| /openbmc/linux/sound/pci/cs46xx/ |
| H A D | cs46xx.h | 22 * The following define the offsets of the registers accessed via base address
150 * The following define the offsets of the registers and memories accessed via
173 * The following defines are for the flags in the host interrupt status
208 * The following defines are for the flags in the host signal register 0.
245 * The following defines are for the flags in the host interrupt control
252 * The following defines are for the flags in the DMA status register.
260 * The following defines are for the flags in the host DMA source address
275 * The following defines are for the flags in the host DMA destination address
290 * The following defines are for the flags in the host DMA control register.
299 * The following defines are for the flags in the host DMA control register.
[all …]
|
| /openbmc/linux/net/netlabel/ |
| H A D | netlabel_mgmt.h | 23 * The following NetLabel payloads are supported by the management interface.
33 * If IPv4 is specified the following attributes are required:
38 * If IPv6 is specified the following attributes are required:
43 * If using NETLBL_NLTYPE_CIPSOV4 the following attributes are required:
48 * however the following attribute may optionally be sent:
64 * The kernel should respond with a series of the following messages.
71 * If the IP address selectors are not used the following attribute is
76 * If the IP address selectors are used then the following attritbute is
81 * If the mapping is using the NETLBL_NLTYPE_CIPSOV4 type then the following
97 * If using NETLBL_NLTYPE_CIPSOV4 the following attributes are required:
[all …]
|
| H A D | netlabel_unlabeled.h | 22 * The following NetLabel payloads are supported by the Unlabeled subsystem.
33 * If IPv4 is specified the following attributes are required:
38 * If IPv6 is specified the following attributes are required:
51 * If IPv4 is specified the following attributes are required:
56 * If IPv6 is specified the following attributes are required:
65 * The kernel should response with a series of the following messages.
72 * If IPv4 is specified the following attributes are required:
77 * If IPv6 is specified the following attributes are required:
90 * If IPv4 is specified the following attributes are required:
95 * If IPv6 is specified the following attributes are required:
[all …]
|
| H A D | netlabel_cipso_v4.h | 22 * The following NetLabel payloads are supported by the CIPSO subsystem.
33 * If using CIPSO_V4_MAP_TRANS the following attributes are required:
51 * success the kernel should send a response using the following format.
65 * If using CIPSO_V4_MAP_TRANS the following attributes are required:
77 * the following messages.
124 * each of the following types: NLBL_CIPSOV4_A_MLSLVLLOC and
139 * the following types: NLBL_CIPSOV4_A_MLSCATLOC and
|
| /openbmc/u-boot/arch/xtensa/cpu/ |
| H A D | u-boot.lds | 37 .reloc_table ALIGN(4) : FOLLOWING(.ResetVector.text)
58 FOLLOWING(.reloc_table))
60 FOLLOWING(.WindowVectors.text))
63 FOLLOWING(.reloc_table))
66 FOLLOWING(.KernelExceptionVector.literal))
68 FOLLOWING(.KernelExceptionVector.text))
70 FOLLOWING(.UserExceptionVector.literal))
72 FOLLOWING(.UserExceptionVector.text))
74 FOLLOWING(.DoubleExceptionVector.literal))
78 SECTION_text(XTENSA_SYS_TEXT_ADDR, FOLLOWING(.DoubleExceptionVector.text))
[all …]
|
| /openbmc/openbmc/poky/meta/files/common-licenses/ |
| H A D | Net-SNMP | 15 …ry forms, with or without modification, are permitted provided that the following conditions are m…
17 … code must retain the above copyright notice, this list of conditions and the following disclaimer.
18 …t reproduce the above copyright notice, this list of conditions and the following disclaimer in th…
25 …ry forms, with or without modification, are permitted provided that the following conditions are m…
27 … code must retain the above copyright notice, this list of conditions and the following disclaimer.
28 …t reproduce the above copyright notice, this list of conditions and the following disclaimer in th…
43 …ry forms, with or without modification, are permitted provided that the following conditions are m…
45 … code must retain the above copyright notice, this list of conditions and the following disclaimer.
47 …t reproduce the above copyright notice, this list of conditions and the following disclaimer in th…
55 …ry forms, with or without modification, are permitted provided that the following conditions are m…
[all …]
|
| H A D | OpenSSL | 8 modification, are permitted provided that the following conditions
12 notice, this list of conditions and the following disclaimer.
