/openbmc/u-boot/tools/ |
H A D | fdt_host.h | 17 * called can then use fdt_pack() to minimise the space consumed.
|
/openbmc/openbmc/poky/meta/conf/distro/include/ |
H A D | no-gplv3.inc | 2 # This include file is to document commonly used configuration options to minimise
|
/openbmc/linux/arch/arm/mach-s3c/ |
H A D | pm-common.c | 61 * This is similar to s3c_pm_do_restore() except we try and minimise the
|
H A D | pm-gpio.c | 136 * we minimise the work between the two settings. in samsung_gpio_pm_2bit_resume()
|
/openbmc/linux/arch/m68k/include/asm/ |
H A D | hash.h | 20 * chosen to minimise the shift distances.
|
/openbmc/linux/kernel/irq/ |
H A D | ipi.c | 234 * Minimise the overhead by omitting the checks for Linux SMP IPIs. in __ipi_send_single() 277 * Minimise the overhead by omitting the checks for Linux SMP IPIs. in __ipi_send_mask()
|
/openbmc/linux/arch/arm64/kernel/ |
H A D | sys_compat.c | 37 * We pick the reserved-ASID to minimise the impact. in __do_compat_cache_op()
|
/openbmc/linux/Documentation/devicetree/bindings/spi/ |
H A D | spi-pl022.yaml | 53 priority to minimise the transfer latency on the bus (boolean)
|
/openbmc/linux/drivers/gpu/drm/i915/gem/ |
H A D | i915_gem_busy.c | 48 * to eventually flush us, but to minimise latency just ask the in __busy_set_if_active()
|
/openbmc/qemu/docs/devel/ |
H A D | multi-thread-tcg.rst | 65 multiple reader/writer threads. Minimise any lock contention to do it. 237 minimise contention.
|
/openbmc/linux/Documentation/sound/soc/ |
H A D | codec.rst | 171 minimise any system noise. The mute stops any digital data from
|
/openbmc/linux/Documentation/driver-api/ |
H A D | regulator.rst | 73 not in use in order to minimise the need to use ifdefs.
|
/openbmc/linux/include/linux/amba/ |
H A D | pl022.h | 233 * priority to minimise the transfer latency on the bus.
|
/openbmc/linux/scripts/dtc/libfdt/ |
H A D | libfdt_internal.h | 103 * the latest supported version and wish to minimise code size.
|
/openbmc/linux/fs/squashfs/ |
H A D | Kconfig | 10 are very small and all blocks are packed to minimise data overhead.
|
/openbmc/linux/net/core/ |
H A D | link_watch.c | 149 /* Minimise down-time: drop delay for up event. */ in linkwatch_schedule_work()
|
/openbmc/linux/sound/soc/codecs/ |
H A D | wm8350.c | 73 * Ramp OUT1 PGA volume to minimise pops at stream startup and shutdown. 138 * Ramp OUT2 PGA volume to minimise pops at stream startup and shutdown. 203 * minimise pop associated with DAPM power switching. 204 * It's best to enable Zero Cross when ramping occurs to minimise any
|
/openbmc/linux/drivers/ata/ |
H A D | pata_cs5530.c | 69 * master to slave. We track the last DMA setup in order to minimise
|
/openbmc/linux/drivers/input/touchscreen/ |
H A D | wm9705.c | 86 * order to minimise this, a signal may be applied to the MASK pin to delay or
|
/openbmc/linux/include/linux/ |
H A D | wm97xx.h | 260 /* pre and post sample - can be used to minimise any analog noise */
|
H A D | refcount.h | 19 * equidistant from 0 and INT_MAX we minimise the scope for error:
|
/openbmc/libpldm/docs/checklists/ |
H A D | changes.md | 207 minimise concerns around spatial memory safety and endian-correctness.
|
/openbmc/linux/drivers/mfd/ |
H A D | wm8350-irq.c | 374 * minimise I/O.
|
/openbmc/linux/Documentation/filesystems/ |
H A D | squashfs.rst | 11 minimise data overhead. Block sizes greater than 4K are supported up to a
|
/openbmc/linux/tools/testing/selftests/alsa/ |
H A D | mixer-test.c | 854 /* Restore the default value to minimise disruption */ in test_ctl_write_valid() 1066 /* Restore the default value to minimise disruption */ in test_ctl_write_invalid()
|