xref: /openbmc/u-boot/arch/arm/mach-stm32mp/Kconfig (revision eba6589f)
1if ARCH_STM32MP
2
3config SPL
4	select SPL_BOARD_INIT
5	select SPL_CLK
6	select SPL_DM
7	select SPL_DM_SEQ_ALIAS
8	select SPL_FRAMEWORK
9	select SPL_GPIO_SUPPORT
10	select SPL_LIBCOMMON_SUPPORT
11	select SPL_LIBGENERIC_SUPPORT
12	select SPL_OF_CONTROL
13	select SPL_OF_TRANSLATE
14	select SPL_PINCTRL
15	select SPL_REGMAP
16	select SPL_RESET_SUPPORT
17	select SPL_SERIAL_SUPPORT
18	select SPL_SYSCON
19	select SPL_DRIVERS_MISC_SUPPORT
20	imply SPL_LIBDISK_SUPPORT
21
22config SYS_SOC
23	default "stm32mp"
24
25config TARGET_STM32MP1
26	bool "Support stm32mp1xx"
27	select ARCH_SUPPORT_PSCI
28	select CPU_V7A
29	select CPU_V7_HAS_NONSEC
30	select CPU_V7_HAS_VIRT
31	select PINCTRL_STM32
32	select STM32_RESET
33	select SYS_ARCH_TIMER
34	select SYSRESET_SYSCON
35	help
36		target STMicroelectronics SOC STM32MP1 family
37		STMicroelectronics MPU with core ARMv7
38
39config SYS_TEXT_BASE
40	prompt "U-Boot base address"
41	default 0xC0100000
42	help
43		configure the U-Boot base address
44		when DDR driver is used:
45		  DDR + 1MB (0xC0100000)
46
47config SYS_MMCSD_RAW_MODE_U_BOOT_PARTITION_MMC2
48	hex "Partition on MMC2 to use to load U-Boot from"
49	depends on SYS_MMCSD_RAW_MODE_U_BOOT_USE_PARTITION
50	default 1
51	help
52	  Partition on the second MMC to load U-Boot from when the MMC is being
53	  used in raw mode
54
55source "board/st/stm32mp1/Kconfig"
56
57# currently activated for debug / should be deactivated for real product
58if DEBUG_UART
59
60config DEBUG_UART_BOARD_INIT
61	default y
62
63# debug on UART4 by default
64config DEBUG_UART_BASE
65	default 0x40010000
66
67# clock source is HSI on reset
68config DEBUG_UART_CLOCK
69	default 64000000
70endif
71
72endif
73