Searched refs:mA (Results 1 – 14 of 14) sorted by relevance
443 int (*vbus_draw) (struct usb_gadget *, unsigned mA);665 static inline int usb_gadget_vbus_draw(struct usb_gadget *gadget, unsigned mA) in usb_gadget_vbus_draw() argument669 return gadget->ops->vbus_draw(gadget, mA); in usb_gadget_vbus_draw()
117 int "Maximum VBUS Power usage (2-500 mA)"127 milliAmperes. The permitted range of values is 2 - 500 mA;128 0 mA would be legal, but can make some hosts misbehave.
1089 static int pxa25x_udc_vbus_draw(struct usb_gadget *_gadget, unsigned mA) in pxa25x_udc_vbus_draw() argument
912 drive-strength = <4>; /* default: 3.5mA */916 drive-strength = <5>; /* 5mA */921 drive-strength = <4>; /* default: 3.5mA */925 drive-strength = <11>; /* 11mA */
633 drive-strength = <4>; /* default: 4mA */637 drive-strength = <8>; /* 8mA */
208 * high-speed mode on pcm-947 board so bump up to 12 mA.
312 * measurement after shutdown: it should be less than 1 mA.)
147 * [7:6] Right-bar GPIO output strength is 8mA
97 /* Based on 5v 500mA AFB02505HHB */
625 /* [7:6] Right-bar GPIO output strength is 8mA */
186 drive-strength - sink or source at most X mA230 - drive-strength takes as argument the target strength in mA.
1736 static int musb_gadget_vbus_draw(struct usb_gadget *gadget, unsigned mA) in musb_gadget_vbus_draw() argument1743 return usb_phy_set_power(musb->xceiv, mA); in musb_gadget_vbus_draw()
130 the 5V 500mA power supplied by the controller will not be sufficient to run
977 …w5yahtub324YDlf+X2dcu8CoxD27Ga3weIkfsuxcnjSV/Zk6ZjZH7MFBLS17sbYX2JmMe+RY7r+mA/iQpjZxlH2NEqcmv0ELmU…1105 …w5yahtub324YDlf+X2dcu8CoxD27Ga3weIkfsuxcnjSV/Zk6ZjZH7MFBLS17sbYX2JmMe+RY7r+mA/iQpjZxlH2NEqcmv0ELmU…