/openbmc/openbmc/poky/meta/lib/oe/ |
H A D | buildstats.py | 105 reduced = None 124 reduced = (self.diskstats_ltime, (readTput, writeTput, util)) 128 return reduced 140 reduced = None 148 reduced = (time, (user/aSum, system/aSum, iowait/aSum)) 151 return reduced 155 … Return reduced pressure: {avg10, avg60, avg300} and delta total compared to the previous sample 167 reduced = None 170 reduced = (time, (avg10, avg60, avg300, delta)) 172 return reduced [all …]
|
/openbmc/phosphor-dbus-interfaces/yaml/xyz/openbmc_project/Control/Power/ |
H A D | Mode.interface.yaml | 43 high and performs at reduced speeds when the utilization is low. 46 The system performs at reduced speeds at all utilizations to 52 The system performs at reduced speeds at all utilizations to 68 This value shall indicate the system performs at reduced speeds
|
/openbmc/linux/Documentation/fb/ |
H A D | modedb.rst | 40 If 'R' is specified, do a 'reduced blanking' calculation for digital displays. 112 displays, the "reduced blanking" calculation can be used. 117 new CRT displays and probably with most flatpanels, if 'reduced blanking' 130 -R = reduced blanking 132 example: .48M3-R - 800x600 with reduced blanking 138 - if reduced blanking, the refresh rate must be at 60Hz
|
/openbmc/u-boot/doc/ |
H A D | README.fec_mxc | 12 RGMII selects 1000 Base-tx reduced pin count interface. 13 RMII selects 100 Base-tx reduced pin count interface.
|
/openbmc/linux/Documentation/devicetree/bindings/power/supply/ |
H A D | maxim,max77693.yaml | 46 reduced by 105 mA/Celsius. 63 be reduced to reach the threshold voltage.
|
/openbmc/linux/drivers/acpi/acpica/ |
H A D | evxfevnt.c | 44 /* If the Hardware Reduced flag is set, machine is always in acpi mode */ in acpi_enable() 102 /* If the Hardware Reduced flag is set, machine is always in acpi mode */ in ACPI_EXPORT_SYMBOL() 149 /* If Hardware Reduced flag is set, there are no fixed events */ in ACPI_EXPORT_SYMBOL() 212 /* If Hardware Reduced flag is set, there are no fixed events */ in ACPI_EXPORT_SYMBOL() 271 /* If Hardware Reduced flag is set, there are no fixed events */ in ACPI_EXPORT_SYMBOL()
|
H A D | hwacpi.c | 35 /* If the Hardware Reduced flag is set, machine is always in acpi mode */ in acpi_hw_set_mode() 121 /* If the Hardware Reduced flag is set, machine is always in acpi mode */ in acpi_hw_get_mode()
|
/openbmc/linux/Documentation/hwmon/ |
H A D | nsa320.rst | 53 the first clock pulse is reduced from 100 ms to just under 10ms then the chip 55 is reduced from 100 us to less than 15 us then data pulses are likely to be
|
/openbmc/linux/include/media/ |
H A D | v4l2-dv-timings.h | 144 * information is needed only in case of version 2 of reduced blanking. 211 * can_reduce_fps - check if conditions for reduced fps are true. 214 * For different timings reduced fps is allowed if the following conditions 217 * - For CVT timings: if reduced blanking v2 (vsync == 8) is true.
|
/openbmc/qemu/docs/specs/ |
H A D | acpi_hw_reduced_hotplug.rst | 5 The ACPI *Generic Event Device* (GED) is a HW reduced platform 11 GED allows HW reduced platforms to handle interrupts in ACPI ASL
|
/openbmc/linux/Documentation/userspace-api/media/v4l/ |
H A D | vidioc-g-dv-timings.rst | 256 - CVT/GTF specific: the timings use reduced blanking (CVT) or the 258 vertical blanking intervals are reduced, allowing a higher 281 If a video receiver detects that the format uses a reduced framerate, 316 regular framerates and framerates reduced by 1000/1001. E.g.:
|
/openbmc/linux/tools/perf/pmu-events/arch/x86/silvermont/ |
H A D | frontend.json | 27 …"BriefDescription": "Counts the number of times a decode restriction reduced the decode throughput… 30 …"PublicDescription": "Counts the number of times a decode restriction reduced the decode throughpu…
|
/openbmc/linux/Documentation/ABI/testing/ |
H A D | sysfs-kernel-iommu_groups | 46 remove translations after use. This may offer reduced 47 overhead at the cost of reduced memory protection.
