Merge branch 'efi/urgent' into efi/core, to pick up fixes

Signed-off-by: Ingo Molnar <mingo@kernel.org>

Merge tag 'spi-fix-v5.6-rc4' of git://git.kernel.org/pub/scm/linux/kernel/git/broonie/spi

Pull spi fixes from Mark Brown:
"A selection of small fixes, mostly for drivers, that have arrived
since

Merge tag 'spi-fix-v5.6-rc4' of git://git.kernel.org/pub/scm/linux/kernel/git/broonie/spi

Pull spi fixes from Mark Brown:
"A selection of small fixes, mostly for drivers, that have arrived
since the merge window. None of them are earth shattering in
themselves but all useful for affected systems"

* tag 'spi-fix-v5.6-rc4' of git://git.kernel.org/pub/scm/linux/kernel/git/broonie/spi:
spi: spi_register_controller(): free bus id on error paths
spi: bcm63xx-hsspi: Really keep pll clk enabled
spi: atmel-quadspi: fix possible MMIO window size overrun
spi/zynqmp: remove entry that causes a cs glitch
spi: pxa2xx: Add CS control clock quirk
spi: spidev: Fix CS polarity if GPIO descriptors are used
spi: qup: call spi_qup_pm_resume_runtime before suspending
spi: spi-omap2-mcspi: Support probe deferral for DMA channels
spi: spi-omap2-mcspi: Handle DMA size restriction on AM65x

show more ...

Merge series "spi: spidev: Fix messages in spidev" from Oleksandr Suvorov <oleksandr.suvorov@toradex.com>:

- fix the values source for the xfer debug message.
- fix the "max speed setting" message s

Merge series "spi: spidev: Fix messages in spidev" from Oleksandr Suvorov <oleksandr.suvorov@toradex.com>:

- fix the values source for the xfer debug message.
- fix the "max speed setting" message showing.

Oleksandr Suvorov (2):
spi: spidev: fix a debug message value
spi: spidev: fix speed setting message

drivers/spi/spidev.c | 23 ++++++++++++-----------
1 file changed, 12 insertions(+), 11 deletions(-)

--
2.24.1

show more ...

spi: atmel-quadspi: fix possible MMIO window size overrun

The QSPI controller memory space is limited to 128MB:
0x9000_00000-0x9800_00000/0XD000_0000--0XD800_0000.

There are nor flashes that are bi

spi: atmel-quadspi: fix possible MMIO window size overrun

The QSPI controller memory space is limited to 128MB:
0x9000_00000-0x9800_00000/0XD000_0000--0XD800_0000.

There are nor flashes that are bigger in size than the memory size
supported by the controller: Micron MT25QL02G (256 MB).

Check if the address exceeds the MMIO window size. An improvement
would be to add support for regular SPI mode and fall back to it
when the flash memories overrun the controller's memory space.

Fixes: 0e6aae08e9ae ("spi: Add QuadSPI driver for Atmel SAMA5D2")
Signed-off-by: Tudor Ambarus <tudor.ambarus@microchip.com>
Link: https://lore.kernel.org/r/20200228155437.1558219-1-tudor.ambarus@microchip.com
Signed-off-by: Mark Brown <broonie@kernel.org>

show more ...

Merge branch 'next' into for-linus

Prepare input updates for 5.5 merge window.

Merge tag 'v5.4-rc8' into WIP.x86/mm, to pick up fixes

Signed-off-by: Ingo Molnar <mingo@kernel.org>

Merge branch 'linus' into x86/hyperv

Pick up upstream fixes to avoid conflicts.

Merge tag 'v5.4-rc5' into next

Sync up with mainline.

Merge drm/drm-next into drm-intel-next-queued

Backmerging to pull in HDR DP code:

https://lists.freedesktop.org/archives/dri-devel/2019-September/236453.html

Signed-off-by: Joonas Lahtinen <joonas

Merge drm/drm-next into drm-intel-next-queued

Backmerging to pull in HDR DP code:

https://lists.freedesktop.org/archives/dri-devel/2019-September/236453.html

Signed-off-by: Joonas Lahtinen <joonas.lahtinen@linux.intel.com>

show more ...

Merge tag 'fix-missing-panels' into fixes

Merge drm/drm-next into drm-misc-next

We haven't done any backmerge for a while due to the merge window, and it
starts to become an issue for komeda. Let's bring 5.4-rc1 in.

Signed-off-by: Maxime R

Merge drm/drm-next into drm-misc-next

We haven't done any backmerge for a while due to the merge window, and it
starts to become an issue for komeda. Let's bring 5.4-rc1 in.

Signed-off-by: Maxime Ripard <mripard@kernel.org>

show more ...

Merge drm/drm-fixes into drm-misc-fixes

We haven't backmerged for a while, let's start the -rc period by pulling
rc1.

Signed-off-by: Maxime Ripard <mripard@kernel.org>

Merge tag 'spi-v5.4' of git://git.kernel.org/pub/scm/linux/kernel/git/broonie/spi

Pull spi updates from Mark Brown:
"The big theme for this release has been performance, we've had a
series of unr

Merge tag 'spi-v5.4' of git://git.kernel.org/pub/scm/linux/kernel/git/broonie/spi

Pull spi updates from Mark Brown:
"The big theme for this release has been performance, we've had a
series of unrelated overhauls of a few drivers all with a big
peformance component.

