1 /* 2 * (C) Copyright 2004 3 * Wolfgang Denk, DENX Software Engineering, wd@denx.de. 4 * 5 * SPDX-License-Identifier: GPL-2.0+ 6 */ 7 8 #include <common.h> 9 #include <command.h> 10 #include <malloc.h> 11 #include <asm/immap.h> 12 13 int checkboard (void) { 14 ulong val; 15 uchar val8; 16 17 puts ("Board: "); 18 puts("Freescale M5249EVB"); 19 val8 = ((uchar)~((uchar)mbar2_readLong(MCFSIM_GPIO1_READ) >> 4)) & 0xf; 20 printf(" (Switch=%1X)\n", val8); 21 22 /* 23 * Set LED on 24 */ 25 val = mbar2_readLong(MCFSIM_GPIO1_OUT) & ~CONFIG_SYS_GPIO1_LED; 26 mbar2_writeLong(MCFSIM_GPIO1_OUT, val); /* Set LED on */ 27 28 return 0; 29 }; 30 31 32 phys_size_t initdram (int board_type) { 33 unsigned long junk = 0xa5a59696; 34 35 /* 36 * Note: 37 * RC = ([(RefreshTime/#rows) / (1/BusClk)] / 16) - 1 38 */ 39 40 #ifdef CONFIG_SYS_FAST_CLK 41 /* 42 * Busclk=70MHz, RefreshTime=64ms, #rows=4096 (4K) 43 * SO=1, NAM=0, COC=0, RTIM=01 (6clk refresh), RC=39 44 */ 45 mbar_writeShort(MCFSIM_DCR, 0x8239); 46 #elif CONFIG_SYS_PLL_BYPASS 47 /* 48 * Busclk=5.6448MHz, RefreshTime=64ms, #rows=8192 (8K) 49 * SO=1, NAM=0, COC=0, RTIM=01 (6clk refresh), RC=02 50 */ 51 mbar_writeShort(MCFSIM_DCR, 0x8202); 52 #else 53 /* 54 * Busclk=36MHz, RefreshTime=64ms, #rows=4096 (4K) 55 * SO=1, NAM=0, COC=0, RTIM=01 (6clk refresh), RC=22 (562 bus clock cycles) 56 */ 57 mbar_writeShort(MCFSIM_DCR, 0x8222); 58 #endif 59 60 /* 61 * SDRAM starts at 0x0000_0000, CASL=10, CBM=010, PS=10 (16bit port), 62 * PM=1 (continuous page mode) 63 */ 64 65 /* RE=0 (keep auto-refresh disabled while setting up registers) */ 66 mbar_writeLong(MCFSIM_DACR0, 0x00003324); 67 68 /* BAM=007c (bits 22,21 are bank selects; 256kB blocks) */ 69 mbar_writeLong(MCFSIM_DMR0, 0x01fc0001); 70 71 /** Precharge sequence **/ 72 mbar_writeLong(MCFSIM_DACR0, 0x0000332c); /* Set DACR0[IP] (bit 3) */ 73 *((volatile unsigned long *) 0x00) = junk; /* write to a memory location to init. precharge */ 74 udelay(0x10); /* Allow several Precharge cycles */ 75 76 /** Refresh Sequence **/ 77 mbar_writeLong(MCFSIM_DACR0, 0x0000b324); /* Enable the refresh bit, DACR0[RE] (bit 15) */ 78 udelay(0x7d0); /* Allow gobs of refresh cycles */ 79 80 /** Mode Register initialization **/ 81 mbar_writeLong(MCFSIM_DACR0, 0x0000b364); /* Enable DACR0[IMRS] (bit 6); RE remains enabled */ 82 *((volatile unsigned long *) 0x800) = junk; /* Access RAM to initialize the mode register */ 83 84 return CONFIG_SYS_SDRAM_SIZE * 1024 * 1024; 85 }; 86 87 88 int testdram (void) { 89 /* TODO: XXX XXX XXX */ 90 printf ("DRAM test not implemented!\n"); 91 92 return (0); 93 } 94