| /openbmc/openbmc/meta-ibm/recipes-phosphor/sensors/phosphor-hwmon/witherspoon-tacoma/obmc/hwmon/ahb/apb@1e780000/bus@1e78a000/i2c@280/ |
| H A D | ir35221@71.conf | 53 CRITHI_curriout2 = "130000"
|
| /openbmc/openbmc/meta-ibm/recipes-phosphor/sensors/phosphor-hwmon/witherspoon-tacoma/obmc/hwmon/ahb/apb@1e780000/bus@1e78a000/i2c@300/ |
| H A D | ir35221@71.conf | 53 CRITHI_curriout2 = "130000"
|
| /openbmc/openbmc/meta-ibm/recipes-phosphor/sensors/phosphor-hwmon/witherspoon/obmc/hwmon/ahb/apb@1e780000/bus@1e78a000/i2c@140/ |
| H A D | ir35221@71.conf | 53 CRITHI_curriout2 = "130000"
|
| /openbmc/openbmc/meta-ibm/recipes-phosphor/sensors/phosphor-hwmon/witherspoon/obmc/hwmon/ahb/apb@1e780000/bus@1e78a000/i2c@180/ |
| H A D | ir35221@71.conf | 53 CRITHI_curriout2 = "130000"
|
| /openbmc/linux/Documentation/devicetree/bindings/gpu/ |
| H A D | vivante,gc.yaml | 65 gpu@130000 {
|
| /openbmc/linux/Documentation/devicetree/bindings/iio/proximity/ |
| H A D | vishay,vcnl3020.yaml | 42 100000, 110000, 120000, 130000, 140000, 150000, 160000, 170000,
|
| /openbmc/linux/arch/powerpc/boot/dts/fsl/ |
| H A D | qoriq-gpio-0.dtsi | 35 gpio0: gpio@130000 {
|
| /openbmc/u-boot/board/timll/devkit3250/ |
| H A D | devkit3250_spl.c | 41 .refresh = 130000, /* 800 clock cycles */
|
| /openbmc/linux/Documentation/devicetree/bindings/gpio/ |
| H A D | gpio-delay.yaml | 78 enable-gpios = <&enable_delay 0 130000 30000>;
|
| /openbmc/linux/scripts/ |
| H A D | Makefile.kasan | 72 ifeq ($(call clang-min-version, 150000)$(call gcc-min-version, 130000),y)
|
| /openbmc/linux/arch/riscv/include/asm/ |
| H A D | ftrace.h | 20 #if defined(CONFIG_CC_IS_GCC) || CONFIG_CLANG_VERSION >= 130000
|
| /openbmc/linux/Documentation/devicetree/bindings/input/ |
| H A D | dlg,da7280.txt | 36 Default: 130000.
|
| /openbmc/linux/drivers/memory/ |
| H A D | jedec_ddr.h | 72 #define T_RFC_130 130000
|
| /openbmc/linux/arch/arm64/boot/dts/arm/ |
| H A D | foundation-v8.dtsi | 230 virtio@130000 {
|
| H A D | rtsm_ve-motherboard.dtsi | 225 virtio@130000 {
|
| /openbmc/linux/arch/arm64/boot/dts/qcom/ |
| H A D | msm8956-sony-xperia-loire.dtsi | 191 regulator-system-load = <130000>;
|
| H A D | sdm670.dtsi | 643 opp-peak-kBps = <200000 130000>;
644 opp-avg-kBps = <130718 130000>;
|
| /openbmc/linux/drivers/iio/chemical/ |
| H A D | sgp40.c | 279 if ((val < -45000) || (val > 130000)) in sgp40_write_raw()
|
| /openbmc/linux/drivers/net/wireless/broadcom/brcm80211/brcmsmac/ |
| H A D | rate.c | 91 {130000, 270000, CEIL(130000 * 10, 9), CEIL(270000 * 10, 9), 0x5C,
|
| /openbmc/linux/arch/x86/ |
| H A D | Makefile | 221 ifeq ($(call test-lt, $(CONFIG_LLD_VERSION), 130000),y)
|
| /openbmc/linux/drivers/thermal/qcom/ |
| H A D | qcom-spmi-temp-alarm.c | 47 { 110000, 130000, 150000 },
|
| /openbmc/linux/drivers/thermal/st/ |
| H A D | stm_thermal.c | 83 #define TS1_T0_VAL1 130000 /* 130 celsius */
|
| /openbmc/linux/drivers/power/supply/ |
| H A D | samsung-sdi-battery.c | 397 { .vbat_uv = 3526000, .ri_uohm = 130000 },
406 { .vbat_uv = 4325000, .ri_uohm = 130000 },
|
| /openbmc/linux/arch/arm64/boot/dts/broadcom/stingray/ |
| H A D | stingray.dtsi | 512 uart3: serial@130000 {
|
| /openbmc/linux/drivers/iio/light/ |
| H A D | adux1020.c | 206 { 0, 130000 },
|