| /openbmc/libmctp/tests/ |
| H A D | test_astlpc.c | 208 /* BMC initialisation */ in network_init()
214 /* Host initialisation */ in network_init()
250 /* Test harness initialisation */ in astlpc_test_packetised_message_bmc_to_host()
293 /* Test harness initialisation */ in astlpc_test_simple_message_host_to_bmc()
335 /* Test harness initialisation */ in astlpc_test_simple_message_bmc_to_host()
448 /* Test harness initialisation */ in astlpc_test_version_host_fails_negotiation()
452 /* BMC initialisation */ in astlpc_test_version_host_fails_negotiation()
461 /* Host initialisation */ in astlpc_test_version_host_fails_negotiation()
479 /* Test harness initialisation */ in astlpc_test_version_bmc_fails_negotiation()
483 /* BMC initialisation */ in astlpc_test_version_bmc_fails_negotiation()
[all …]
|
| /openbmc/u-boot/board/efi/ |
| H A D | Kconfig | 11 this case EFI does the early initialisation, and U-Boot
19 this case EFI does the early initialisation, and U-Boot
|
| /openbmc/qemu/include/hw/xen/interface/io/ |
| H A D | xenbus.h | 15 * status of initialisation across the bus. States here imply nothing about
25 * InitWait: Finished early initialisation but waiting for information
|
| /openbmc/u-boot/board/coreboot/coreboot/ |
| H A D | start.S | 11 /* No 32-bit board specific initialisation */
|
| /openbmc/u-boot/board/intel/edison/ |
| H A D | start.S | 11 /* No 32-bit board specific initialisation */
|
| /openbmc/u-boot/arch/arm/include/asm/arch-sunxi/ |
| H A D | gtbus.h | 3 * GTBUS initialisation
|
| H A D | gtbus_sun9i.h | 3 * GTBUS initialisation for sun9i
|
| /openbmc/u-boot/board/toradex/apalis-tk1/ |
| H A D | Kconfig | 29 bool "Apalis Evaluation Board PCIe Initialisation"
|
| /openbmc/u-boot/board/toradex/apalis_t30/ |
| H A D | Kconfig | 29 bool "Apalis Evaluation Board PCIe Initialisation"
|
| /openbmc/phosphor-mboxd/ |
| H A D | mboxd_windows.h | 12 /* Initialisation Functions */
|
| /openbmc/u-boot/arch/mips/cpu/ |
| H A D | cm_init.S | 3 * MIPS Coherence Manager (CM) Initialisation
|
| /openbmc/openbmc/meta-openembedded/meta-oe/recipes-graphics/directfb/directfb/ |
| H A D | fix-client-gfx_state-initialisation.patch | 4 Subject: [PATCH] fix client->gfx_state initialisation
|
| /openbmc/phosphor-mboxd/Documentation/ |
| H A D | mboxd.md | 42 UNINITIALISED - The daemon is still in the initialisation phase and
126 ### Initialisation subsection
|
| /openbmc/u-boot/doc/ |
| H A D | README.generic-board | 11 initialisation slightly differently. To address this, a new 'generic board
47 initialisation is painful since it must be independently added in 10
|
| /openbmc/hiomapd/Documentation/ |
| H A D | mboxd.md | 43 UNINITIALISED - The daemon is still in the initialisation phase and
127 ### Initialisation subsection
|
| /openbmc/libmctp/docs/bindings/ |
| H A D | vendor-ibm-astlpc.md | 279 The BMC MAY choose to fail channel initialisation if these properties are
311 The host sends commands to the BMC to signal channel initialisation, begin
357 - The control data is only written during initialisation. The control area is
374 drive the status register. Each side's initialisation sequence is outlined
385 #### BMC Initialisation Sequence
392 #### Host Initialisation Sequence
|
| /openbmc/u-boot/arch/arm/mach-sunxi/ |
| H A D | gtbus_sun9i.c | 3 * GTBUS initialisation for sun9i
|
| H A D | dram_sun9i.c | 3 * sun9i dram controller initialisation
467 * DRAM3 initialisation requires holding CKE LOW for in mctl_channel_init()
468 * at least 500us prior to starting the initialisation in mctl_channel_init()
470 * before the initialisation sequence may be started). in mctl_channel_init()
493 * after driving CKE HIGH in the initialisation sequence. in mctl_channel_init()
584 * initialisation when the PHY initialisation completes). in mctl_channel_init()
621 /* PHY initialisation */ in mctl_channel_init()
|
| /openbmc/hiomapd/ |
| H A D | windows.h | 36 /* Initialisation Functions */
|
| /openbmc/u-boot/drivers/video/rockchip/ |
| H A D | rk_hdmi.h | 65 * Performs the following, common initialisation steps:
|
| /openbmc/u-boot/board/aristainetos/ |
| H A D | aristainetos.c | 129 * During initialisation this isn't working correctly, in board_mmc_init()
135 * initialisation in Linux in board_mmc_init()
|
| /openbmc/u-boot/doc/device-tree-bindings/clock/ |
| H A D | rockchip,rk3368-dmc.txt | 4 The RK3368 DMC (dynamic memory controller) driver supports setup/initialisation
|
| /openbmc/u-boot/include/configs/ |
| H A D | integrator-common.h | 28 * then the U-Boot initialisation code will
|
| H A D | lacie_kw.h | 72 * Enable platform initialisation via misc_init_r() function
|
| /openbmc/qemu/include/hw/virtio/ |
| H A D | vhost.h | 162 * The initialisation of the vhost device will trigger the
163 * initialisation of the backend and potentially capability
264 * or initialisation time parameters. The configuration can be updated
|