Searched refs:latched (Results 1 – 13 of 13) sorted by relevance
/openbmc/linux/sound/soc/codecs/ |
H A D | tas2764.c | 66 u8 latched[6] = {0, 0, 0, 0, 0, 0}; in tas2764_irq() local 70 for (i = 0; i < ARRAY_SIZE(latched); i++) in tas2764_irq() 71 latched[i] = snd_soc_component_read(tas2764->component, in tas2764_irq() 75 if (latched[0] & BIT(i)) { in tas2764_irq() 82 if (latched[0]) { in tas2764_irq() 84 latched[1], latched[2], latched[3], latched[4], latched[5]); in tas2764_irq()
|
/openbmc/linux/Documentation/devicetree/bindings/input/touchscreen/ |
H A D | eeti.txt | 10 latched. This is necessary for platforms that lack
|
/openbmc/phosphor-power/phosphor-regulators/docs/config_file/ |
H A D | or.md | 9 executed, such as a register read that clears latched fault bits.
|
H A D | and.md | 9 executed, such as a register read that clears latched fault bits.
|
/openbmc/linux/Documentation/virt/kvm/devices/ |
H A D | arm-vgic-v3.rst | 132 GICR_ISPENDR0 registers get/set the value of the latched pending state for 139 to ISPENDR) this state is "latched", and only cleared when either the 143 ISPENDR writes are latched; if the device lowers the line level then the
|
/openbmc/u-boot/arch/arm/mach-uniphier/ |
H A D | Kconfig | 100 The boot mode pins are latched when the system reset is deasserted
|
/openbmc/linux/Documentation/hwmon/ |
H A D | w83792d.rst | 108 which triggers if your computer case is open (This one is latched, contrary
|
/openbmc/linux/Documentation/sound/designs/ |
H A D | timestamping.rst | 137 latched by a low-level audio subsystem, and the information provided
|
/openbmc/linux/Documentation/ABI/testing/ |
H A D | sysfs-timecard | 251 on PCI latencies, and when the PHC time was latched
|
/openbmc/u-boot/doc/ |
H A D | README.uniphier | 394 shows the boot mode pins that has been latched at the power-on reset
|
/openbmc/linux/drivers/scsi/aic7xxx/ |
H A D | aic7xxx.seq | 424 /* Save latched contents */ 1963 * latched (the usual way), then read the data byte directly off the bus
|
H A D | aic79xx.seq | 1422 * So we wait until SCSIDATL is latched (the usual way), then read the data
|
/openbmc/linux/Documentation/virt/kvm/x86/ |
H A D | timekeeping.rst | 110 for (N-1)/2 counts. Only even values are latched by the counter, so odd
|