xref: /openbmc/u-boot/include/linux/usb/musb.h (revision a376702f)
1 /*
2  * This is used to for host and peripheral modes of the driver for
3  * Inventra (Multidrop) Highspeed Dual-Role Controllers:  (M)HDRC.
4  *
5  * Board initialization should put one of these into dev->platform_data,
6  * probably on some platform_device named "musb-hdrc".  It encapsulates
7  * key configuration differences between boards.
8  */
9 
10 #ifndef __LINUX_USB_MUSB_H
11 #define __LINUX_USB_MUSB_H
12 
13 #ifndef __deprecated
14 #define __deprecated
15 #endif
16 
17 #include <linux/compat.h>
18 
19 /* The USB role is defined by the connector used on the board, so long as
20  * standards are being followed.  (Developer boards sometimes won't.)
21  */
22 enum musb_mode {
23 	MUSB_UNDEFINED = 0,
24 	MUSB_HOST,		/* A or Mini-A connector */
25 	MUSB_PERIPHERAL,	/* B or Mini-B connector */
26 	MUSB_OTG		/* Mini-AB connector */
27 };
28 
29 struct clk;
30 
31 enum musb_fifo_style {
32 	FIFO_RXTX,
33 	FIFO_TX,
34 	FIFO_RX
35 } __attribute__ ((packed));
36 
37 enum musb_buf_mode {
38 	BUF_SINGLE,
39 	BUF_DOUBLE
40 } __attribute__ ((packed));
41 
42 struct musb_fifo_cfg {
43 	u8			hw_ep_num;
44 	enum musb_fifo_style	style;
45 	enum musb_buf_mode	mode;
46 	u16			maxpacket;
47 };
48 
49 #define MUSB_EP_FIFO(ep, st, m, pkt)		\
50 {						\
51 	.hw_ep_num	= ep,			\
52 	.style		= st,			\
53 	.mode		= m,			\
54 	.maxpacket	= pkt,			\
55 }
56 
57 #define MUSB_EP_FIFO_SINGLE(ep, st, pkt)	\
58 	MUSB_EP_FIFO(ep, st, BUF_SINGLE, pkt)
59 
60 #define MUSB_EP_FIFO_DOUBLE(ep, st, pkt)	\
61 	MUSB_EP_FIFO(ep, st, BUF_DOUBLE, pkt)
62 
63 struct musb_hdrc_eps_bits {
64 	const char	name[16];
65 	u8		bits;
66 };
67 
68 struct musb_hdrc_config {
69 	struct musb_fifo_cfg	*fifo_cfg;	/* board fifo configuration */
70 	unsigned		fifo_cfg_size;	/* size of the fifo configuration */
71 
72 	/* MUSB configuration-specific details */
73 	unsigned	multipoint:1;	/* multipoint device */
74 	unsigned	dyn_fifo:1 __deprecated; /* supports dynamic fifo sizing */
75 	unsigned	soft_con:1 __deprecated; /* soft connect required */
76 	unsigned	utm_16:1 __deprecated; /* utm data witdh is 16 bits */
77 	unsigned	big_endian:1;	/* true if CPU uses big-endian */
78 	unsigned	mult_bulk_tx:1;	/* Tx ep required for multbulk pkts */
79 	unsigned	mult_bulk_rx:1;	/* Rx ep required for multbulk pkts */
80 	unsigned	high_iso_tx:1;	/* Tx ep required for HB iso */
81 	unsigned	high_iso_rx:1;	/* Rx ep required for HD iso */
82 	unsigned	dma:1 __deprecated; /* supports DMA */
83 	unsigned	vendor_req:1 __deprecated; /* vendor registers required */
84 
85 	u8		num_eps;	/* number of endpoints _with_ ep0 */
86 	u8		dma_channels __deprecated; /* number of dma channels */
87 	u8		dyn_fifo_size;	/* dynamic size in bytes */
88 	u8		vendor_ctrl __deprecated; /* vendor control reg width */
89 	u8		vendor_stat __deprecated; /* vendor status reg witdh */
90 	u8		dma_req_chan __deprecated; /* bitmask for required dma channels */
91 	u8		ram_bits;	/* ram address size */
92 
93 	struct musb_hdrc_eps_bits *eps_bits __deprecated;
94 };
95 
96 struct musb_hdrc_platform_data {
97 	/* MUSB_HOST, MUSB_PERIPHERAL, or MUSB_OTG */
98 	u8		mode;
99 
100 	/* for clk_get() */
101 	const char	*clock;
102 
103 	/* (HOST or OTG) switch VBUS on/off */
104 	int		(*set_vbus)(struct device *dev, int is_on);
105 
106 	/* (HOST or OTG) mA/2 power supplied on (default = 8mA) */
107 	u8		power;
108 
109 	/* (PERIPHERAL) mA/2 max power consumed (default = 100mA) */
110 	u8		min_power;
111 
112 	/* (HOST or OTG) msec/2 after VBUS on till power good */
113 	u8		potpgt;
114 
115 	/* (HOST or OTG) program PHY for external Vbus */
116 	unsigned	extvbus:1;
117 
118 	/* Power the device on or off */
119 	int		(*set_power)(int state);
120 
121 	/* MUSB configuration-specific details */
122 	struct musb_hdrc_config	*config;
123 
124 	/* Architecture specific board data	*/
125 	void		*board_data;
126 
127 	/* Platform specific struct musb_ops pointer */
128 	const void	*platform_ops;
129 };
130 
131 
132 /* TUSB 6010 support */
133 
134 #define	TUSB6010_OSCCLK_60	16667	/* psec/clk @ 60.0 MHz */
135 #define	TUSB6010_REFCLK_24	41667	/* psec/clk @ 24.0 MHz XI */
136 #define	TUSB6010_REFCLK_19	52083	/* psec/clk @ 19.2 MHz CLKIN */
137 
138 #ifdef	CONFIG_ARCH_OMAP2PLUS
139 
140 extern int __init tusb6010_setup_interface(
141 		struct musb_hdrc_platform_data *data,
142 		unsigned ps_refclk, unsigned waitpin,
143 		unsigned async_cs, unsigned sync_cs,
144 		unsigned irq, unsigned dmachan);
145 
146 extern int tusb6010_platform_retime(unsigned is_refclk);
147 
148 #endif	/* OMAP2 */
149 
150 /*
151  * U-Boot specfic stuff
152  */
153 struct musb *musb_register(struct musb_hdrc_platform_data *plat, void *bdata,
154 			   void *ctl_regs);
155 
156 #endif /* __LINUX_USB_MUSB_H */
157