Home
last modified time | relevance | path

Searched full:ldos (Results 1 – 25 of 85) sorted by relevance

1234

/openbmc/u-boot/drivers/power/pmic/
H A DKconfig39 regulators (LDOs). It also provides some GPIO, reset and battery
46 The AS3722 includes 7 DC/DC buck convertors, 11 low-noise LDOs, a
100 - 21x LDOs
128 The Rockchip RK808 PMIC provides four buck DC-DC convertors, 8 LDOs,
176 The S5M8767 PMIC provides a large array of LDOs and BUCKs for use
193 The TPS65090 is a PMIC containing several LDOs, DC to DC convertors,
202 The PALMAS is a PMIC containing several LDOs, SMPS.
209 The LP873X is a PMIC containing couple of LDOs and couple of SMPS.
223 SoC. It provides 4 buck DC-DC convertors and 5 LDOs, and it is accessed
231 DC-DC converter, 8 LDOs and a RTC. This driver binds the SMPS and LDO
[all …]
/openbmc/linux/Documentation/devicetree/bindings/regulator/
H A Dtwl-regulator.txt4 For twl6030 regulators/LDOs
21 For twl6032 regulators/LDOs
35 For twl4030 regulators/LDOs
60 For twl4030 regulators/LDOs:
75 For twl6030 regulators/LDOs:
H A Drohm,bd71815-regulator.yaml57 comments below for bucks/LDOs which support this. 0 means
77 comments below for bucks/LDOs which support this. 0 means
86 comments below for bucks/LDOs which support this. 0 means
99 # Bucks 3-5 and ldos 1-5 support setting the RUN state voltage here.
H A Dmaxim,max77802.yaml31 regulators are:: bucks 2-4 and LDOs 1-35. Also, it only takes effect if the
43 LDOs supporting the regulator-initial-mode property and changing their
52 LDOs supporting the regulator-mode property (changing mode to Low Power
H A Dsprd,sc2731-regulator.txt4 14 LDO and 3 DCDCs are designed for external use. All DCDCs/LDOs have
6 ceramic capacitors are recommended to use with these LDOs.
H A Dregulator-max77620.txt3 Device has multiple DCDC(sd[0-3] and LDOs(ldo[0-8]). The input supply
38 There are also additional properties for SD/LDOs. These additional properties
39 are required to configure FPS configuration parameters for SDs and LDOs.
113 LDOs: 5mV/us, 100mV/us
H A Dsamsung,s2mps11.yaml22 # 38 LDOs
H A Dsamsung,s2mpu02.yaml22 # 28 LDOs
H A Dsamsung,s2mps15.yaml22 # 27 LDOs
H A Dsamsung,s2mps13.yaml22 # 40 LDOs
H A Dsamsung,s2mps14.yaml22 # 25 LDOs, without LDO10-12
/openbmc/u-boot/drivers/power/regulator/
H A DKconfig33 driver implements get/set api for the various BUCKS and LDOS supported
42 driver implements enable/disable for step-down bucks and LDOs,
130 driver implements get/set api for the various BUCKS and LDOs supported
148 common requirements, including all LDOs and BUCKs. This allows many
243 The TPS65910 PMIC provides 4 SMPSs and 8 LDOs. This driver supports all
252 driver implements get/set api for the various BUCKS and LDOs supported
/openbmc/linux/drivers/regulator/
H A DKconfig114 Say y here to support Freescale i.MX on-chip ANATOP LDOs
283 Say y here to support the BUCKs and LDOs regulators found on
297 Say y here to support the BUCKs and LDOs regulators found on
307 Say y here to support the BUCKs and LDOs regulators found on
317 Say y here to support the BUCKs and LDOs regulators found on
413 21 general purpose LDOs, 3 dedicated LDOs, and 5 BUCKs. All
423 provides 5 general purpose LDOs, and all of them come with support
463 Other LDOs are used for the display module.
547 regulator. The MAX77836 has two additional LDOs.
584 chip to control Step-Down DC-DC and LDOs. Say Y here to
[all …]
H A Dmax77802-regulator.c108 * Some LDOs support Low Power Mode while the system is running.
110 * LDOs 1, 3, 20, 21.
158 * Enable Control Logic1 by PWRREQ (BUCK 2-4 and LDOs 2, 4-19, 22-35)
159 * Enable Control Logic2 by PWRREQ (LDOs 1, 20, 21)
236 * LDOs 2, 4-19, 22-35
252 * LDOs 1, 20, 21, 3
310 /* LDOs 3-7, 9-14, 18-26, 28, 29, 32-34 */
331 /* LDOs 1, 2, 8, 15, 17, 27, 30, 35 */
H A Dmax77686-regulator.c42 * Values used for configuring LDOs and bucks.
52 /* Low power mode controlled by PWRREQ: All LDOs */
87 /* all LDOs */ in max77686_get_opmode_shift()
112 /* Some BUCKs and LDOs supports Normal[ON/OFF] mode during suspend */
131 /* Some LDOs supports [LPM/Normal]ON mode during suspend state */
166 /* Some LDOs supports LPM-ON/OFF/Normal-ON mode during suspend state */
H A Drohm-regulator.c118 * Other bucks and all LDOs must be disabled when voltage is changed.
119 * BD96801 - LDO voltage levels can be changed when LDOs are disabled.
H A Dhi6421v530-regulator.c23 * @mode_mask: ECO mode bitmask of LDOs; for BUCKs, this masks sleep
24 * @eco_microamp: eco mode load upper limit (in uA), valid for LDOs only
/openbmc/linux/Documentation/devicetree/bindings/mfd/
H A Dda9062.txt11 da9062-regulator : : LDOs & BUCKs
22 da9062-regulator : : LDOs & BUCKs
54 - regulators : This node defines the settings for the LDOs and BUCKs.
H A Dmediatek,mt6357.yaml15 converters and 29 LDOs. Supported features are audio codec,
44 List of MT6357 BUCKs and LDOs regulators.
H A Dsprd,sc27xx-pmic.txt9 - LDOs to support both internal and external requirement.
/openbmc/u-boot/board/toradex/apalis-tk1/
H A Das3722_init.c80 * Don't write LDCONTROL - it's already 0xFF, i.e. all LDOs enabled. in pmic_enable_cpu_vdd()
96 * Don't write LDCONTROL - it's already 0xFF, i.e. all LDOs enabled. in pmic_enable_cpu_vdd()
112 * Don't write LDCONTROL - it's already 0xFF, i.e. all LDOs enabled. in pmic_enable_cpu_vdd()
/openbmc/u-boot/board/nvidia/venice2/
H A Das3722_init.c81 * Don't write LDCONTROL - it's already 0xFF, i.e. all LDOs enabled. in pmic_enable_cpu_vdd()
97 * Don't write LDCONTROL - it's already 0xFF, i.e. all LDOs enabled. in pmic_enable_cpu_vdd()
/openbmc/linux/include/linux/mfd/
H A Dtwl.h702 #define TPS_SUBSET BIT(1) /* tps659[23]0 have fewer LDOs */
729 * the LDOs, and leave the three buck converters alone. VDD1 and VDD2
740 /* EXTERNAL LDOs */
753 /* INTERNAL LDOs */
773 /* EXTERNAL LDOs */
785 /* INTERNAL LDOs */
789 /* LDOs on 6025 have different names */
/openbmc/linux/include/linux/regulator/
H A Dmt6357-regulator.h17 /* LDOs */
/openbmc/linux/drivers/mfd/
H A Dlp8788.c77 /* 12 digital ldos */
91 /* 10 analog ldos */

1234