Merge branch 'master' of git://git.denx.de/u-boot-socfpga

- SoCFPGA cache/gpio fixes

ARM: socfpga: Clear PL310 early in SPL

On SoCFPGA Gen5 systems, it can rarely happen that a reboot from Linux
will result in stale data in PL310 L2 cache controller. Even if the L2
cache controller

ARM: socfpga: Clear PL310 early in SPL

On SoCFPGA Gen5 systems, it can rarely happen that a reboot from Linux
will result in stale data in PL310 L2 cache controller. Even if the L2
cache controller is disabled via the CTRL register CTRL_EN bit, those
data can interfere with operation of devices using DMA, like e.g. the
DWMMC controller. This can in turn cause e.g. SPL to fail reading data
from SD/MMC.

The obvious solution here would be to fully reset the L2 cache controller
via the reset manager MPUMODRST L2 bit, however this causes bus hang even
if executed entirely from L1 I-cache to avoid generating any bus traffic
through the L2 cache controller.

This patch thus configures and enables the L2 cache controller very early
in the SPL boot process, clears the L2 cache and disables the L2 cache
controller again.

The reason for doing it in SPL is because we need to avoid accessing any
of the potentially stale data in the L2 cache, and we are certain any of
the stale data will be below the OCRAM address range. To further reduce
bus traffic during the L2 cache invalidation, we enable L1 I-cache and
run the invalidation code entirely out of the L1 I-cache.

Signed-off-by: Marek Vasut <marex@denx.de>
Cc: Dalon Westergreen <dwesterg@gmail.com>
Cc: Dinh Nguyen <dinguyen@kernel.org>

show more ...

Merge branch '2019-02-01-master-imports'

- Various TI platforms have been updated and DTS files re-synced and
options disabled if not used or migrated to the DM versions
- Improvements to the dump

Merge branch '2019-02-01-master-imports'

- Various TI platforms have been updated and DTS files re-synced and
options disabled if not used or migrated to the DM versions
- Improvements to the dumpimage tool
- Rename SPL FAT/EXT filesystem support symbols for consistency and then
allow them to be used to save more space in SPL.
- More lmb fixes
- Partial migration of CONFIG_BUILD_TARGET

show more ...

spl: Kconfig: Replace CONFIG_SPL_EXT_SUPPORT to CONFIG_SPL_FS_EXT4

Replace CONFIG_SPL_EXT_SUPPORT to CONFIG_SPLY_FS_EXT4 so both
obj-$(CONFIG_$(SPL_)FS_EXT4) and CONFIG_IS_ENABLED(FS_EXT4) can be
us

spl: Kconfig: Replace CONFIG_SPL_EXT_SUPPORT to CONFIG_SPL_FS_EXT4

Replace CONFIG_SPL_EXT_SUPPORT to CONFIG_SPLY_FS_EXT4 so both
obj-$(CONFIG_$(SPL_)FS_EXT4) and CONFIG_IS_ENABLED(FS_EXT4) can be
used to control the build in both SPL and U-Boot.

Signed-off-by: Tien Fong Chee <tien.fong.chee@intel.com>
Reviewed-by: Tom Rini <trini@konsulko.com>

show more ...

spl: Kconfig: Replace CONFIG_SPL_FAT_SUPPORT with CONFIG_SPL_FS_FAT

Replace CONFIG_SPL_FAT_SUPPORT with CONFIG_SPL_FS_FAT so
obj-$(CONFIG_$(SPL_)FS_FAT) can be used to control the build in both
SPL

spl: Kconfig: Replace CONFIG_SPL_FAT_SUPPORT with CONFIG_SPL_FS_FAT

Replace CONFIG_SPL_FAT_SUPPORT with CONFIG_SPL_FS_FAT so
obj-$(CONFIG_$(SPL_)FS_FAT) can be used to control the build in both
SPL and U-Boot.

Signed-off-by: Tien Fong Chee <tien.fong.chee@intel.com>
Reviewed-by: Simon Goldschmidt <simon.k.r.goldschmidt@gmail.com>
Reviewed-by: Tom Rini <trini@konsulko.com>

show more ...