|
/openbmc/linux/arch/riscv/kernel/ |
H A D | acpi.c | 68 * and carry out revision and ACPI HW reduced compliancy tests in acpi_fadt_sanity_check() 93 pr_err("FADT not ACPI hardware reduced compliant\n"); in acpi_fadt_sanity_check() 109 * 3. check ACPI FADT HW reduced flag
|
/openbmc/linux/net/netfilter/ipvs/ |
H A D | ip_vs_wrr.c | 34 * Then cw is reduced with di and all dests are checked again. 44 * weight changes, it is possible some dest weight to be reduced 47 * So, we modify how mw is calculated, now it is reduced with (di - 1),
|
/openbmc/linux/Documentation/devicetree/bindings/arm/msm/ |
H A D | qcom,idle-state.txt | 28 voltage may be reduced to the minimum value needed to keep the processor 51 voltages reduced, provided all cpus enter this state. Since the span of low
|
/openbmc/linux/Documentation/admin-guide/pm/ |
H A D | sleep-states.rst | 15 reduced. 44 deeper system suspend variants to provide reduced resume latency. It is always 65 reduced relative to :ref:`suspend-to-idle <s2idle>` and it may be necessary to 97 The set of devices that can wake up the system from S2RAM usually is reduced
|
/openbmc/linux/arch/x86/math-emu/ |
H A D | div_Xsig.S | 184 /* Half of the main problem is done, there is just a reduced numerator 188 movl FPU_accum_2,%edx /* get the reduced num */ 297 movl FPU_accum_1,%edx /* get the reduced num */ 309 movl FPU_accum_1,%edx /* get the reduced num */
|
/openbmc/qemu/docs/ |
H A D | multi-thread-compression.txt | 23 bandwidth is limited, and the total migration time can also be reduced 25 reduced about 50%. The benefit depends on data's compressibility in VM. 31 enough, then the total migration time can be reduced, and multiple
|
/openbmc/linux/Documentation/devicetree/bindings/net/ |
H A D | ti,cpsw-switch.yaml | 16 gigabit media independent interface (GMII),reduced gigabit media 17 independent interface (RGMII), reduced media independent interface (RMII),
|
/openbmc/linux/drivers/net/wireless/intel/iwlwifi/fw/ |
H A D | uefi.c | 238 "Reduced Power UEFI variable not found 0x%lx (len %lu)\n", in iwl_uefi_get_reduced_power() 245 "Invalid Reduced Power UEFI variable len (%lu)\n", in iwl_uefi_get_reduced_power() 251 IWL_DEBUG_FW(trans, "Read reduced power from UEFI with size %lu\n", in iwl_uefi_get_reduced_power()
|
/openbmc/linux/include/acpi/ |
H A D | acpixf.h | 210 * ACPI 5.0 introduces the concept of a "reduced hardware platform", meaning 212 * a reduced HW machine, and that flag is duplicated here for convenience. 280 * Hardware-reduced prototypes (default: Not hardware reduced). 286 * Note: This static build option for reduced hardware is intended to 289 * on the actual FADT reduced hardware flag (HW_REDUCED_ACPI). If set,
|
/openbmc/linux/Documentation/devicetree/bindings/iio/dac/ |
H A D | ti,dac7512.yaml | 21 Maximum frequency is reduced for supply voltage of less than 3.6V
|
/openbmc/linux/tools/testing/selftests/bpf/progs/ |
H A D | pyperf180.c | 12 * reduced some branch target distances and resolved the compilation failure.
|
/openbmc/u-boot/drivers/net/ |
H A D | Kconfig | 214 Mbps Ethernet and includes Reduced Media Independent 215 Interface (RMII) and Reduced Gigabit Media Independent 288 Enable the support of the Reduced Gigabit Media-Independent
|