Otherwise it's been relatively quiet, highlights include:

- A big overhaul of the spi-fsl-dspi driver improving the code
quality, performance and stability from Vladimir Oltean.

- A big performance enhancement for the bc2835 (Raspberry Pi) driver
for unidirectional transfers from Lukas Wunner.

- Improved performance on small transfers for the uniphier driver
from Keiji Hayashibara.

- Lots of coccinelle generated cleanups from Yue Haibing.

- New device support for Freescale ls2080a and Nuvoton NPCM FIU"

* tag 'spi-v5.4' of git://git.kernel.org/pub/scm/linux/kernel/git/broonie/spi: (102 commits)
spi: mediatek: support large PA
spi: mediatek: add spi support for mt6765 IC
dt-bindings: spi: update bindings for MT6765 SoC
spi: bcm2835: Speed up RX-only DMA transfers by zero-filling TX FIFO
spi: bcm2835: Speed up TX-only DMA transfers by clearing RX FIFO
dmaengine: bcm2835: Avoid accessing memory when copying zeroes
spi: bcm2835: Cache CS register value for ->prepare_message()
dmaengine: bcm2835: Document struct bcm2835_dmadev
spi: Guarantee cacheline alignment of driver-private data
dmaengine: bcm2835: Allow reusable descriptors
dmaengine: bcm2835: Allow cyclic transactions without interrupt
spi: bcm2835: Drop dma_pending flag
spi: bcm2835: Work around DONE bit erratum
spi-gpio: Use PTR_ERR_OR_ZERO() in spi_gpio_request()
spi: Use an abbreviated pointer to ctlr->cur_msg in __spi_pump_messages
spi: npcm-fiu: remove set but not used variable 'retlen'
spi: fsl-spi: use devm_platform_ioremap_resource() to simplify code
spi: zynq-qspi: use devm_platform_ioremap_resource() to simplify code
spi: zynqmp: use devm_platform_ioremap_resource() to simplify code
spi: xlp: use devm_platform_ioremap_resource() to simplify code
...

show more ...

Merge branch 'next' into for-linus

Prepare input updates for 5.4 merge window.

Merge branch 'spi-5.4' into spi-next

Merge branch 'for-next' into for-linus

Signed-off-by: Takashi Iwai <tiwai@suse.de>

Merge remote-tracking branch 'remotes/powerpc/topic/ppc-kvm' into kvm-ppc-next

This merges in fixes for the XIVE interrupt controller which touch both
generic powerpc and PPC KVM code. To avoid mer

Merge remote-tracking branch 'remotes/powerpc/topic/ppc-kvm' into kvm-ppc-next

This merges in fixes for the XIVE interrupt controller which touch both
generic powerpc and PPC KVM code. To avoid merge conflicts, these
commits will go upstream via the powerpc tree as well as the KVM tree.

Signed-off-by: Paul Mackerras <paulus@ozlabs.org>

show more ...

Merge branch 'ti-sysc-fixes' into fixes

Merge tag 'efi-urgent' of git://git.kernel.org/pub/scm/linux/kernel/git/efi/efi into efi/urgent

Pull a single EFI fix for v5.3 from Ard:

- Fix mixed mode breakage in EFI config table handling for

Merge tag 'efi-urgent' of git://git.kernel.org/pub/scm/linux/kernel/git/efi/efi into efi/urgent

Pull a single EFI fix for v5.3 from Ard:

- Fix mixed mode breakage in EFI config table handling for TPM.

show more ...

Merge tag 'v5.3-rc4' into next

Sync up with mainline to bring in device_property_count_u32 andother
newer APIs.

Merge tag 'v5.3-rc3' into drm-next-5.4

Linux 5.3-rc3

Signed-off-by: Alex Deucher <alexander.deucher@amd.com>

spi: Remove dev_err() usage after platform_get_irq()

We don't need dev_err() messages when platform_get_irq() fails now that
platform_get_irq() prints an error message itself when something goes
wro

spi: Remove dev_err() usage after platform_get_irq()

We don't need dev_err() messages when platform_get_irq() fails now that
platform_get_irq() prints an error message itself when something goes
wrong. Let's remove these prints with a simple semantic patch.

// <smpl>
@@
expression ret;
struct platform_device *E;
@@

ret =
(
platform_get_irq(E, ...)
|
platform_get_irq_byname(E, ...)
);

if ( \( ret < 0 \| ret <= 0 \) )
{
(
-if (ret != -EPROBE_DEFER)
-{ ...
-dev_err(...);
-... }
|
...
-dev_err(...);
)
...
}
// </smpl>

While we're here, remove braces on if statements that only have one
statement (manually).

Cc: Mark Brown <broonie@kernel.org>
Cc: linux-spi@vger.kernel.org
Cc: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Signed-off-by: Stephen Boyd <swboyd@chromium.org>
Link: https://lore.kernel.org/r/20190730181557.90391-42-swboyd@chromium.org
Signed-off-by: Mark Brown <broonie@kernel.org>

show more ...

Merge drm/drm-next into drm-intel-next-queued

Catching up with 5.3-rc*

Signed-off-by: Rodrigo Vivi <rodrigo.vivi@intel.com>

Merge branch master from git://git.kernel.org/pub/scm/linux/kernel/git/torvalds/linux.git

Pick up the spectre documentation so the Grand Schemozzle can be added.

Merge tag 'v5.3-rc1' into regulator-5.3

Linus 5.3-rc1