xref: /openbmc/linux/drivers/bus/Kconfig (revision e15a5365)
1# SPDX-License-Identifier: GPL-2.0
2#
3# Bus Devices
4#
5
6menu "Bus devices"
7
8config ARM_CCI
9	bool
10
11config ARM_CCI400_COMMON
12	bool
13	select ARM_CCI
14
15config ARM_CCI400_PORT_CTRL
16	bool
17	depends on ARM && OF && CPU_V7
18	select ARM_CCI400_COMMON
19	help
20	  Low level power management driver for CCI400 cache coherent
21	  interconnect for ARM platforms.
22
23config ARM_INTEGRATOR_LM
24	bool "ARM Integrator Logic Module bus"
25	depends on HAS_IOMEM
26	depends on ARCH_INTEGRATOR || COMPILE_TEST
27	default ARCH_INTEGRATOR
28	help
29	  Say y here to enable support for the ARM Logic Module bus
30	  found on the ARM Integrator AP (Application Platform)
31
32config BRCMSTB_GISB_ARB
33	bool "Broadcom STB GISB bus arbiter"
34	depends on ARM || ARM64 || MIPS
35	default ARCH_BRCMSTB || BMIPS_GENERIC
36	help
37	  Driver for the Broadcom Set Top Box System-on-a-chip internal bus
38	  arbiter. This driver provides timeout and target abort error handling
39	  and internal bus master decoding.
40
41config BT1_APB
42	bool "Baikal-T1 APB-bus driver"
43	depends on MIPS_BAIKAL_T1 || COMPILE_TEST
44	select REGMAP_MMIO
45	help
46	  Baikal-T1 AXI-APB bridge is used to access the SoC subsystem CSRs.
47	  IO requests are routed to this bus by means of the DW AMBA 3 AXI
48	  Interconnect. In case of any APB protocol collisions, slave device
49	  not responding on timeout an IRQ is raised with an erroneous address
50	  reported to the APB terminator (APB Errors Handler Block). This
51	  driver provides the interrupt handler to detect the erroneous
52	  address, prints an error message about the address fault, updates an
53	  errors counter. The counter and the APB-bus operations timeout can be
54	  accessed via corresponding sysfs nodes.
55
56config BT1_AXI
57	bool "Baikal-T1 AXI-bus driver"
58	depends on MIPS_BAIKAL_T1 || COMPILE_TEST
59	select MFD_SYSCON
60	help
61	  AXI3-bus is the main communication bus connecting all high-speed
62	  peripheral IP-cores with RAM controller and with MIPS P5600 cores on
63	  Baikal-T1 SoC. Traffic arbitration is done by means of DW AMBA 3 AXI
64	  Interconnect (so called AXI Main Interconnect) routing IO requests
65	  from one SoC block to another. This driver provides a way to detect
66	  any bus protocol errors and device not responding situations by
67	  means of an embedded on top of the interconnect errors handler
68	  block (EHB). AXI Interconnect QoS arbitration tuning is currently
69	  unsupported.
70
71config MOXTET
72	tristate "CZ.NIC Turris Mox module configuration bus"
73	depends on SPI_MASTER && OF
74	help
75	  Say yes here to add support for the module configuration bus found
76	  on CZ.NIC's Turris Mox. This is needed for the ability to discover
77	  the order in which the modules are connected and to get/set some of
78	  their settings. For example the GPIOs on Mox SFP module are
79	  configured through this bus.
80
81config HISILICON_LPC
82	bool "Support for ISA I/O space on HiSilicon Hip06/7"
83	depends on (ARM64 && ARCH_HISI) || (COMPILE_TEST && !ALPHA && !HEXAGON && !PARISC && !C6X)
84	depends on HAS_IOMEM
85	select INDIRECT_PIO if ARM64
86	help
87	  Driver to enable I/O access to devices attached to the Low Pin
88	  Count bus on the HiSilicon Hip06/7 SoC.
89
90config IMX_WEIM
91	bool "Freescale EIM DRIVER"
92	depends on ARCH_MXC
93	help
94	  Driver for i.MX WEIM controller.
95	  The WEIM(Wireless External Interface Module) works like a bus.
96	  You can attach many different devices on it, such as NOR, onenand.
97
98config MIPS_CDMM
99	bool "MIPS Common Device Memory Map (CDMM) Driver"
100	depends on CPU_MIPSR2 || CPU_MIPSR5
101	help
102	  Driver needed for the MIPS Common Device Memory Map bus in MIPS
103	  cores. This bus is for per-CPU tightly coupled devices such as the
104	  Fast Debug Channel (FDC).
105
106	  For this to work, either your bootloader needs to enable the CDMM
107	  region at an unused physical address on the boot CPU, or else your
108	  platform code needs to implement mips_cdmm_phys_base() (see
109	  asm/cdmm.h).
110
111config MVEBU_MBUS
112	bool
113	depends on PLAT_ORION
114	help
115	  Driver needed for the MBus configuration on Marvell EBU SoCs
116	  (Kirkwood, Dove, Orion5x, MV78XX0 and Armada 370/XP).
