/openbmc/linux/arch/arm64/boot/dts/ti/ |
H A D | k3-j7200-evm-quad-port-eth-exp.dtso | 19 ethernet1 = "/bus@100000/ethernet@c000000/ethernet-ports/port@1"; 20 ethernet2 = "/bus@100000/ethernet@c000000/ethernet-ports/port@2"; 21 ethernet3 = "/bus@100000/ethernet@c000000/ethernet-ports/port@3"; 22 ethernet4 = "/bus@100000/ethernet@c000000/ethernet-ports/port@4"; 97 J721E_IOPAD(0x00a8, PIN_OUTPUT, 5) /* (W19) UART8_TXD.MDIO0_MDC */ 98 J721E_IOPAD(0x00a4, PIN_INPUT, 5) /* (W14) UART8_RXD.MDIO0_MDIO */
|
/openbmc/linux/arch/arm64/boot/dts/freescale/ |
H A D | imx8-ss-ddr.dtsi | 7 ddr_subsys: bus@5c000000 { 13 ddr_pmu0: ddr-pmu@5c020000 {
|
H A D | fsl-ls1088a.dtsi | 261 <5 0 &gic GIC_SPI 5 IRQ_TYPE_LEVEL_HIGH>, 877 cluster1_core0_watchdog: wdt@c000000 { 957 fsl_mc: fsl-mc@80c000000 { 998 dpmac5: ethernet@5 { 1000 reg = <5>;
|
/openbmc/u-boot/arch/arm/dts/ |
H A D | am3517.dtsi | 20 am35x_otg_hs: am35x_otg_hs@5c040000 { 29 davinci_emac: ethernet@5c000000 { 46 davinci_mdio: ethernet@5c030000 { 81 hecc: can@5c050000 { 94 /* Table Table 5-79 of the TRM shows 480ab000 is reserved */
|
H A D | stm32mp157c.dtsi | 229 timer@5 { 231 reg = <5>; 693 hwspinlock: hwspinlock@4c000000 { 869 #dma-cells = <5>; 937 dsi: dsi@5a000000 { 947 ltdc: display-controller@5a001000 { 958 usbphyc: usbphyc@5a006000 { 978 usart1: serial@5c000000 { 986 i2c4: i2c@5c002000 { 999 i2c6: i2c@5c009000 {
|
/openbmc/linux/arch/arm/boot/dts/sunplus/ |
H A D | sunplus-sp7021-achip.dtsi | 77 soc@9c000000 { 80 interrupts = <GIC_SPI 5 IRQ_TYPE_LEVEL_HIGH>, /* EXT_INT0 */
|
/openbmc/u-boot/doc/SPI/ |
H A D | README.ti_qspi_dra_test | 24 …etected S25FL256S_64K with page size 256 Bytes, erase size 64 KiB, total 32 MiB, mapped at 5c000000 42 For #2, set sysboot to QSPI-1 boot mode(SYSBOOT[5:0] = 100110) and power
|
/openbmc/linux/arch/arm/boot/dts/aspeed/ |
H A D | aspeed-bmc-opp-vesnin.dts | 26 vga_memory: framebuffer@5f000000 { 30 flash_memory: region@5c000000 { 69 gpios = <&gpio ASPEED_GPIO(P, 5) GPIO_ACTIVE_LOW>;
|
H A D | aspeed-bmc-opp-palmetto.dts | 25 vga_memory: framebuffer@5f000000 { 30 coldfire_memory: codefire_memory@5ee00000 { 35 flash_memory: region@5c000000 { 49 gpios = <&gpio ASPEED_GPIO(R, 5) GPIO_ACTIVE_LOW>; 67 data-gpios = <&gpio ASPEED_GPIO(A, 5) GPIO_ACTIVE_HIGH>; 78 gpios = <&gpio ASPEED_GPIO(P, 5) GPIO_ACTIVE_LOW>; 79 linux,code = <ASPEED_GPIO(P, 5)>; 221 gpios = <ASPEED_GPIO(C, 5) GPIO_ACTIVE_HIGH>; 291 gpios = <ASPEED_GPIO(F, 5) GPIO_ACTIVE_HIGH>; 319 gpios = <ASPEED_GPIO(G, 5) GPIO_ACTIVE_HIGH>;
|
/openbmc/openbmc/meta-facebook/meta-bletchley/recipes-bletchley/mdio-util/files/ |
H A D | mdio-util | 21 C45_READ_CMD=$((16#8C000000)) 104 CMD_DATA=$5 193 if [ "$CLAUSE_VER" == "c22" ] && [ "$CMD_TYPE" == "r" ] && [ "$#" -eq 5 ]; then 194 REG_ADDR=${5} 197 REG_ADDR=${5} 201 DEV_ADDR=${5} 207 DEV_ADDR=${5}
