Searched refs:CDP (Results 1 – 17 of 17) sorted by relevance
1 U-Boot has networking support for VLANs (802.1q), and CDP (Cisco8 CDP is used mainly to discover your device VLAN(s) when connected to11 Note: In order to enable CDP support a small change is needed in the15 Various defines control CDP; see the README section.
1 # Uncomment to start SNMP subagent and enable CDP, SONMP and EDP protocol
10 # discovery protocol. It also supports CDP, EDP and
76 [CDP] = { 0x00d0, 0x60, OMAP_DMA_REG_32BIT },
163 CDP, CNDP, CCDN, enumerator
138 tst r0, #0x08000000 @ only CDP/CPRT/LDC/STC have bit 27
325 r = net_loop(CDP); in do_cdp()
1320 Perform CDP network configuration
7 model = "Qualcomm MSM8960 CDP";
513 case CDP: in net_loop()1412 case CDP: in net_check_prereq()
531 BOOTP, RARP, ARP, TFTPGET, DHCP, PING, DNS, NFS, CDP, NETCONS, SNTP, enumerator
140 tristate "CFI Flash device mapped on AMD SC520 CDP"143 The SC520 CDP board has two banks of CFI-compliant chips and one
23 CDP (Code and Data Prioritization) "cdp_l3", "cdp_l2"50 L2 and L3 CDP are controlled separately.517 With CDP disabled the L3 schemata format is::521 L3 schemata file details (CDP enabled via mount option to resctrl)523 When CDP is enabled L3 control is split into two separate resources531 CDP is supported at L2 using the 'cdpl2' mount option. The schemata
441 omap_dma_chan_write(c, CDP, cdp); in omap_dma_start()450 omap_dma_chan_write(c, CDP, 0); in omap_dma_start()
598 "Unknown", "SDP", "DCP", "CDP", "ACA", "C", "PD",
71 AIR0701 "AIR 54CDP PCI/EISA System Board"72 AIR0702 "AIR 54CDP PCI/EISA Dual-Processors System Board"
1507 - CDP Options:1510 The device id used in CDP trigger frames.