <asm/arch/iomux-mx23.h>
|
| H A D | spl_boot.c | 3 * Olimex MX23 Olinuxino Boot setup
11 #include <asm/arch/iomux-mx23.h>
|
| /openbmc/linux/Documentation/devicetree/bindings/mfd/ |
| H A D | mxs-lradc.txt | 4 - compatible: Should be "fsl,imx23-lradc" for i.MX23 SoC and "fsl,imx28-lradc"
23 Example for i.MX23 SoC:
|
| /openbmc/u-boot/doc/imx/common/ |
| H A D | mxs.txt | 10 The term "MXS" refers to a family of Freescale SoCs that is composed by MX23
33 tool is built automatically when compiling U-Boot for i.MX23 or i.MX28.
43 longer necessary for general use of U-Boot on i.MX23 and i.MX28.
110 4. For building U-Boot for Olimex MX23 Olinuxino board:
143 to MX28 manual, section 12.2.1 (Table 12-2) or MX23 manual, section 35.1.2
|
| /openbmc/linux/drivers/clocksource/ |
| H A D | mxs_timer.c | 22 * The v1 on MX23 only gets 16 bits counter, while v2 on MX28
26 * another for clocksource. MX28 uses timrot 0 and 1, while MX23
43 * on MX28 while timrot2 on MX23.
|
| /openbmc/u-boot/include/configs/ |
| H A D | mxs.h | 35 #include <asm/arch/iomux-mx23.h>
57 /* OCRAM at 0x0 ; 32kB on MX23 ; 128kB on MX28 */
|
| /openbmc/linux/arch/arm/mach-mxs/ |
| H A D | Kconfig | 17 bool "Freescale MXS (i.MX23, i.MX28) support"
|
| /openbmc/linux/drivers/i2c/busses/ |
| H A D | i2c-mxs.c | 106 * @dev_type: distinguish i.MX23/i.MX28 features
349 * Start WRITE transaction on the I2C bus. By studying i.MX23 datasheet,
381 * MX23 idea: in mxs_i2c_pio_setup_xfer()
385 * WARNING! The MX23 is broken in some way, even if it claims in mxs_i2c_pio_setup_xfer()
549 /* Clear the PIO_MODE on i.MX23 */ in mxs_i2c_pio_setup_xfer()
622 * The i.MX23 is strange. After each and every operation, it's I2C IP in mxs_i2c_xfer_msg()
626 * DEBUG0 register. This bit is not documented in the i.MX23 datasheet in mxs_i2c_xfer_msg()
|
| /openbmc/u-boot/tools/ |
| H A D | mxsimage.h | 190 * on i.MX23 and i.MX28, but some of the mode names
194 * fields on i.MX23 as seen in Table 35-3 of the
|
| /openbmc/linux/drivers/gpu/drm/mxsfb/ |
| H A D | Kconfig | 19 Those devices are found in various i.MX SoC (including i.MX23,
|
| H A D | mxsfb_drv.h | 5 * i.MX23/i.MX28/i.MX6SX MXSFB LCD controller driver.
|
| /openbmc/linux/Documentation/devicetree/bindings/nvmem/ |
| H A D | mxs-ocotp.yaml | 7 title: On-Chip OTP Memory for Freescale i.MX23/i.MX28
|
| /openbmc/u-boot/drivers/dma/ |
| H A D | Kconfig | 47 depends on MX23 || MX28 || MX6 || MX7
|
| /openbmc/linux/Documentation/devicetree/bindings/crypto/ |
| H A D | fsl-dcp.yaml | 7 title: Freescale DCP (Data Co-Processor) found on i.MX23/i.MX28
|
| /openbmc/u-boot/doc/ |
| H A D | README.mxc_ocotp | 10 - i.MX23,
|
| /openbmc/linux/drivers/mfd/ |
| H A D | mxs-lradc.c | 175 fallthrough; /* to an error message for i.MX23 */ in mxs_lradc_probe()
258 MODULE_DESCRIPTION("Freescale i.MX23/i.MX28 LRADC driver");
|
| /openbmc/u-boot/board/freescale/mx23evk/ |
| H A D | mx23evk.c | 18 #include <asm/arch/iomux-mx23.h>
|