Searched full:pulsed (Results 1 – 17 of 17) sorted by relevance
28 property is set, this output will be pulsed when the watchdog bites
16 pin is pulsed before reading from the device to
35 0=pulsed (dynamic) curr limiting
1086 * Note: The bit is only pulsed -> no lock on shared register needed in start()
73 iAQ-Core Continuous/Pulsed VOC (Volatile Organic Compounds)
322 * Bits 3-0 of the output port P2 of the keyboard controller may be pulsed in kbd_write_command()324 * command specify the output port bits to be pulsed. in kbd_write_command()325 * 0: Bit should be pulsed. 1: Bit should not be modified. in kbd_write_command()
88 #define ABB5ZES3_REG_TIM_CLK_TAM BIT(7) /* Permanent/pulsed timer A/int. 2 */89 #define ABB5ZES3_REG_TIM_CLK_TBM BIT(6) /* Permanent/pulsed timer B */617 * pulsed). in abb5zes3_rtc_check_setup()
122 driver is probed or resumed to share a pulsed reset line.
809 pulsed out. It is likely possible to disrupt the traffic on the pin by doing
145 #define Z8536_PAB_HANDSHAKE_HST_PULSED Z8536_PAB_HANDSHAKE_HST(2)/* Pulsed */
278 * what the datasheet calls 'Pulsed FSYNC mode' and '50% in ssm3515_set_fmt()
181 /* GPIO&0x40 is pulsed low when a button is pressed. Don't do in get_key_msi_tvanywhere_plus()233 /* GPIO&0x100 is pulsed low when a button is pressed. Don't do in get_key_kworld_pc150u()
116 description: Pulsed current value applied during open-circuit detect.
1141 the ADC output is only ever pulsed. */ in stellaris_init()
377 /* When writing, any write causes JOYSTICK_COMPARATOR output enable to be pulsed on write. */
1062 "pulsed low, high-Z", in show_parconfig_winbond()
1851 is divided as follows: [0] VAUX Enable; when pulsed low; enables supply1853 for this pin); [1] VAUX Disable; when pulsed low; disables supply form