Home
last modified time | relevance | path

Searched refs:DTR (Results 1 – 25 of 39) sorted by relevance

12

/openbmc/linux/arch/arm/boot/dts/ti/omap/
H A Dam335x-netcom-plus-2xx.dts27 AM33XX_PADCONF(AM335X_PIN_LCD_VSYNC, PIN_OUTPUT_PULLDOWN, MUX_MODE7) /* DTR */
40 AM33XX_PADCONF(AM335X_PIN_GPMC_AD12, PIN_OUTPUT_PULLDOWN, MUX_MODE7) /* DTR */
H A Dam335x-baltos-ir3220.dts33 …XX_PADCONF(AM335X_PIN_LCD_VSYNC, PIN_OUTPUT_PULLDOWN, MUX_MODE7) /* lcd_vsync.gpio2[22] DTR */
46 …XX_PADCONF(AM335X_PIN_GPMC_AD12, PIN_OUTPUT_PULLDOWN, MUX_MODE7) /* gpmc_ad12.gpio1[12] DTR */
H A Dam335x-baltos-ir5221.dts41 …XX_PADCONF(AM335X_PIN_LCD_VSYNC, PIN_OUTPUT_PULLDOWN, MUX_MODE7) /* lcd_vsync.gpio2[22] DTR */
54 …XX_PADCONF(AM335X_PIN_GPMC_AD12, PIN_OUTPUT_PULLDOWN, MUX_MODE7) /* gpmc_ad12.gpio1[12] DTR */
H A Dam335x-baltos-ir2110.dts27 …XX_PADCONF(AM335X_PIN_LCD_VSYNC, PIN_OUTPUT_PULLDOWN, MUX_MODE7) /* lcd_vsync.gpio2[22] DTR */
/openbmc/linux/Documentation/devicetree/bindings/soc/fsl/cpm_qe/
H A Dserial.txt14 CTS, RTS, DCD, DSR, DTR, and RI.
/openbmc/linux/Documentation/devicetree/bindings/serial/
H A Dcirrus,clps711x-uart.txt11 - {rts,cts,dtr,dsr,rng,dcd}-gpios: specify a GPIO for RTS/CTS/DTR/DSR/RI/DCD
/openbmc/linux/drivers/tty/serial/
H A Dpmac_zilog.c534 set_bits |= DTR; in pmz_set_mctrl()
536 clear_bits |= DTR; in pmz_set_mctrl()
827 uap->curregs[R5] |= DTR; in __pmz_startup()
855 uap->curregs[R5] |= DTR; in pmz_irda_reset()
862 uap->curregs[R5] &= ~DTR; in pmz_irda_reset()
1128 uap->curregs[R5] |= DTR; in pmz_irda_setup()
1178 uap->curregs[R5] &= ~DTR; in pmz_irda_setup()
1889 write_zsreg(uap, R5, uap->curregs[5] | TxENABLE | RTS | DTR); in pmz_console_write()
H A Dzs.h152 #define DTR 0x80 /* DTR */ macro
H A Dip22zilog.h134 #define DTR 0x80 /* DTR */ macro
H A Dsunzilog.h126 #define DTR 0x80 /* DTR */ macro
H A Dpmac_zilog.h214 #define DTR 0x80 /* DTR */ macro
H A Dip22zilog.c555 set_bits |= DTR; in ip22zilog_set_mctrl()
557 clear_bits |= DTR; in ip22zilog_set_mctrl()
H A Dzs.c395 zport_a->regs[5] |= DTR; in zs_set_mctrl()
397 zport_a->regs[5] &= ~DTR; in zs_set_mctrl()
/openbmc/linux/drivers/net/hamradio/
H A Dz8530.h98 #define DTR 0x80 /* DTR */ macro
/openbmc/linux/arch/arm/boot/dts/nxp/imx/
H A Dimx6dl-eckelmann-ci4x10.dts240 MX6QDL_PAD_EIM_D24__GPIO3_IO24 0x0001b010 /* DTR */
252 MX6QDL_PAD_GPIO_18__GPIO7_IO13 0x0001b010 /* DTR */
H A Dimx6ull-colibri.dtsi610 pinctrl_uart1_ctrl1: uart1ctrl1grp { /* Additional DTR, DCD */
614 MX6UL_PAD_JTAG_TDO__GPIO1_IO12 0x90b1 /* SODIMM 23 / DTR */
/openbmc/u-boot/arch/arm/dts/
H A Dimx7-colibri.dtsi77 MX7D_PAD_SD2_DATA0__GPIO5_IO14 0x14 /* DTR */
H A Dimx6ull-colibri.dts416 pinctrl_uart1_ctrl1: uart1-ctrl1-grp { /* Additional DTR, DCD */
420 MX6UL_PAD_JTAG_TDO__GPIO1_IO12 0x1b0b1 /* DTR */
/openbmc/u-boot/arch/x86/include/asm/acpi/
H A Ddebug.asl35 Store(0x03, CMCR) /* DTR=1 RTS=1 out1/2=Off loop=Off */
/openbmc/linux/drivers/tty/
H A Dnozomi.c249 unsigned int DTR:1; member
306 unsigned int DTR:1; member
1477 ctrl.DTR = 1; in nozomi_card_exit()
1519 port->ctrl_ul.DTR = dtr; in set_dtr()
1664 | (ctrl_ul->DTR ? TIOCM_DTR : 0) in ntty_tiocmget()
/openbmc/linux/Documentation/arch/arm/sa1100/
H A Dassabet.rst255 - COM: TX, RX, CTS, DSR, DCD, RTS, DTR, PM
294 - COM1,2: TX, RX, CTS, DSR, DCD, RTS, DTR
/openbmc/linux/Documentation/driver-api/serial/
H A Dserial-rs485.rst20 toggling RTS or DTR signals. That can be used to control external
/openbmc/linux/Documentation/driver-api/tty/
H A Dmoxa-smartio.rst167 close_delay set the amount of time (in 1/100 of a second) that DTR
/openbmc/linux/arch/arm/boot/dts/nxp/vf/
H A Dvf610-zii-dev.dtsi196 * Attached MT25QL02 can go up to 90Mhz in DTR and 166 in STR
/openbmc/openbmc/meta-openembedded/meta-oe/recipes-connectivity/gammu/gammu/
H A Dgammurc62 ; If cable you use is not powered over DTR/RTS, try using -nopower variant of

12