|
/openbmc/linux/arch/arm/boot/dts/ti/omap/ |
H A D | am3517.dtsi | 54 target-module@5c040000 { 85 davinci_emac: ethernet@5c000000 { 102 davinci_mdio: mdio@5c030000 { 137 hecc: can@5c050000 { 180 /* Table Table 5-79 of the TRM shows 480ab000 is reserved */
|
/openbmc/linux/arch/arm64/boot/dts/qcom/ |
H A D | sm6115-fxtec-pro1x.dts | 24 framebuffer0: framebuffer@5c000000 { 44 gpios = <&pm6125_gpios 5 GPIO_ACTIVE_LOW>;
|
H A D | sm6115p-lenovo-j606f.dts | 29 framebuffer0: framebuffer@5c000000 { 49 gpios = <&pm6125_gpios 5 GPIO_ACTIVE_LOW>;
|
H A D | sm6125-xiaomi-laurel-sprout.dts | 29 framebuffer0: framebuffer@5c000000 { 77 gpios = <&pm6125_gpios 5 GPIO_ACTIVE_LOW>;
|
H A D | sm8250-xiaomi-elish-common.dtsi | 37 framebuffer: framebuffer@9c000000 { 142 cont_splash_mem: cont-splash@9c000000 { 519 current-num-sinks = <5>;
|
H A D | sm6125-sony-xperia-seine-pdx201.dts | 33 framebuffer0: framebuffer@5c000000 {
|
/openbmc/linux/arch/arm/boot/dts/renesas/ |
H A D | r7s9210-rza2mevb.dts | 26 * | = = | SW6-5 set to Ether2 27 * | 1 2 3 4 5 6 7 8 9 0 | SW6-6 set to VDC6 82 memory@c000000 { 147 <RZA2_PINMUX(PORTE, 5, 1)>, /* ET0_MDC */ 149 <RZA2_PINMUX(PORTL, 0, 5)>; /* IRQ4 */ 159 <RZA2_PINMUX(PORT3, 5, 7)>, /* RMII1_RXD1 */ 163 <RZA2_PINMUX(PORTL, 1, 5)>; /* IRQ5 */ 188 <RZA2_PINMUX(PORT5, 5, 3)>; /* SD1_WP */ 199 <RZA2_PINMUX(PORTC, 5, 1)>; /* VBUSEN1 */
|
/openbmc/linux/arch/arm/boot/dts/arm/ |
H A D | vexpress-v2p-ca5s.dts | 96 scu@2c000000 { 196 arm,vexpress-sysreg,func = <1 5>;
|
H A D | vexpress-v2p-ca9.dts | 78 vram: vram@4c000000 { 262 arm,vexpress-sysreg,func = <2 5>;
|
/openbmc/linux/arch/arm/boot/dts/ti/keystone/ |
H A D | keystone-k2hk.dtsi | 60 msm_ram: sram@c000000 { 67 bm-sram@5f0000 { 83 0xa50 8 0xa50 8 0x850 8 (ASSERT_CLEAR | DEASSERT_SET | STATUS_CLEAR) /* 5: dsp5 */ 244 resets = <&pscrst 5>; 246 interrupts = <5 13>;
|
H A D | keystone-k2l.dtsi | 190 * GPIO_TIMIO_SEL[5]: 0-GPIO5, 1-TIMI3 246 * GPIO_EMIFA_SEL[5]: 0-EMIFA5, 1-GPIO37 258 msm_ram: sram@c000000 { 404 ti,davinci-spi-num-cs = <5>; 412 ti,davinci-spi-num-cs = <5>;
|
/openbmc/linux/Documentation/devicetree/bindings/sram/ |
H A D | sram.yaml | 157 sram@5c000000 {
|
/openbmc/linux/arch/arm64/boot/dts/mediatek/ |
H A D | mt6779.dtsi | 63 cpu5: cpu@5 { 120 gic: interrupt-controller@c000000 {
|
/openbmc/linux/arch/arm/boot/dts/intel/pxa/ |
H A D | pxa3xx.dtsi | 33 (gpio <= 9) ? (0x028c + 4 * (gpio - 5)) : \ 44 (gpio <= 5) ? (0x284 + 4 * gpio) : \ 56 #define MFP_AF5 (5 << 0) 216 usb0: usb@4c000000 {
|
/openbmc/linux/arch/riscv/boot/dts/sifive/ |
H A D | fu540-c000.dtsi | 166 plic0: interrupt-controller@c000000 { 207 interrupts = <5>;
|