Home
last modified time | relevance | path

Searched refs:transmission (Results 1 – 25 of 172) sorted by relevance

1234567

/openbmc/openbmc/meta-openembedded/meta-oe/recipes-connectivity/transmission/
H A Dtransmission_4.0.6.bb11 gitsm://github.com/transmission/transmission;branch=4.0.x;protocol=https \
12 file://transmission-daemon \
30 # Weak default values for transmission user and group
37 sed -i '/USERNAME=/c\USERNAME=${TRANSMISSION_USER}' ${UNPACKDIR}/transmission-daemon
39 install -m 0744 ${UNPACKDIR}/transmission-daemon ${D}${sysconfdir}/init.d/
40 chown ${TRANSMISSION_USER}:${TRANSMISSION_GROUP} ${D}${sysconfdir}/init.d/transmission-daemon
44 sed -i '/User=/c\User=${TRANSMISSION_USER}' ${S}/daemon/transmission-daemon.service
46 install -m 0644 ${S}/daemon/transmission-daemon.service ${D}${systemd_unitdir}/system
52 …= "${bindir}/transmission-remote ${bindir}/transmission-cli ${bindir}/transmission-create ${bindir…
53 FILES:${PN}-gtk += "${bindir}/transmission-gtk ${datadir}/icons ${datadir}/applications ${datadir}/…
[all …]
/openbmc/linux/drivers/staging/pi433/Documentation/
H A Dpi433.txt9 (www.pi433.de). It supports transmission and reception. It can be opened
10 by multiple applications for transmission and reception. While transmit
20 a) transmission
22 Each transmission can take place with a different configuration of the rf
24 takes care, that each transmission takes place with the parameterset of the
25 application, that requests the transmission. To allow the transmission to take
33 the air, the rf module is set to standby, the parameters for transmission gets
34 set, the hardware fifo of the rf chip gets preloaded and the transmission gets
38 transmission cycle ends.
48 interrupted by the transmission thread at any time to insert a transmission cycle.
[all …]
/openbmc/linux/Documentation/ABI/stable/
H A Dfirewire-cdev20 - Asynchronous request transmission
28 - Isochronous stream transmission and reception
29 - Asynchronous stream transmission and reception
30 - Asynchronous broadcast request transmission
31 - PHY packet transmission and reception
43 an address range, asynchronous response transmission
55 - PHY packet transmission and reception
87 Allocate a DMA buffer for isochronous reception or transmission
92 for transmission, flags = MAP_SHARED, fd = the handle to the
/openbmc/linux/Documentation/devicetree/bindings/hsi/
H A Dclient-devices.txt9 - hsi-rx-mode: Receiver Bit transmission mode ("stream" or "frame")
10 - hsi-tx-mode: Transmitter Bit transmission mode ("stream" or "frame")
12 the transmission mode is the same for receiver and
14 - hsi-speed-kbps: Max bit transmission speed in kbit/s
/openbmc/linux/Documentation/admin-guide/media/
H A Dsi4713.rst17 Basically, it has transmission and signal noise level measurement features.
19 The Si4713 integrates transmit functions for FM broadcast stereo transmission.
26 Users must comply with local regulations on radio frequency (RF) transmission.
126 - power_level - Sets the output power level for signal transmission.
132 - rds_ps_name - Sets the RDS ps name field for transmission.
133 - rds_radio_text - Sets the RDS radio text for transmission.
134 - rds_pi - Sets the RDS PI field for transmission.
135 - rds_pty - Sets the RDS PTY field for transmission.
139 - preemphasis - sets the preemphasis to be applied for transmission.
179 transmission. To do that use S/G_MODULATOR ioctl and configure txsubchans properly.
/openbmc/openbmc/meta-openembedded/meta-oe/recipes-connectivity/transmission/files/
H A Dtransmission-daemon31 USERNAME=transmission
53 NAME=transmission-daemon
/openbmc/linux/Documentation/userspace-api/media/v4l/
H A Dext-ctrls-fm-tx.rst12 limiter, RDS transmission and tuning power features.
30 Sets the RDS Programme Identification field for transmission.
33 Sets the RDS Programme Type field for transmission. This encodes up
37 Sets the Programme Service name (PS_NAME) for transmission. It is
49 Sets the Radio Text info for transmission. It is a textual
172 Sets the output power level for signal transmission. Unit is in
/openbmc/linux/Documentation/networking/
H A Dmac80211-injection.rst40 legacy rate for the transmission (only for devices without own rate control)
