| /openbmc/linux/Documentation/devicetree/bindings/memory-controllers/ |
| H A D | ti-aemif.txt | 84 - ti,cs-select-strobe-mode: enable/disable select strobe mode
85 In select strobe mode chip select behaves as
86 the strobe and is active only during the strobe
92 device wants to extend the strobe period. If
104 and the activation of read strobe.
107 - ti,cs-read-strobe-ns: read strobe width, ns
109 the read strobe.
114 strobe and the end of the cycle (which may be
121 and the activation of write strobe.
124 - ti,cs-write-strobe-ns: write strobe width, ns
[all …]
|
| /openbmc/linux/Documentation/userspace-api/media/v4l/ |
| H A D | ext-ctrls-flash.rst | 23 Unsynchronised LED flash (software strobe)
34 Synchronised LED flash (hardware strobe)
38 timeout) but controlled by the sensor through a strobe signal from the
84 Defines the source of the flash LED strobe.
93 - The flash strobe is triggered by using the
96 - The flash strobe is triggered by an external source. Typically
98 flash strobe start to exposure start.
110 Stop flash strobe immediately.
117 Hardware timeout for flash. The flash strobe is stopped after this
118 period of time has passed from the start of the strobe.
[all …]
|
| /openbmc/linux/Documentation/ABI/testing/ |
| H A D | sysfs-class-led-flash | 6 Set the brightness of this LED in the flash strobe mode, in
18 Maximum brightness level for this LED in the flash strobe mode,
26 Hardware timeout for flash, in microseconds. The flash strobe
28 of the strobe. The file is created only for the flash LED
43 Flash strobe state. When written with 1 it triggers flash strobe
62 the flash strobe was still on when
|
| H A D | sysfs-bus-intel_th-devices-pti | 12 Description: (RW) 0: PTI trace clock acts as a strobe which only toggles
|
| /openbmc/linux/drivers/bus/ |
| H A D | ts-nbus.c | 33 struct gpio_desc *strobe; member
64 ts_nbus->strobe = devm_gpiod_get(&pdev->dev, "ts,strobe", GPIOD_OUT_HIGH); in ts_nbus_init_pdata()
65 if (IS_ERR(ts_nbus->strobe)) { in ts_nbus_init_pdata()
67 return PTR_ERR(ts_nbus->strobe); in ts_nbus_init_pdata()
117 gpiod_set_value_cansleep(ts_nbus->strobe, 0); in ts_nbus_reset_bus()
126 gpiod_set_value_cansleep(ts_nbus->strobe, 1); in ts_nbus_start_transaction()
|
| /openbmc/linux/drivers/input/joystick/ |
| H A D | grip.c | 72 int strobe = gameport_time(gameport, GRIP_STROBE_GPP); in grip_gpp_read_packet() local
75 t = strobe; in grip_gpp_read_packet()
87 t = strobe; in grip_gpp_read_packet()
113 int strobe = gameport_time(gameport, GRIP_STROBE_XT); in grip_xt_read_packet() local
117 t = strobe; in grip_xt_read_packet()
131 t = strobe; in grip_xt_read_packet()
144 t = strobe; in grip_xt_read_packet()
|
| H A D | cobra.c | 45 int strobe = gameport_time(gameport, COBRA_MAX_STROBE); in cobra_read_packet() local
63 t[i] = strobe; in cobra_read_packet()
|
| H A D | sidewinder.c | 119 int timeout, bitout, sched, i, kick, start, strobe; in sw_read_packet() local
126 strobe = gameport_time(gameport, SW_STROBE); in sw_read_packet()
143 bitout = strobe; /* Extend time if not timed out */ in sw_read_packet()
158 bitout = strobe; /* Extend timeout for next bit */ in sw_read_packet()
|
| /openbmc/linux/drivers/media/usb/au0828/ |
| H A D | au0828-i2c.c | 122 int i, strobe = 0; in i2c_sendbytes() local
177 strobe++; in i2c_sendbytes()
180 if ((strobe >= 4) || (i >= msg->len)) { in i2c_sendbytes()
192 strobe = 0; in i2c_sendbytes()
|
| /openbmc/linux/Documentation/devicetree/bindings/phy/ |
| H A D | rockchip-emmc-phy.txt | 19 - rockchip,enable-strobe-pulldown: Enable internal pull-down for the strobe
|
| /openbmc/linux/Documentation/devicetree/bindings/bus/ |
| H A D | ts-nbus.txt | 14 - ts,strobe-gpios : The GPIO pin connected to the stobe line on the FPGA
41 ts,strobe-gpios = <&gpio0 25 GPIO_ACTIVE_HIGH>;
|
| /openbmc/linux/Documentation/leds/ |
| H A D | leds-class-flash.rst | 49 defines the source of the flash LED strobe -
52 strobe start with exposure start,
74 determines whether the flash strobe source
|
| /openbmc/linux/drivers/mmc/host/ |
| H A D | dw_mmc-exynos.c | 249 u32 dqs, strobe; in dw_mci_exynos_config_hs400() local
264 strobe = priv->saved_strobe_ctrl; in dw_mci_exynos_config_hs400()
268 strobe = DQS_CTRL_RD_DELAY(strobe, priv->dqs_delay); in dw_mci_exynos_config_hs400()
276 mci_writel(host, HS400_DLINE_CTRL, strobe); in dw_mci_exynos_config_hs400()
|
| /openbmc/u-boot/arch/arm/dts/ |
| H A D | keystone-k2l-evm.dts | 57 ti,cs-read-strobe-ns = <23>;
60 ti,cs-write-strobe-ns = <23>;
|
| H A D | keystone-k2e-evm.dts | 80 ti,cs-read-strobe-ns = <23>;
83 ti,cs-write-strobe-ns = <23>;
|
| H A D | keystone-k2hk-evm.dts | 101 ti,cs-read-strobe-ns = <23>;
104 ti,cs-write-strobe-ns = <23>;
|
| /openbmc/linux/include/linux/platform_data/ |
| H A D | keyscan-davinci.h | 23 u8 strobe; member
|
| /openbmc/linux/arch/arm/boot/dts/ti/keystone/ |
| H A D | keystone-k2l-evm.dts | 71 ti,cs-read-strobe-ns = <23>;
74 ti,cs-write-strobe-ns = <23>;
|
| H A D | keystone-k2e-evm.dts | 98 ti,cs-read-strobe-ns = <23>;
101 ti,cs-write-strobe-ns = <23>;
|
| H A D | keystone-k2hk-evm.dts | 115 ti,cs-read-strobe-ns = <23>;
118 ti,cs-write-strobe-ns = <23>;
|
| /openbmc/linux/arch/arm64/boot/dts/rockchip/ |
| H A D | rk3588-edgeble-neu6a.dtsi | 29 mmc-hs400-enhanced-strobe;
|
| H A D | rk3588s-khadas-edge2.dts | 29 mmc-hs400-enhanced-strobe;
|
| /openbmc/linux/drivers/leds/flash/ |
| H A D | Kconfig | 62 and strobe mode.
70 Support 2 channels and torch/strobe mode.
|
| /openbmc/linux/include/media/ |
| H A D | v4l2-mediabus.h | 117 unsigned char strobe:1; member
|
| /openbmc/u-boot/doc/device-tree-bindings/gpio/ |
| H A D | mscc_sgpio.txt | 5 strobe pin. By attaching a number of (external) shift registers, the
|