1 /* 2 * board/renesas/alt/alt.c 3 * 4 * Copyright (C) 2014, 2015 Renesas Electronics Corporation 5 * 6 * SPDX-License-Identifier: GPL-2.0 7 */ 8 9 #include <common.h> 10 #include <malloc.h> 11 #include <dm.h> 12 #include <dm/platform_data/serial_sh.h> 13 #include <asm/processor.h> 14 #include <asm/mach-types.h> 15 #include <asm/io.h> 16 #include <asm/errno.h> 17 #include <asm/arch/sys_proto.h> 18 #include <asm/gpio.h> 19 #include <asm/arch/rmobile.h> 20 #include <asm/arch/rcar-mstp.h> 21 #include <asm/arch/mmc.h> 22 #include <asm/arch/sh_sdhi.h> 23 #include <netdev.h> 24 #include <miiphy.h> 25 #include <i2c.h> 26 #include <div64.h> 27 #include "qos.h" 28 29 DECLARE_GLOBAL_DATA_PTR; 30 31 #define CLK2MHZ(clk) (clk / 1000 / 1000) 32 void s_init(void) 33 { 34 struct rcar_rwdt *rwdt = (struct rcar_rwdt *)RWDT_BASE; 35 struct rcar_swdt *swdt = (struct rcar_swdt *)SWDT_BASE; 36 37 /* Watchdog init */ 38 writel(0xA5A5A500, &rwdt->rwtcsra); 39 writel(0xA5A5A500, &swdt->swtcsra); 40 41 /* QoS */ 42 qos_init(); 43 } 44 45 #define TMU0_MSTP125 (1 << 25) 46 #define SCIF2_MSTP719 (1 << 19) 47 #define ETHER_MSTP813 (1 << 13) 48 #define IIC1_MSTP323 (1 << 23) 49 #define MMC0_MSTP315 (1 << 15) 50 #define SDHI0_MSTP314 (1 << 14) 51 #define SDHI1_MSTP312 (1 << 12) 52 53 #define SD1CKCR 0xE6150078 54 #define SD1_97500KHZ 0x7 55 56 int board_early_init_f(void) 57 { 58 /* TMU */ 59 mstp_clrbits_le32(MSTPSR1, SMSTPCR1, TMU0_MSTP125); 60 61 /* SCIF2 */ 62 mstp_clrbits_le32(MSTPSR7, SMSTPCR7, SCIF2_MSTP719); 63 64 /* ETHER */ 65 mstp_clrbits_le32(MSTPSR8, SMSTPCR8, ETHER_MSTP813); 66 67 /* IIC1 / sh-i2c ch1 */ 68 mstp_clrbits_le32(MSTPSR3, SMSTPCR3, IIC1_MSTP323); 69 70 #ifdef CONFIG_SH_MMCIF 71 /* MMC */ 72 mstp_clrbits_le32(MSTPSR3, SMSTPCR3, MMC0_MSTP315); 73 #endif 74 75 #ifdef CONFIG_SH_SDHI 76 /* SDHI0, 1 */ 77 mstp_clrbits_le32(MSTPSR3, SMSTPCR3, SDHI0_MSTP314 | SDHI1_MSTP312); 78 79 /* 80 * SD0 clock is set to 97.5MHz by default. 81 * Set SD1 to the 97.5MHz as well. 82 */ 83 writel(SD1_97500KHZ, SD1CKCR); 84 #endif 85 return 0; 86 } 87 88 int board_init(void) 89 { 90 /* adress of boot parameters */ 91 gd->bd->bi_boot_params = CONFIG_SYS_SDRAM_BASE + 0x100; 92 93 /* Init PFC controller */ 94 r8a7794_pinmux_init(); 95 96 /* Ether Enable */ 97 #if defined(CONFIG_R8A7794_ETHERNET_B) 98 gpio_request(GPIO_FN_ETH_CRS_DV_B, NULL); 99 gpio_request(GPIO_FN_ETH_RX_ER_B, NULL); 100 gpio_request(GPIO_FN_ETH_RXD0_B, NULL); 101 gpio_request(GPIO_FN_ETH_RXD1_B, NULL); 102 gpio_request(GPIO_FN_ETH_LINK_B, NULL); 103 gpio_request(GPIO_FN_ETH_REFCLK_B, NULL); 104 gpio_request(GPIO_FN_ETH_MDIO_B, NULL); 105 gpio_request(GPIO_FN_ETH_TXD1_B, NULL); 106 gpio_request(GPIO_FN_ETH_TX_EN_B, NULL); 107 gpio_request(GPIO_FN_ETH_MAGIC_B, NULL); 108 gpio_request(GPIO_FN_ETH_TXD0_B, NULL); 109 gpio_request(GPIO_FN_ETH_MDC_B, NULL); 110 #else 111 gpio_request(GPIO_FN_ETH_CRS_DV, NULL); 112 gpio_request(GPIO_FN_ETH_RX_ER, NULL); 113 gpio_request(GPIO_FN_ETH_RXD0, NULL); 114 gpio_request(GPIO_FN_ETH_RXD1, NULL); 115 gpio_request(GPIO_FN_ETH_LINK, NULL); 116 gpio_request(GPIO_FN_ETH_REFCLK, NULL); 117 gpio_request(GPIO_FN_ETH_MDIO, NULL); 118 gpio_request(GPIO_FN_ETH_TXD1, NULL); 