15 notice, this list of conditions and the following disclaimer in
20 software must display the following acknowledgment:
33 6. Redistributions of any form whatsoever must retain the following
68 the following conditions are aheared to. The following conditions
82 modification, are permitted provided that the following conditions
85 notice, this list of conditions and the following disclaimer.
87 notice, this list of conditions and the following disclaimer in the
90 must display the following acknowledgement:
|
| H A D | Sleepycat | 7 modification, are permitted provided that the following conditions
11 notice, this list of conditions and the following disclaimer.
13 notice, this list of conditions and the following disclaimer in the
41 modification, are permitted provided that the following conditions
45 notice, this list of conditions and the following disclaimer.
47 notice, this list of conditions and the following disclaimer in the
68 modification, are permitted provided that the following conditions
72 notice, this list of conditions and the following disclaimer.
74 notice, this list of conditions and the following disclaimer in the
|
| H A D | Caldera | 1 … for which Caldera International, Inc. grants rights are limited to the following UNIX Operating S…
9 The following copyright notice applies to the source code files for which this license is granted.
13 …ry forms, with or without modification, are permitted provided that the following conditions are m…
15 …ation must retain the above copyright notice, this list of conditions and the following disclaimer.
17 …t reproduce the above copyright notice, this list of conditions and the following disclaimer in th…
19 …g materials mentioning features or use of this software must display the following acknowledgement:
|
| H A D | Sendmail | 3 The following license terms and conditions apply, unless a redistribution agreement or other licens…
7 …rived work) in source and binary forms is permitted only if each of the following conditions is me…
9 1. Redistributions qualify as "freeware" or "Open Source Software" under one of the following terms:
17 …n. For the purposes of binary distribution the "Copyright Notice" refers to the following language:
26 …ry forms, with or without modification, are permitted provided that the following conditions are m…
28 … code must retain the above copyright notice, this list of conditions and the following disclaimer.
30 …t reproduce the above copyright notice, this list of conditions and the following disclaimer in th…
|
| H A D | Sendmail-8.23 | 3 The following license terms and conditions apply, unless a redistribution agreement or other licens…
7 …rived work) in source and binary forms is permitted only if each of the following conditions is me…
9 1. Redistributions qualify as "freeware" or "Open Source Software" under one of the following terms:
17 …n. For the purposes of binary distribution the "Copyright Notice" refers to the following language:
26 …ry forms, with or without modification, are permitted provided that the following conditions are m…
28 … code must retain the above copyright notice, this list of conditions and the following disclaimer.
30 …t reproduce the above copyright notice, this list of conditions and the following disclaimer in th…
|
| H A D | BSD-Advertising-Acknowledgement | 5 modification, are permitted provided that the following conditions
9 notice, this list of conditions and the following disclaimer.
12 notice, this list of conditions and the following disclaimer in
17 software must display the following acknowledgment:
21 4. Redistributions of any form whatsoever must retain the following
|
| H A D | SSLeay-standalone | 12 the following conditions are aheared to. The following conditions
26 modification, are permitted provided that the following conditions
29 notice, this list of conditions and the following disclaimer.
31 notice, this list of conditions and the following disclaimer in the
34 must display the following acknowledgement:
|
| H A D | BSD-Systemics-W3Works | 14 must display the following acknowledgement:
27 as long as the following conditions are adhered to.
36 modification, are permitted provided that the following conditions
39 notice, this list of conditions and the following disclaimer.
41 notice, this list of conditions and the following disclaimer in the
44 must display the following acknowledgement:
|
| /openbmc/linux/scripts/kconfig/tests/preprocess/escape/ |
| H A D | Kconfig | 7 # delimiters. You can use the following trick to do so.
12 # The following prints the text as-is.
23 # The following should print "$(X)". It should not be expanded further.
28 # The following should print "(".
33 # The following should print "$(X)". It should not be expanded further.
37 # The following should print "$(X)" as well.