117
118config OMAP_INTERCONNECT
119	tristate "OMAP INTERCONNECT DRIVER"
120	depends on ARCH_OMAP2PLUS
121
122	help
123	  Driver to enable OMAP interconnect error handling driver.
124
125config OMAP_OCP2SCP
126	tristate "OMAP OCP2SCP DRIVER"
127	depends on ARCH_OMAP2PLUS
128	help
129	  Driver to enable ocp2scp module which transforms ocp interface
130	  protocol to scp protocol. In OMAP4, USB PHY is connected via
131	  OCP2SCP and in OMAP5, both USB PHY and SATA PHY is connected via
132	  OCP2SCP.
133
134config QCOM_EBI2
135	bool "Qualcomm External Bus Interface 2 (EBI2)"
136	depends on HAS_IOMEM
137	depends on ARCH_QCOM || COMPILE_TEST
138	default ARCH_QCOM
139	help
140	  Say y here to enable support for the Qualcomm External Bus
141	  Interface 2, which can be used to connect things like NAND Flash,
142	  SRAM, ethernet adapters, FPGAs and LCD displays.
143
144config SIMPLE_PM_BUS
145	tristate "Simple Power-Managed Bus Driver"
146	depends on OF && PM
147	help
148	  Driver for transparent busses that don't need a real driver, but
149	  where the bus controller is part of a PM domain, or under the control
150	  of a functional clock, and thus relies on runtime PM for managing
151	  this PM domain and/or clock.
152	  An example of such a bus controller is the Renesas Bus State
153	  Controller (BSC, sometimes called "LBSC within Bus Bridge", or
154	  "External Bus Interface") as found on several Renesas ARM SoCs.
155
156config SUN50I_DE2_BUS
157	bool "Allwinner A64 DE2 Bus Driver"
158	  default ARM64
159	  depends on ARCH_SUNXI
160	  select SUNXI_SRAM
161	  help
162	  Say y here to enable support for Allwinner A64 DE2 bus driver. It's
163	  mostly transparent, but a SRAM region needs to be claimed in the SRAM
164	  controller to make the all blocks in the DE2 part accessible.
165
166config SUNXI_RSB
167	tristate "Allwinner sunXi Reduced Serial Bus Driver"
168	  default MACH_SUN8I || MACH_SUN9I || ARM64
169	  depends on ARCH_SUNXI
170	  select REGMAP
171	  help
172	  Say y here to enable support for Allwinner's Reduced Serial Bus
173	  (RSB) support. This controller is responsible for communicating
174	  with various RSB based devices, such as AXP223, AXP8XX PMICs,
175	  and AC100/AC200 ICs.
176
177config TEGRA_ACONNECT
178	tristate "Tegra ACONNECT Bus Driver"
179	depends on ARCH_TEGRA_210_SOC
180	depends on OF && PM
181	help
182	  Driver for the Tegra ACONNECT bus which is used to interface with
183	  the devices inside the Audio Processing Engine (APE) for Tegra210.
184
185config TEGRA_GMI
186	tristate "Tegra Generic Memory Interface bus driver"
187	depends on ARCH_TEGRA
188	help
189	  Driver for the Tegra Generic Memory Interface bus which can be used
190	  to attach devices such as NOR, UART, FPGA and more.
191
192config  TI_PWMSS
193	bool
194	default y if (ARCH_OMAP2PLUS) && (PWM_TIECAP || PWM_TIEHRPWM || TI_EQEP)
195	help
196	  PWM Subsystem driver support for AM33xx SOC.
197
198	  PWM submodules require PWM config space access from submodule
199	  drivers and require common parent driver support.
200
201config TI_SYSC
202	bool "TI sysc interconnect target module driver"
203	depends on ARCH_OMAP2PLUS
204	help
205	  Generic driver for Texas Instruments interconnect target module
206	  found on many TI SoCs.
207
208config TS_NBUS
209	tristate "Technologic Systems NBUS Driver"
210	depends on SOC_IMX28
211	depends on OF_GPIO && PWM
212	help
213	  Driver for the Technologic Systems NBUS which is used to interface
214	  with the peripherals in the FPGA of the TS-4600 SoM.
215
216config UNIPHIER_SYSTEM_BUS
217	tristate "UniPhier System Bus driver"
218	depends on ARCH_UNIPHIER && OF
219	default y
220	help
221	  Support for UniPhier System Bus, a simple external bus.  This is
222	  needed to use on-board devices connected to UniPhier SoCs.
223
224config VEXPRESS_CONFIG
225	tristate "Versatile Express configuration bus"
226	default y if ARCH_VEXPRESS
227	depends on ARM || ARM64
228	depends on OF
229	select REGMAP
230	help
231	  Platform configuration infrastructure for the ARM Ltd.
232	  Versatile Express.
233
234config DA8XX_MSTPRI
235	bool "TI da8xx master peripheral priority driver"
236	depends on ARCH_DAVINCI_DA8XX
237	help
238	  Driver for Texas Instruments da8xx master peripheral priority
239	  configuration. Allows to adjust the priorities of all master
240	  peripherals.
241
242source "drivers/bus/fsl-mc/Kconfig"
243source "drivers/bus/mhi/Kconfig"
244
245endmenu
246