44 HT rate for the transmission (only for devices without own rate control).
59 VHT mcs and number of streams used in the transmission (only for devices
H A Dpacket_mmap.rst37 transmission, multiple packets can be sent through one system call to get the
42 transmission process, but it isn't everything. At least, if you are capturing
46 enabled. For transmission, check the MTU (Maximum Transmission Unit) used and
95 for capture and transmission. This can be done by mapping the
103 How to use mmap() directly to improve transmission process
107 [setup] socket() -------> creation of the transmission socket
110 bind() ---------> bind transmission socket with a network interface
114 [transmission] poll() ---------> wait for free packets (optional)
120 [shutdown] close() --------> destruction of the transmission socket and
418 To use one socket for capture and transmission, the mapping of both the
[all …]
/openbmc/linux/net/can/j1939/
H A Dtransport.c254 if (!session->transmission) in __j1939_session_drop()
265 if (session->transmission) { in j1939_session_destroy()
525 session->transmission == transmitter) in j1939_session_get_by_addr_locked()
1124 !session->transmission, in __j1939_session_cancel()
1159 if (session->transmission) in j1939_tp_txtimer()
1215 if (!session->transmission) { in j1939_session_completed()
1456 if (session->transmission) { in j1939_xtp_rx_cts_one()
1569 session->transmission); in j1939_session_activate()
1682 if (!session->transmission) { in j1939_xtp_rx_rts_session_active()
1699 if (session->transmission) in j1939_xtp_rx_rts_session_active()
[all …]
/openbmc/linux/Documentation/sound/cards/
H A Dhdspm.rst18 Audio transmission
21 * number of channels -- depends on transmission mode
32 (Note: Choosing the 56channel mode for transmission or as
41 transmission/receive-mode , only 28 are transmitted/received
50 transmission/receive-mode , only 14 are transmitted/received
183 MADI-transmission (0).
/openbmc/linux/Documentation/sound/designs/
H A Dtracepoints.rst30 In a design of ALSA PCM core, data transmission is abstracted as PCM substream.
31 Applications manage PCM substream to maintain data transmission for PCM frames.
32 Before starting the data transmission, applications need to configure PCM
111 a care of hardware design or data transmission protocol.
/openbmc/openbmc/meta-openembedded/meta-networking/recipes-protocols/pptp-linux/pptp-linux/
H A Doptions.pptp12 # Turn off transmission protocols we know won't be used
/openbmc/linux/Documentation/devicetree/bindings/media/
H A Dnokia,n900-ir5 - pwms: specifies PWM used for IR signal transmission.
/openbmc/linux/Documentation/ABI/testing/
H A Dsysfs-class-led-trigger-netdev40 Signal transmission of data on the named network device.
42 If set to 0 (default), the LED will not blink on transmission.
45 in interval to signal transmission.
H A Dsysfs-class-net-statistics131 during transmission by a network device (e.g: because of
144 transmission.
169 Indicates the number of packets dropped during transmission.
178 Indicates the number of packets in error during transmission by
/openbmc/openbmc/meta-openembedded/meta-multimedia/recipes-multimedia/libiec61883/
H A Dlibiec61883_1.2.0.bb2 libraw1394 for transmission, reception, and management of media streams and \
/openbmc/u-boot/Documentation/devicetree/bindings/misc/
H A Dgdsys,io-endpoint.txt3 The IO endpoint of IHS FPGA devices is a packet-based transmission interface
/openbmc/linux/sound/soc/sprd/
H A DKconfig15 is used for sound stream transmission between audio subsystem
/openbmc/linux/drivers/net/wireless/purelifi/plfxlc/
H A DKconfig8 802.11 OFDM PHY but uses light as the transmission medium.
/openbmc/linux/Documentation/devicetree/bindings/sound/
H A Dsprd-mcdt.txt4 transmission between audio subsystem and other AP/CP subsystem. It
H A Dsirf-audio-port.txt10 One of the DMA channels will be responsible for transmission (should be
H A Dbrcm,bcm2835-i2s.txt11 One of the DMA channels will be responsible for transmission (should be
/openbmc/linux/arch/arm/include/debug/
H A Dat91.S33 tst \rd, #AT91_DBGU_TXEMPTY @ DBGU_TXEMPTY = 1 when transmission complete
/openbmc/linux/Documentation/driver-api/nfc/
H A Dnfc-pn544.rst9 The PN544 is an integrated transmission module for contactless

1234567