1if ARCH_STM32MP 2 3config SPL 4 select SPL_BOARD_INIT 5 select SPL_CLK 6 select SPL_DM 7 select SPL_DM_SEQ_ALIAS 8 select SPL_FRAMEWORK 9 select SPL_GPIO_SUPPORT 10 select SPL_LIBCOMMON_SUPPORT 11 select SPL_LIBGENERIC_SUPPORT 12 select SPL_OF_CONTROL 13 select SPL_OF_TRANSLATE 14 select SPL_PINCTRL 15 select SPL_REGMAP 16 select SPL_RESET_SUPPORT 17 select SPL_SERIAL_SUPPORT 18 select SPL_SYSCON 19 select SPL_DRIVERS_MISC_SUPPORT 20 imply SPL_LIBDISK_SUPPORT 21 22config SYS_SOC 23 default "stm32mp" 24 25config TARGET_STM32MP1 26 bool "Support stm32mp1xx" 27 select ARCH_SUPPORT_PSCI 28 select CPU_V7A 29 select CPU_V7_HAS_NONSEC 30 select CPU_V7_HAS_VIRT 31 select PINCTRL_STM32 32 select STM32_RESET 33 select SYS_ARCH_TIMER 34 select SYSRESET_SYSCON 35 help 36 target STMicroelectronics SOC STM32MP1 family 37 STMicroelectronics MPU with core ARMv7 38 39config SYS_TEXT_BASE 40 prompt "U-Boot base address" 41 default 0xC0100000 42 help 43 configure the U-Boot base address 44 when DDR driver is used: 45 DDR + 1MB (0xC0100000) 46 47config SYS_MMCSD_RAW_MODE_U_BOOT_PARTITION_MMC2 48 hex "Partition on MMC2 to use to load U-Boot from" 49 depends on SYS_MMCSD_RAW_MODE_U_BOOT_USE_PARTITION 50 default 1 51 help 52 Partition on the second MMC to load U-Boot from when the MMC is being 53 used in raw mode 54 55source "board/st/stm32mp1/Kconfig" 56 57# currently activated for debug / should be deactivated for real product 58if DEBUG_UART 59 60config DEBUG_UART_BOARD_INIT 61 default y 62 63# debug on UART4 by default 64config DEBUG_UART_BASE 65 default 0x40010000 66 67# clock source is HSI on reset 68config DEBUG_UART_CLOCK 69 default 64000000 70endif 71 72endif 73