41 # The following should print "$(".
|
| /openbmc/u-boot/doc/device-tree-bindings/gpu/ |
| H A D | nvidia,tegra20-host1x.txt | 16 - reset-names: Must include the following entries:
20 of the following host1x client modules:
32 - reset-names: Must include the following entries:
45 - reset-names: Must include the following entries:
58 - reset-names: Must include the following entries:
71 - reset-names: Must include the following entries:
84 - reset-names: Must include the following entries:
94 - clock-names: Must include the following entries:
101 - reset-names: Must include the following entries:
113 - clock-names: Must include the following entries:
[all …]
|
| /openbmc/linux/Documentation/admin-guide/device-mapper/ |
| H A D | dm-ima.rst | 37 system needs to be updated to have following line, and the system needs
52 Then IMA ASCII measurement log has the following format:
89 Following device state changes will trigger IMA measurements:
103 The IMA measurement log has the following format for 'dm_table_load':
149 For instance, if a linear device is created with the following table entries,
156 Then IMA ASCII measurement log will have the following entry:
173 The IMA measurement log has the following format for 'dm_device_resume':
194 For instance, if a linear device is resumed with the following command,
211 The IMA measurement log has the following format for 'dm_device_remove':
232 For instance, if a linear device is removed with the following command,
[all …]
|
| /openbmc/linux/Documentation/devicetree/bindings/clock/ |
| H A D | mvebu-core-clock.txt | 7 The following is a list of provided IDs and clock names on Armada 370/XP:
14 The following is a list of provided IDs and clock names on Armada 375:
20 The following is a list of provided IDs and clock names on Armada 380/385:
26 The following is a list of provided IDs and clock names on Armada 39x:
34 The following is a list of provided IDs and clock names on 98dx3236:
40 The following is a list of provided IDs and clock names on Kirkwood and Dove:
46 The following is a list of provided IDs and clock names on Orion5x:
52 - compatible : shall be one of the following:
|
| /openbmc/linux/Documentation/admin-guide/ |
| H A D | kernel-per-CPU-kthreads.rst | 43 To reduce its OS jitter, do any of the following:
62 To reduce its OS jitter, do the following:
73 To reduce its OS jitter, do one of the following:
93 Do all of the following:
109 Do all of the following:
121 Do all of the following:
133 Do all of the following:
145 Do one or more of the following:
156 Do all of the following:
178 Do all of the following:
[all …]
|
| /openbmc/linux/drivers/staging/media/av7110/ |
| H A D | audio_data_types.rst | 15 and can take the following values, depending on whether we are replaying
34 The following values can be returned by the AUDIO_GET_STATUS call
50 the following values.
66 The AUDIO_GET_STATUS call returns the following structure informing
85 The following structure is used by the AUDIO_SET_MIXER call to set the
103 following bits set according to the hardwares capabilities.
|
| /openbmc/linux/tools/perf/Documentation/ |
| H A D | perf-c2c.txt | 89 Following fields are available: tid,pid,iaddr,dso
144 Following perf record options are configured by default:
149 Unless specified otherwise with '-e' option, following events are monitored by
155 following on AMD:
159 and following on PowerPC:
176 The report command workflow is following:
186 For each cacheline in the 1) list we display following data:
235 For each offset in the 2) list we display following data:
285 - node IDs with stats for each ID, in following format:
288 - node IDs with list of affected CPUs in following format:
[all …]
|
| /openbmc/openbmc/poky/documentation/dev-manual/ |
| H A D | bmaptool.rst | 16 the ``bmap-tools`` package using the following command and then
23 need to build bmaptool before using it. Use the following command::
27 Following, is an example that shows how to flash a Wic image. Realize
31 #. *Update your local.conf File:* You need to have the following set
43 depending on your particular setup. The following commands assume the
56 For help on the ``bmaptool`` command, use the following command::
|
| /openbmc/linux/Documentation/hwmon/ |
| H A D | mp5023.rst | 33 The driver exports the following attributes via the 'sysfs' files
48 The driver provides the following attributes for output voltage:
56 The driver provides the following attributes for output current:
66 The driver provides the following attributes for input power:
74 The driver provides the following attributes for temperature:
|
| H A D | xdp710.rst | 32 The driver exports the following attributes via the 'sysfs' files
47 The driver provides the following attributes for output voltage:
55 The driver provides the following attributes for output current:
65 The driver provides the following attributes for input power:
73 The driver provides the following attributes for temperature:
|
| H A D | mp5990.rst | 33 The driver exports the following attributes via the 'sysfs' files
48 The driver provides the following attributes for output voltage:
56 The driver provides the following attributes for output current:
66 The driver provides the following attributes for input power:
74 The driver provides the following attributes for temperature:
|