Searched refs:TxConfig (Results 1 – 5 of 5) sorted by relevance
| /openbmc/qemu/hw/net/ |
| H A D | rtl8139.c | 110 TxConfig = 0x40, enumerator
450 uint32_t TxConfig; member
1244 s->TxConfig = 0; in rtl8139_reset()
1250 s->TxConfig |= HW_REVID(1, 1, 1, 0, 1, 1, 0); // RTL-8139C+ HasLWake in rtl8139_reset()
1699 val = SET_MASKED(val, TxVersionMask | 0x8070f80f, s->TxConfig); in rtl8139_TxConfig_write()
1701 s->TxConfig = val; in rtl8139_TxConfig_write()
1708 uint32_t tc = s->TxConfig; in rtl8139_TxConfig_writeb()
1716 uint32_t ret = s->TxConfig; in rtl8139_TxConfig_read()
1771 if (TxLoopBack == (s->TxConfig & TxLoopBack)) in rtl8139_transfer_frame()
2684 case TxConfig: /* windows driver sometimes writes using byte-lenth call */ in rtl8139_io_writeb()
[all …]
|
| /openbmc/u-boot/drivers/net/ |
| H A D | rtl8139.c | 109 TxConfig=0x40, RxConfig=0x44, enumerator
369 outl((TX_DMA_BURST<<8)|0x03000000, ioaddr + TxConfig); in rtl_reset()
|
| H A D | rtl8169.c | 123 TxConfig = 0x40, enumerator
404 tmp = RTL_R32(TxConfig); in rtl8169_init_board()
417 printf("PCI device: TxConfig = 0x%lX\n", (unsigned long) RTL_R32(TxConfig)); in rtl8169_init_board()
756 RTL_W32(TxConfig, (TX_DMA_BURST << TxDMAShift) | in rtl8169_hw_start()
|
| H A D | ns8382x.c | 76 TxConfig = 0x28, enumerator
564 OUTL(dev, tx_config, TxConfig); in ns8382x_init()
717 OUTL(dev, tx_config, TxConfig); in ns8382x_check_duplex()
|
| H A D | natsemi.c | 81 TxConfig = 0x24, enumerator
583 OUTL(dev, tx_config, TxConfig); in natsemi_init()
746 OUTL(dev, tx_config, TxConfig); in natsemi_check_duplex()
|