| /openbmc/u-boot/drivers/net/ |
| H A D | ne2000.c | 182 PRINTK("cmd (at %lx) is %x\n", addr + E8390_CMD, n2k_inb(E8390_CMD)); in pcnet_reset_8390()
184 PRINTK("cmd (at %lx) is %x\n", addr + E8390_CMD, n2k_inb(E8390_CMD)); in pcnet_reset_8390()
186 PRINTK("cmd (at %lx) is %x\n", addr + E8390_CMD, n2k_inb(E8390_CMD)); in pcnet_reset_8390()
194 PRINTK("got %x in reset\n", r); in pcnet_reset_8390()
225 PRINTK ("trying to get MAC via prom reading\n"); in get_prom()
234 PRINTK ("PROM:"); in get_prom()
237 PRINTK (" %02x", prom[i]); in get_prom()
239 PRINTK ("\n"); in get_prom()
244 PRINTK ("matched board %d\n", i); in get_prom()
249 PRINTK ("on exit i is %d/%ld\n", i, NR_INFO); in get_prom()
[all …]
|
| H A D | ne2000_base.c | 661 PRINTK("pushed len = %d\n", len); in uboot_push_packet_len()
673 PRINTK("pushed key = %d\n", key); in uboot_push_tx_done()
686 PRINTK("### ne2k_setup_driver\n"); in ne2k_setup_driver()
700 PRINTK("CCR before is %x\n", *p); in ne2k_setup_driver()
702 PRINTK("CCR after is %x\n", *p); in ne2k_setup_driver()
766 PRINTK("Packet sucesfully sent\n"); in ne2k_send()
|
| H A D | ne2000_base.h | 101 #define PRINTK(args...) printf(args) macro
105 #define PRINTK(args...) macro
|
| H A D | lan91c96.c | 85 #define PRINTK(args...) printf(args) macro
87 #define PRINTK(args...) macro
716 PRINTK("Using MAC Address %pM\n", v_mac); in smc_get_ethaddr()
|
| H A D | smc91111.c | 101 #define PRINTK(args...) printf(args) macro
103 #define PRINTK(args...) macro
|
| /openbmc/linux/drivers/atm/ |
| H A D | nicstar.c | 92 #define PRINTK(args...) printk(args) macro
94 #define PRINTK(args...) do {} while (0) macro
226 PRINTK("nicstar%d: freeing %d huge buffers.\n", i, card->hbpool.count); in nicstar_remove_one()
231 PRINTK("nicstar%d: %d huge buffers freed.\n", i, j); in nicstar_remove_one()
233 PRINTK("nicstar%d: freeing %d iovec buffers.\n", i, in nicstar_remove_one()
239 PRINTK("nicstar%d: %d iovec buffers freed.\n", i, j); in nicstar_remove_one()
283 PRINTK("nicstar: General debug enabled.\n"); in nicstar_init()
400 PRINTK("nicstar%d: membase at 0x%p.\n", i, card->membase); in ns_init_card()
412 PRINTK("nicstar%d: setting PCI latency timer to %d.\n", i, in ns_init_card()
497 PRINTK("nicstar%d: %dK x 32bit SRAM size.\n", i, card->sram_size); in ns_init_card()
[all …]
|
| /openbmc/linux/drivers/net/ethernet/smsc/ |
| H A D | smc9194.c | 159 #define PRINTK(x) printk x macro
161 #define PRINTK(x) macro
590 PRINTK((CARDNAME": In XMIT with no packet to send\n")); in smc_hardware_send_packet()
1139 PRINTK((CARDNAME ": WARNING: smc_rcv with nothing on FIFO.\n")); in smc_rcv()
1404 PRINTK((CARDNAME ": UNSUPPORTED: EPH INTERRUPT\n")); in smc_interrupt()
1406 PRINTK((CARDNAME ": UNSUPPORTED: ERCV INTERRUPT\n")); in smc_interrupt()
|
| H A D | smc91x.c | 150 #define PRINTK(dev, fmt, ...) \ macro
408 PRINTK(dev, "smc_rcv with nothing on FIFO.\n"); in smc_rcv()
714 PRINTK(dev, "smc_tx with nothing on FIFO.\n"); in smc_tx()
735 PRINTK(dev, "%s occurred on last xmit\n", in smc_tx()
1282 PRINTK(dev, "UNSUPPORTED: ERCV INTERRUPT\n"); in smc_interrupt()
1293 PRINTK(dev, "spurious interrupt (mask = 0x%02x)\n", in smc_interrupt()
1341 PRINTK(dev, "TX timeout (INT 0x%02x INTMASK 0x%02x MEM 0x%04x FIFO 0x%04x EPH_ST 0x%04x)\n", in smc_timeout()
2042 PRINTK(dev, "No PHY found\n"); in smc_probe()
2044 PRINTK(dev, "PHY LAN83C183 (LAN91C111 Internal)\n"); in smc_probe()
2046 PRINTK(dev, "PHY LAN83C180\n"); in smc_probe()
|
| /openbmc/linux/arch/ia64/ |
| H A D | Kconfig.debug | 42 depends on DEBUG_KERNEL && PRINTK
|
| /openbmc/linux/arch/sh/ |
| H A D | Kconfig.debug | 18 depends on DEBUG_KERNEL && PRINTK
|
| /openbmc/linux/Documentation/driver-api/usb/ |
| H A D | usb3-debug-port.rst | 35 EARLY PRINTK
|
| /openbmc/linux/lib/ |
| H A D | Kconfig.debug | 8 depends on PRINTK
23 depends on PRINTK
40 depends on PRINTK
92 depends on DEBUG_KERNEL && PRINTK && GENERIC_CALIBRATE_DELAY
111 depends on PRINTK
182 depends on PRINTK
193 default y if PRINTK
|
| /openbmc/linux/init/ |
| H A D | Kconfig | 736 depends on PRINTK
757 depends on PRINTK
789 depends on PRINTK && DEBUG_FS
1552 config PRINTK config
|
| /openbmc/linux/kernel/trace/ |
| H A D | trace.h | 1231 C(PRINTK, "trace_printk"), \
|
| /openbmc/linux/drivers/tty/serial/ |
| H A D | Kconfig | 1318 depends on PRINTK
|
| /openbmc/linux/ |
| H A D | MAINTAINERS | 17245 PRINTK
17255 PRINTK INDEXING
|