119 gpio_request(GPIO_FN_ETH_TX_EN, NULL); 120 gpio_request(GPIO_FN_ETH_MAGIC, NULL); 121 gpio_request(GPIO_FN_ETH_TXD0, NULL); 122 gpio_request(GPIO_FN_ETH_MDC, NULL); 123 #endif 124 gpio_request(GPIO_FN_IRQ8, NULL); 125 126 /* PHY reset */ 127 gpio_request(GPIO_GP_1_24, NULL); 128 gpio_direction_output(GPIO_GP_1_24, 0); 129 mdelay(20); 130 gpio_set_value(GPIO_GP_1_24, 1); 131 udelay(1); 132 133 return 0; 134 } 135 136 #define CXR24 0xEE7003C0 /* MAC address high register */ 137 #define CXR25 0xEE7003C8 /* MAC address low register */ 138 int board_eth_init(bd_t *bis) 139 { 140 #ifdef CONFIG_SH_ETHER 141 int ret = -ENODEV; 142 u32 val; 143 unsigned char enetaddr[6]; 144 145 ret = sh_eth_initialize(bis); 146 if (!eth_getenv_enetaddr("ethaddr", enetaddr)) 147 return ret; 148 149 /* Set Mac address */ 150 val = enetaddr[0] << 24 | enetaddr[1] << 16 | 151 enetaddr[2] << 8 | enetaddr[3]; 152 writel(val, CXR24); 153 154 val = enetaddr[4] << 8 | enetaddr[5]; 155 writel(val, CXR25); 156 157 return ret; 158 #else 159 return 0; 160 #endif 161 } 162 163 int board_mmc_init(bd_t *bis) 164 { 165 int ret = -ENODEV; 166 167 #ifdef CONFIG_SH_MMCIF 168 gpio_request(GPIO_GP_4_31, NULL); 169 gpio_set_value(GPIO_GP_4_31, 1); 170 171 ret = mmcif_mmc_init(); 172 #endif 173 174 #ifdef CONFIG_SH_SDHI 175 gpio_request(GPIO_FN_SD0_DATA0, NULL); 176 gpio_request(GPIO_FN_SD0_DATA1, NULL); 177 gpio_request(GPIO_FN_SD0_DATA2, NULL); 178 gpio_request(GPIO_FN_SD0_DATA3, NULL); 179 gpio_request(GPIO_FN_SD0_CLK, NULL); 180 gpio_request(GPIO_FN_SD0_CMD, NULL); 181 gpio_request(GPIO_FN_SD0_CD, NULL); 182 gpio_request(GPIO_FN_SD1_DATA0, NULL); 183 gpio_request(GPIO_FN_SD1_DATA1, NULL); 184 gpio_request(GPIO_FN_SD1_DATA2, NULL); 185 gpio_request(GPIO_FN_SD1_DATA3, NULL); 186 gpio_request(GPIO_FN_SD1_CLK, NULL); 187 gpio_request(GPIO_FN_SD1_CMD, NULL); 188 gpio_request(GPIO_FN_SD1_CD, NULL); 189 190 /* SDHI 0 */ 191 gpio_request(GPIO_GP_2_26, NULL); 192 gpio_request(GPIO_GP_2_29, NULL); 193 gpio_direction_output(GPIO_GP_2_26, 1); 194 gpio_direction_output(GPIO_GP_2_29, 1); 195 196 ret = sh_sdhi_init(CONFIG_SYS_SH_SDHI0_BASE, 0, 197 SH_SDHI_QUIRK_16BIT_BUF); 198 if (ret) 199 return ret; 200 201 /* SDHI 1 */ 202 gpio_request(GPIO_GP_4_26, NULL); 203 gpio_request(GPIO_GP_4_29, NULL); 204 gpio_direction_output(GPIO_GP_4_26, 1); 205 gpio_direction_output(GPIO_GP_4_29, 1); 206 207 ret = sh_sdhi_init(CONFIG_SYS_SH_SDHI1_BASE, 1, 0); 208 #endif 209 return ret; 210 } 211 212 int dram_init(void) 213 { 214 gd->ram_size = CONFIG_SYS_SDRAM_SIZE; 215 216 return 0; 217 } 218 219 const struct rmobile_sysinfo sysinfo = { 220 CONFIG_ARCH_RMOBILE_BOARD_STRING 221 }; 222 223 void reset_cpu(ulong addr) 224 { 225 u8 val; 226 227 i2c_set_bus_num(1); /* PowerIC connected to ch1 */ 228 i2c_read(CONFIG_SYS_I2C_POWERIC_ADDR, 0x13, 1, &val, 1); 229 val |= 0x02; 230 i2c_write(CONFIG_SYS_I2C_POWERIC_ADDR, 0x13, 1, &val, 1); 231 } 232 233 static const struct sh_serial_platdata serial_platdata = { 234 .base = SCIF2_BASE, 235 .type = PORT_SCIF, 236 .clk = 14745600, 237 .clk_mode = EXT_CLK, 238 }; 239 240 U_BOOT_DEVICE(alt_serials) = { 241 .name = "serial_sh", 242 .platdata = &serial_platdata, 243 }; 244