/openbmc/u-boot/arch/arm/include/asm/arch-lpc32xx/ |
H A D | gpio_grp.h | 23 * P3 GPIO_0 - GPIO_5 (output register only)
|
/openbmc/linux/Documentation/devicetree/bindings/gpio/ |
H A D | gpio-xgene-sb.txt | 8 | GPIO controller +------ GPIO_0
|
/openbmc/linux/arch/arm64/boot/dts/qcom/ |
H A D | msm8998-sony-xperia-yoshino-maple.dts | 75 gpio-line-names = "", /* GPIO_0 */
|
H A D | sm8250-sony-xperia-edo-pdx206.dts | 94 gpio-line-names = "AP_CTI_IN", /* GPIO_0 */
|
H A D | sm8450-sony-xperia-nagara-pdx224.dts | 50 gpio-line-names = "TELE_SPI_MISO", /* GPIO_0 */
|
H A D | sm8450-sony-xperia-nagara-pdx223.dts | 78 gpio-line-names = "NC", /* GPIO_0 */
|
H A D | sm8350-sony-xperia-sagami-pdx215.dts | 103 gpio-line-names = "APPS_I2C_0_SDA", /* GPIO_0 */
|
H A D | sm8250-sony-xperia-edo-pdx203.dts | 186 gpio-line-names = "AP_CTI_IN", /* GPIO_0 */
|
H A D | apq8039-t2.dts | 199 "APQ_UART1_TX", /* GPIO_0 */
|
H A D | msm8996pro-xiaomi-natrium.dts | 251 "ESE_SPI_MOSI", /* GPIO_0 */
|
/openbmc/linux/arch/mips/boot/dts/mscc/ |
H A D | serval.dtsi | 105 pins = "GPIO_0", "GPIO_2", "GPIO_3", "GPIO_1";
|
/openbmc/u-boot/arch/mips/dts/ |
H A D | mscc,serval.dtsi | 113 pins = "GPIO_0", "GPIO_2", "GPIO_3", "GPIO_1";
|
H A D | mscc,servalt.dtsi | 113 pins = "GPIO_0", "GPIO_1", "GPIO_2", "GPIO_3";
|
H A D | mscc,jr2.dtsi | 122 pins = "GPIO_0", "GPIO_1", "GPIO_2", "GPIO_3";
|
H A D | mscc,ocelot.dtsi | 220 pins = "GPIO_0", "GPIO_1", "GPIO_2", "GPIO_3";
|
H A D | mscc,luton.dtsi | 66 pins = "GPIO_0", "GPIO_1", "GPIO_2", "GPIO_3";
|
/openbmc/linux/Documentation/devicetree/bindings/mfd/ |
H A D | mscc,ocelot.yaml | 128 pins = "GPIO_0", "GPIO_1", "GPIO_2", "GPIO_3";
|
/openbmc/linux/drivers/media/pci/cx23885/ |
H A D | cx23885-f300.c | 20 #define F300_DATA GPIO_0
|
H A D | cx23885-cards.c | 1718 cx23885_gpio_enable(dev, GPIO_0 | GPIO_1 | GPIO_2, 1); in cx23885_gpio_setup() 1721 cx23885_gpio_set(dev, GPIO_0 | GPIO_1 | GPIO_2); in cx23885_gpio_setup() 1727 cx23885_gpio_enable(dev, GPIO_0 | GPIO_1, 1); in cx23885_gpio_setup() 1728 cx23885_gpio_clear(dev, GPIO_0 | GPIO_1); in cx23885_gpio_setup() 1730 cx23885_gpio_set(dev, GPIO_0 | GPIO_1); in cx23885_gpio_setup()
|
/openbmc/linux/arch/arm/boot/dts/ti/omap/ |
H A D | omap4-panda-common.dtsi | 148 powerdown-gpios = <&gpio1 0 GPIO_ACTIVE_LOW>; /* gpio_0 */ 293 OMAP4_IOPAD(0x184, PIN_OUTPUT | MUX_MODE3) /* gpio_0 */
|
/openbmc/linux/arch/arm64/boot/dts/marvell/ |
H A D | armada-7040-db.dts | 136 * IO0_4: GPIO_0 IO1_4: SD_Status
|
/openbmc/linux/drivers/media/tuners/ |
H A D | tda8290.c | 372 set_gpio_cf[1] &= 0xf0; /* clear GPIO_0 bits 3-0 */ in tda8295_agc2_out() 375 set_gpio_cf[1] |= 0x01; /* config GPIO_0 as Open Drain Out */ in tda8295_agc2_out() 376 set_gpio_val[1] &= 0xfe; /* set GPIO_0 pin low */ in tda8295_agc2_out()
|
/openbmc/linux/Documentation/devicetree/bindings/pinctrl/ |
H A D | mediatek,mt7622-pinctrl.yaml | 292 PWM_0, GPIO_0, GPIO_1, GPIO_2, GPIO_3, GPIO_4, GPIO_5,
|
/openbmc/linux/arch/arm64/boot/dts/freescale/ |
H A D | imx8mn-bsh-smm-s2-common.dtsi | 420 MX8MN_IOMUXC_GPIO1_IO00_GPIO1_IO0 0x0d6 /* GPIO_0 - WIFI_GPIO_0 */
|
/openbmc/linux/arch/arm64/boot/dts/actions/ |
H A D | s900-bubblegum-96.dts | 94 "GPIO-A", /* GPIO_0, LSEC pin 23 */
|