1# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
2%YAML 1.2
3---
4$id: http://devicetree.org/schemas/pci/fsl,imx6q-pcie.yaml#
5$schema: http://devicetree.org/meta-schemas/core.yaml#
6
7title: Freescale i.MX6 PCIe host controller
8
9maintainers:
10  - Lucas Stach <l.stach@pengutronix.de>
11  - Richard Zhu <hongxing.zhu@nxp.com>
12
13description: |+
14  This PCIe host controller is based on the Synopsys DesignWare PCIe IP
15  and thus inherits all the common properties defined in snps,dw-pcie.yaml.
16
17allOf:
18  - $ref: /schemas/pci/snps,dw-pcie.yaml#
19
20properties:
21  compatible:
22    enum:
23      - fsl,imx6q-pcie
24      - fsl,imx6sx-pcie
25      - fsl,imx6qp-pcie
26      - fsl,imx7d-pcie
27      - fsl,imx8mq-pcie
28      - fsl,imx8mm-pcie
29      - fsl,imx8mp-pcie
30
31  reg:
32    items:
33      - description: Data Bus Interface (DBI) registers.
34      - description: PCIe configuration space region.
35
36  reg-names:
37    items:
38      - const: dbi
39      - const: config
40
41  interrupts:
42    items:
43      - description: builtin MSI controller.
44
45  interrupt-names:
46    items:
47      - const: msi
48
49  clocks:
50    minItems: 3
51    items:
52      - description: PCIe bridge clock.
53      - description: PCIe bus clock.
54      - description: PCIe PHY clock.
55      - description: Additional required clock entry for imx6sx-pcie,
56          imx8mq-pcie.
57
58  clock-names:
59    minItems: 3
60    items:
61      - const: pcie
62      - const: pcie_bus
63      - const: pcie_phy
64      - const: pcie_inbound_axi for imx6sx-pcie, pcie_aux for imx8mq-pcie
65
66  num-lanes:
67    const: 1
68
69  fsl,imx7d-pcie-phy:
70    $ref: /schemas/types.yaml#/definitions/phandle
71    description: A phandle to an fsl,imx7d-pcie-phy node. Additional
72      required properties for imx7d-pcie and imx8mq-pcie.
73
74  power-domains:
75    items:
76      - description: The phandle pointing to the DISPLAY domain for
77          imx6sx-pcie, to PCIE_PHY power domain for imx7d-pcie and
78          imx8mq-pcie.
79      - description: The phandle pointing to the PCIE_PHY power domains
80          for imx6sx-pcie.
81
82  power-domain-names:
83    items:
84      - const: pcie
85      - const: pcie_phy
86
87  resets:
88    maxItems: 3
89    description: Phandles to PCIe-related reset lines exposed by SRC
90      IP block. Additional required by imx7d-pcie and imx8mq-pcie.
91
92  reset-names:
93    items:
94      - const: pciephy
95      - const: apps
96      - const: turnoff
97
98  fsl,tx-deemph-gen1:
99    description: Gen1 De-emphasis value (optional required).
100    $ref: /schemas/types.yaml#/definitions/uint32
101    default: 0
102
103  fsl,tx-deemph-gen2-3p5db:
104    description: Gen2 (3.5db) De-emphasis value (optional required).
105    $ref: /schemas/types.yaml#/definitions/uint32
106    default: 0
107
108  fsl,tx-deemph-gen2-6db:
109    description: Gen2 (6db) De-emphasis value (optional required).
110    $ref: /schemas/types.yaml#/definitions/uint32
111    default: 20
112
113  fsl,tx-swing-full:
114    description: Gen2 TX SWING FULL value (optional required).
115    $ref: /schemas/types.yaml#/definitions/uint32
116    default: 127
117
118  fsl,tx-swing-low:
119    description: TX launch amplitude swing_low value (optional required).
120    $ref: /schemas/types.yaml#/definitions/uint32
121    default: 127
122
123  fsl,max-link-speed:
124    description: Specify PCI Gen for link capability (optional required).
125      Note that the IMX6 LVDS clock outputs do not meet gen2 jitter
126      requirements and thus for gen2 capability a gen2 compliant clock
127      generator should be used and configured.
128    $ref: /schemas/types.yaml#/definitions/uint32
129    enum: [1, 2, 3, 4]
130    default: 1
131
132  phys:
133    maxItems: 1
134
135  phy-names:
136    const: pcie-phy
137
138  reset-gpio:
139    description: Should specify the GPIO for controlling the PCI bus device
140      reset signal. It's not polarity aware and defaults to active-low reset
141      sequence (L=reset state, H=operation state) (optional required).
142
143  reset-gpio-active-high:
144    description: If present then the reset sequence using the GPIO
145      specified in the "reset-gpio" property is reversed (H=reset state,
146      L=operation state) (optional required).
147    type: boolean
148
149  vpcie-supply:
150    description: Should specify the regulator in charge of PCIe port power.
151      The regulator will be enabled when initializing the PCIe host and
152      disabled either as part of the init process or when shutting down
153      the host (optional required).
154
155  vph-supply:
156    description: Should specify the regulator in charge of VPH one of
157      the three PCIe PHY powers. This regulator can be supplied by both
158      1.8v and 3.3v voltage supplies (optional required).
159
160required:
161  - compatible
162  - reg
163  - reg-names
164  - "#address-cells"
165  - "#size-cells"
166  - device_type
167  - bus-range
168  - ranges
169  - num-lanes
170  - interrupts
171  - interrupt-names
172  - "#interrupt-cells"
173  - interrupt-map-mask
174  - interrupt-map
175  - clocks
176  - clock-names
177
178unevaluatedProperties: false
179
180examples:
181  - |
182    #include <dt-bindings/clock/imx6qdl-clock.h>
183    #include <dt-bindings/interrupt-controller/arm-gic.h>
184
185    pcie: pcie@1ffc000 {
186        compatible = "fsl,imx6q-pcie";
187        reg = <0x01ffc000 0x04000>,
188              <0x01f00000 0x80000>;
189        reg-names = "dbi", "config";
190        #address-cells = <3>;
191        #size-cells = <2>;
192        device_type = "pci";
193        bus-range = <0x00 0xff>;
194        ranges = <0x81000000 0 0          0x01f80000 0 0x00010000>,
195                 <0x82000000 0 0x01000000 0x01000000 0 0x00f00000>;
196        num-lanes = <1>;
197        interrupts = <GIC_SPI 120 IRQ_TYPE_LEVEL_HIGH>;
198        interrupt-names = "msi";
199        #interrupt-cells = <1>;
200        interrupt-map-mask = <0 0 0 0x7>;
201        interrupt-map = <0 0 0 1 &gpc GIC_SPI 123 IRQ_TYPE_LEVEL_HIGH>,
202                        <0 0 0 2 &gpc GIC_SPI 122 IRQ_TYPE_LEVEL_HIGH>,
203                        <0 0 0 3 &gpc GIC_SPI 121 IRQ_TYPE_LEVEL_HIGH>,
204                        <0 0 0 4 &gpc GIC_SPI 120 IRQ_TYPE_LEVEL_HIGH>;
205        clocks = <&clks IMX6QDL_CLK_PCIE_AXI>,
206                <&clks IMX6QDL_CLK_LVDS1_GATE>,
207                <&clks IMX6QDL_CLK_PCIE_REF_125M>;
208        clock-names = "pcie", "pcie_bus", "pcie_phy";
209    };
210...
211