Merge branch 'master' of git://git.denx.de/u-boot-socfpga

arm: socfpga: fix SPL booting from fpga OnChip RAM

This patch prevents disabling the FPGA bridges when
SPL or U-Boot is executed from FPGA onchip RAM.

Signed-off-by: Simon Goldschmidt <simon.k.r.go

arm: socfpga: fix SPL booting from fpga OnChip RAM

This patch prevents disabling the FPGA bridges when
SPL or U-Boot is executed from FPGA onchip RAM.

Signed-off-by: Simon Goldschmidt <simon.k.r.goldschmidt@gmail.com>

show more ...

Merge branch 'master' of git://git.denx.de/u-boot-socfpga

arm: socfpga: gen5: combine some init code for SPL and U-Boot

Some of the code for low level system initialization in SPL's
board_init_f() and U-Boot's arch_early_init_r() is the same,
so let's comb

arm: socfpga: gen5: combine some init code for SPL and U-Boot

Some of the code for low level system initialization in SPL's
board_init_f() and U-Boot's arch_early_init_r() is the same,
so let's combine it into a single function called from both.

Signed-off-by: Simon Goldschmidt <simon.k.r.goldschmidt@gmail.com>

show more ...

arm: socfpga: cyclone5: handle debug uart

If CONFIG_DEBUG_UART is enabled, correctly initialize
the debug uart before console is initialized to debug
early boot problems in SPL.

Signed-off-by: Simo

arm: socfpga: cyclone5: handle debug uart

If CONFIG_DEBUG_UART is enabled, correctly initialize
the debug uart before console is initialized to debug
early boot problems in SPL.

Signed-off-by: Simon Goldschmidt <simon.k.r.goldschmidt@gmail.com>

show more ...

arm: socfpga: spl_gen5: clean up malloc_base assignment

In spl_gen5's board_init_f(), gd->malloc_base is manually assigned
at the end of the function to point to sdram. This code is outdated
as by

arm: socfpga: spl_gen5: clean up malloc_base assignment

In spl_gen5's board_init_f(), gd->malloc_base is manually assigned
at the end of the function to point to sdram. This code is outdated
as by now, the heap is switched to sdram by the common function
spl_relocate_stack_gd() if the appropriate defines are set.

As it was, the value assigned manually was directly overwritten by
this common code, so remove the manual assignment.

Signed-off-by: Simon Goldschmidt <simon.k.r.goldschmidt@gmail.com>

show more ...

arm: socfpga: fix SPL on gen5 after moving to DM serial

There were NULL pointers dereferenced because DM was used
too early without correct initialization:
- malloc_simple returned NULL when called

arm: socfpga: fix SPL on gen5 after moving to DM serial

There were NULL pointers dereferenced because DM was used
too early without correct initialization:
- malloc_simple returned NULL when called from preloader_console_init()
because gd->malloc_limit was 0
- uclass_add dereferenced gd->uclass_root members which were NULL because
dm_init (or one of its relatives) has not been called.

All this is fixed by calling spl_early_init before calling
preloader_console_init.

This fixes commit 73172753f4f3 ("ARM: socfpga: Convert to DM serial")

Signed-off-by: Simon Goldschmidt <simon.k.r.goldschmidt@gmail.com>

show more ...

Merge branch 'master' of git://git.denx.de/u-boot-socfpga

- Update SPDX tag in arch/arm/mach-socfpga/spl_a10.c

Signed-off-by: Tom Rini <trini@konsulko.com>

arm: socfpga: Restructure the SPL file

Restructure the SPL so each devices such as CV, A10 and S10
will have their own dedicated SPL file. SPL file determine
the HW initialization flow which is devi

arm: socfpga: Restructure the SPL file

Restructure the SPL so each devices such as CV, A10 and S10
will have their own dedicated SPL file. SPL file determine
the HW initialization flow which is device specific

Signed-off-by: Chin Liang See <chin.liang.see@intel.com>
Signed-off-by: Ley Foon Tan <ley.foon.tan@intel.com>

show more ...